The polymer nanocomposites embedded particles size and agglomeration effect on the effective refractive index tuning

2021 ◽  
Author(s):  
Sipan N. Liu ◽  
Md Didarul Islam ◽  
Zahyun Ku ◽  
Augustine M. Urbas ◽  
Darryl A. Boyd ◽  
...  
Keyword(s):  
Refractive Index ◽  
Polymer Nanocomposites ◽  
Effective Refractive Index ◽  
Agglomeration Effect ◽  
Embedded Particles

Stress Whitening in Polypropylene. I. Light Scattering Theory and Model Experiments

1995 ◽  
Vol 60 (11) ◽  
pp. 1875-1887 ◽  
Author(s):  
Jaroslav Holoubek ◽  
Miroslav Raab
Keyword(s):  
Refractive Index ◽  
Light Scattering ◽  
Incident Light ◽  
Polymeric Materials ◽  
Wavelength Dependence ◽  
Theoretical Background ◽  
Surrounding Matrix ◽  
Embedded Particles ◽  
The One ◽  
Stress Whitening

Theoretical background for an optical method is presented which makes it possible to distinguish unambiguously between voids and particles as light scattering sites in polymeric materials. Typical dependences of turbidity as a function of diameter of scattering elements, their volume fractions and also turbidity curves as a function of the wavelength of the incident light were calculated, based both on the Lorenz-Mie theory and the fluctuation theory. Such dependences calculated for polypropylene-containing voids on the one hand and particles, differing only slightly from the surrounding matrix in their refractive index, on the other hand, are markedly different. The most significant results are: (i) Turbidity is at least by two orders of magnitude larger for voids in comparison to embedded particles of ethylene-propylene (EPDM) rubber of the same size, concentration and at the same wavelength. (ii) The wavelength dependence of turbidity for EPDM particles and the inherent refractive index fluctuations in the polypropylene matrix is much steeper as compared to voids for all considered diameters (0.1-10 μm). Thus, the nature of stress whitening in complex polymeric materials can be determined from turbidity measurements.

scholarly journals NONLINEAR OPTICAL WAVEGUIDE STRUCTURE FOR SENSOR APPLICATION: TM CASE

2007 ◽  
Vol 21 (30) ◽  
pp. 5075-5089 ◽  
Author(s):  
HALA M. KHALIL ◽  
MOHAMMED M. SHABAT ◽  
SOFYAN A. TAYA ◽  
MAZEN M. ABADLA
Keyword(s):  
Refractive Index ◽  
Theoretical Analysis ◽  
Closed Form ◽  
Optical Waveguide ◽  
Effective Refractive Index ◽  
Nonlinear Optical ◽  
Waveguide Structure ◽  
Analytical Expressions ◽  
Evanescent Waveguide ◽  
Waveguide Sensor

In this work, we present an extensive theoretical analysis of nonlinear optical waveguide sensor. The waveguide under consideration consists of a thin dielectrica film surrounded by a self-focused nonlinear cladding and a linear substrate. The nonlinearity of the cladding is considered to be of Kerr-type. Both cases, when the effective refractive index is greater and when it is smaller than the index of the guiding layer, are discussed. The sensitivity of the effective refractive index to any change in the cladding index in evanescent optical waveguide sensor is derived for TM modes. Closed form analytical expressions and normalized charts are given to provide the conditions required for the sensor to exhibit its maximum sensitivity. The results are compared with those of the well-known linear evanescent waveguide sensors.

scholarly journals Titania Photonic Crystals with Precise Photonic Band Gap Position via Anodizing with Voltage versus Optical Path Length Modulation

Nanomaterials ◽  
2019 ◽  
Vol 9 (4) ◽  
pp. 651 ◽  
Author(s):  
Ermolaev ◽  
Kushnir ◽  
Sapoletova ◽  
Napolskii
Keyword(s):  
Refractive Index ◽  
Photonic Crystals ◽  
Band Gap ◽  
Titanium Oxide ◽  
Effective Refractive Index ◽  
Photonic Band Gap ◽  
Voltage Versus ◽  
Research Attention ◽  
Anodic Titanium Oxide ◽  
Photonic Band

Photonic crystals based on titanium oxide are promising for optoelectronic applications, for example as components of solar cells and photodetectors. These materials attract great research attention because of the high refractive index of TiO2. One of the promising routes to prepare photonic crystals based on titanium oxide is titanium anodizing at periodically changing voltage or current. However, precise control of the photonic band gap position in anodic titania films is a challenge. To solve this problem, systematic data on the effective refractive index of the porous anodic titanium oxide are required. In this research, we determine quantitatively the dependence of the effective refractive index of porous anodic titanium oxide on the anodizing regime and develop a model which allows one to predict and, therefore, control photonic band gap position in the visible spectrum range with an accuracy better than 98.5%. The prospects of anodic titania photonic crystals implementation as refractive index sensors are demonstrated.

scholarly journals Modes Effective Refractive Index Difference Measurement in Few-mode Optical Fiber

2016 ◽  
Vol 140 ◽  
pp. 77-84 ◽  
Author(s):  
Jing Zhang ◽  
Zhifang Wu ◽  
Tianye Huang ◽  
Xuguang Shao ◽  
Ping Shum
Keyword(s):  
Refractive Index ◽  
Optical Fiber ◽  
Effective Refractive Index ◽  
Difference Measurement ◽  
Refractive Index Difference
Sign in / Sign up

Export Citation Format

Share Document