Relations between the apparent source width (ASW) of the sound field in a concert hall and its sound pressure level at low frequencies (GL), and its inter‐aural cross correlation coefficient (IACC)

1994 ◽  
Vol 96 (5) ◽  
pp. 3268-3268 ◽  
Author(s):  
Toshiyuki Okano ◽  
Takayuki Hidaka ◽  
Leo L. Beranek
Keyword(s):  
Correlation Coefficient ◽  
Sound Pressure Level ◽  
Cross Correlation ◽  
Sound Pressure ◽  
Sound Field ◽  
Pressure Level ◽  
Concert Hall ◽  
Low Frequencies ◽  
Apparent Source

Interaction between Strong Sound Waves and Cloud Droplets: Theoretical Analysis

2021 ◽  
Author(s):  
Ying-Hui Jia ◽  
Fang-Fang Li ◽  
Kun Fang ◽  
Guang-Qian Wang ◽  
Jun Qiu
Keyword(s):  
Sound Wave ◽  
Sound Pressure Level ◽  
Sound Pressure ◽  
Sound Field ◽  
Pressure Level ◽  
Velocity Variation ◽  
Time Range ◽  
Sound Waves ◽  
Cloud Droplets ◽  
Acoustic Frequency

AbstractRecently strong sound wave was proposed to enhance precipitation. The theoretical basis of this proposal has not been effectively studied either experimentally or theoretically. Based on the microscopic parameters of atmospheric cloud physics, this paper solved the complex nonlinear differential equation to show the movement characteristics of cloud droplets under the action of sound waves. The motion process of individual cloud droplet in a cloud layer in the acoustic field is discussed as well as the relative motion between two cloud droplets. The effects of different particle sizes and sound field characteristics on particle motion and collision are studied to analyze the dynamic effects of thunder-level sound waves on cloud droplets. The amplitude of velocity variation has positive correlation with Sound Pressure Level (SPL) and negative correlation with the frequency of the surrounding sound field. Under the action of low-frequency sound waves with sufficient intensity, individual cloud droplets could be forced to oscillate significantly. The droplet smaller than 40μm can be easily driven by sound waves of 50 Hz and 123.4 dB. The calculation of the collision process of two droplets reveals that the disorder of motion for polydisperse droplets is intensified, resulting in the broadening of the collision time range and spatial range. When the acoustic frequency is less than 100Hz (@ 123.4dB) or the Sound Pressure Level (SPL) is greater than 117.4dB (@ 50Hz), the sound wave can affect the collision of cloud droplets significantly. This study provides theoretical perspective of acoustic effect to the microphysics of atmospheric clouds.

Investigation of turbulence-induced quadrupole source acoustic characteristics of a three-dimensional hydrofoil

2020 ◽  
Vol 34 (14) ◽  
pp. 2050145
Author(s):  
Rennian Li ◽  
Wenna Liang ◽  
Wei Han ◽  
Hui Quan ◽  
Rong Guo ◽  
...  
Keyword(s):  
Vortex Shedding ◽  
Sound Pressure Level ◽  
Sound Pressure ◽  
Three Dimensional ◽  
Sound Field ◽  
Leading Edge ◽  
Pressure Level ◽  
Acoustic Characteristics ◽  
Eddy Simulation ◽  
Unsteady Fluid

In order to investigate the turbulence-induced acoustic characteristics of hydrofoils, the flow and sound field for a model NH-15-18-1 asymmetric hydrofoil were calculated based on the mixed method of large eddy simulation (LES) with Lighthill analogy theory. Unsteady fluid turbulent stress source around the hydrofoil were selected as the inducements of quadrupole sound. The average velocity along the mainstream direction was calculated for different Reynolds numbers [Formula: see text]. Compared to experimental measurements, good agreement was seen over a range of [Formula: see text]. The results showed that the larger the [Formula: see text], the larger the vortex intensity, the shorter the vortex initial shedding position to the leading edge of the hydrofoil, and the higher the vortex shedding frequency [Formula: see text]. The maximum sound pressure level (SPL) of the hydrofoil was located at the trailing edge and wake of the hydrofoil, which coincided with the velocity curl [Formula: see text] distribution of the flow field. The maximum SPL of the sound field was consistent with the location of the vortex shedding. There were quadratic positive correlations between the total sound pressure level (TSPL) and the maximum value of the vortex intensity [Formula: see text] and velocity curl, which verified that shedding and diffusion of vortices are the fundamental cause of the generation of the quadrupole source noise.

