Analysis on frequency response of trans-impedance amplifier (TIA) for signal-to-noise ratio (SNR) enhancement in optical signal detection system using lock-in amplifier (LIA)
In order to detect the weak signal deeply buried in the noise, a weak signal detection system based on lock-in amplifier is proposed. The system includes the preamplifier circuit, active low pass filter circuit, AC amplifying circuit and phase sensitive demodulation circuit. Test results show that it can greatly increase the signal-to-noise ratio (SNR) up to 12.7db.
An indigenised lock-in amplifier is designed that enables the accurate measurement of signals contaminated by broad-band noise, power-line pick-up, frequency drift, or other sources of interference. It does this by means of an extremely narrow band detector which has the centre of its passband locked to the frequency of the signal to be measured. Large improvements in signal-to-noise ratio are achieved.
A linear adaptive algorithm was developed for array beamforming purposes. The design goal for the algorithm is to minimize the squared filter output subject to filter constraints which allow energy propagating from the array steering direction to pass without being distorted. The adaptive filter coefficients were initialized to satisfy the constraints which were preserved during the iterations. The adaptation rate is inversely varied with filter output and total input channel power. Performance of the algorithm was studied using the recorded short‐period array data from the Korean Seismic Research Station. Processed were a high‐amplitude signal from Kamchatka, a medium‐amplitude signal from eastern Kazakh, and a number of low‐amplitude signals from central Eurasia. Results of signal‐to‐noise ratio gain relative to a conventional beamformer among the events tested were consistent and were in the range of 4.5 to 6.5 dB in the wide passband. Much better signal‐to‐noise ratio improvement was obtained in the low‐frequency passband. The adaptive algorithm was programmed in the real‐time mode and can be implemented in a front‐end detection system.
Integrated in-band optical signal-to-noise ratio monitor implemented on SOI platform