Determination of percentage depth-dose curves for electron beams using different types of detectors

2001 ◽  
Vol 28 (3) ◽  
pp. 298-302 ◽  
Author(s):  
G. X. Ding ◽  
C. W. Yu
Keyword(s):  
Electron Beams ◽  
Percentage Depth Dose ◽  
Depth Dose ◽  
Different Types

scholarly journals Applications and benefits of using gradient percentage depth dose instead of percentage depth dose for electron and photon beams in radiotherapy

2021 ◽  
Vol 27 (1) ◽  
pp. 25-29
Author(s):  
Labinot Kastrati ◽  
Gezim Hodolli ◽  
Sehad Kadiri ◽  
Elvin Demirel ◽  
Lutfi Istrefi ◽  
...  
Keyword(s):  
Electron Beams ◽  
Published Data ◽  
Photon Beams ◽  
Data Set ◽  
Percentage Depth Dose ◽  
Depth Dose ◽  
Electron And Photon

Abstract Introduction: The aim of this study is to analyze the gradient of percentage depth dose for photon and electron beams of LINACs and to simplify the data set. Materials and Methods: Dosimetry measurements were performed in accordance with Technical Reports Series No. 398 IAEA. Results and discussion: The gradient of percentage depth dose was calculated and compared with the available published data. Conclusion: Instead of percentage depth dose for increasing and decreasing parts, the findings suggest using only two numbers for specific gradient of dose, separately. In this way, they can replace the whole set of the percentage depth dose (PDD).

An evaluation of the recommendations of the TG-25 protocol for determination of depth dose curves for electron beams using ionization chambers

1995 ◽  
Vol 22 (8) ◽  
pp. 1333-1337 ◽  
Author(s):  
M. Saiful Huq ◽  
A. G. Agostinelli ◽  
Ravinder Nath
Keyword(s):  
Electron Beams ◽  
Ionization Chambers ◽  
Depth Dose

scholarly journals Verification of percentage depth dose of MAGICA polymer gel dosimeter with electron beams

2009 ◽  
Vol 164 ◽  
pp. 012037
Author(s):  
K Adinehvand ◽  
M R Aghamiri ◽  
M H Zahmatkesh ◽  
S H Akhlaghpor
Keyword(s):  
Electron Beams ◽  
Polymer Gel ◽  
Gel Dosimeter ◽  
Percentage Depth Dose ◽  
Depth Dose ◽  
Polymer Gel Dosimeter

Characterization of Different Types of Biomass Wastes Using Thermogravimetric and ICP-MS Analyses

2020 ◽  
Vol 70 (12) ◽  
pp. 4594-4600
Keyword(s):  
Thermogravimetric Analysis ◽  
Food Industry ◽  
Wood Waste ◽  
Biomass Ash ◽  
Minor Elements ◽  
Ms Analysis ◽  
Icp Ms ◽  
Different Types

The purpose of this study was to characterize some types of biomass wastes resulted from different activities such as: agriculture, forestry and food industry using thermogravimetric and ICP-MS analyses. Also, it was optimized an ICP-MS method for the determination of As, Cd and Pb from biomass ash samples. The ICP-MS analysis revealed that the highest concentration of metals (As, Cd, Pb) was recorded in the wood waste ash sample, also the thermogravimetric analysis indicated that the highest amount of ash was obtained for the same sample (26.82%). The biomass wastes mentioned in this study are alternative recyclable materials, reusable as pellets and briquettes. Keywords: ash, biomass, ICP-MS, minor elements, TG

Studies on the Behavior Some Paints in Electro-insulating Fluid Based on Vegetable Esters

2018 ◽  
Vol 69 (5) ◽  
pp. 1139-1144
Author(s):  
Iosif Lingvay ◽  
Adriana Mariana Bors ◽  
Livia Carmen Ungureanu ◽  
Valerica Stanoi ◽  
Traian Rus
Keyword(s):  
Structural Changes ◽  
Oxidation Processes ◽  
High Oleic ◽  
Painting Materials ◽  
Insulating Paper ◽  
Different Types ◽  
Mechanism And Kinetics ◽  
Kinetics Of ◽  
Natural Ester

For the purpose of using three different types of painting materials for the inner protection of the transformer vats, their behavior was studied under actual conditions of operation in the transformer (thermal stress in electro-insulating fluid based on the natural ester in contact with copper for electro-technical use and electro-insulating paper). By comparing determination of the content in furans products (HPLC technique) and gases formed (by gas-chromatography) in the electro-insulating fluid (natural ester with high oleic content) thermally aged at 130 �C to 1000 hours in closed glass vessels, it have been found that the presence the investigated painting materials lead to a change in the mechanism and kinetics of the thermo-oxidation processes. These changes are supported by oxygen dissolved in oil, what leads to decrease both to gases formation CO2, CO, H2, CH4, C2H4 and C2H6) and furans products (5-HMF, 2-FOL, 2 -FAL and 2-ACF). The painting materials investigated during the heat treatment applied did not suffer any remarkable structural changes affecting their functionality in the electro-insulating fluid based on vegetable esters.

Sign in / Sign up

Export Citation Format

Share Document