scholarly journals Evaluation and Improvement of the Sound Quality of a Diesel Engine Based on Tests and Simulations

Energies ◽  
2020 ◽  
Vol 13 (4) ◽  
pp. 777 ◽  
Author(s):  
Zhengwei Yang ◽  
Huihua Feng ◽  
Bingjie Ma ◽  
Ammar Abdualrahim Alnor Khalifa
Keyword(s):  
Diesel Engine ◽  
Sound Pressure Level ◽  
Sound Pressure ◽  
Subjective Evaluation ◽  
Sound Field ◽  
Sound Quality ◽  
Pressure Level ◽  
Sound Power ◽  
Improvement Strategy ◽  
Radiated Sound

Traditional acoustic evaluation of a diesel engine generally uses the A-weighted sound pressure level (AWSPL) and radiated sound power to assess the noise of an engine prototype present in an experiment. However, this cannot accurately and comprehensively reflect the auditory senses of human subjects during the simulation stage. To overcome such shortage, the Moore–Glasberg loudness and sharpness approach is applied to evaluate and improve the sound quality (SQ) of a 16 V-type marine diesel engine, and synthesizing noise audio files. Through finite element (FE) simulations, the modes of the engine’s block and the average vibrational velocity of the entire engine surface were calculated and compared with the test results. By further applying an automatically matched layer (AML) approach, the engine-radiated sound pressure level (SPL) and sound power contributions of all engine parts were obtained. By analyzing the Moore–Glasberg loudness and sharpness characteristics of three critical sound field points, an improvement strategy of the oil sump was then proposed. After improvement, both the loudness and sharpness decreased significantly. To verify the objective SQ evaluation results, ten noise audio clips of the diesel engine were then synthesized and tested. The subjective evaluation results were in accordance with the simulated analysis. Therefore, the proposed approach to analyze and improve the SQ of a diesel engine is reliable and effective.

Active Control of Structural Sound Radiation in an Acoustic Enclosure Using Distributed Point Force Actuators

2014 ◽  
Vol 1082 ◽  
pp. 517-520
Author(s):  
Da Lin Chen ◽  
Nan Chen
Keyword(s):  
Active Control ◽  
Sound Pressure Level ◽  
Cooperative Control ◽  
Sound Pressure ◽  
Control Method ◽  
Sound Radiation ◽  
Sound Field ◽  
Pressure Level ◽  
Point Force ◽  
Flexible Plates

This paper demonstrates an investigation about the active control of sound radiation in the enclosure cavity consists of two flexible plates. One of the flexible plates is driven by a point force to generate the primary sound field in the cavity, and using some point forces which are located at different locations on the receiving plate to suppressing the panel vibration and then to minimum the cavity sound pressure level (SPL); meanwhile some actuators are located on the other panel surfaces to reduce the sound pressure level at some frequencies that can’t be well reduced by only effect on one panel. The better result shows the possibility of applying distributed cooperative control method to the structural-acoustic coupled system.

The Acoustic Test Report of Three Outdoor Courtyard in Shenyang Palace Museum

2014 ◽  
Vol 507 ◽  
pp. 131-137 ◽  
Author(s):  
Shen Chen ◽  
Dong Xu Zhang ◽  
Xin Xin Pan ◽  
Yang Cong
Keyword(s):  
Sound Pressure Level ◽  
Scientific Community ◽  
Sound Pressure ◽  
Sound Field ◽  
Pressure Level ◽  
Future Research ◽  
Reverberation Time ◽  
Test Report ◽  
Traditional Architecture ◽  
Solid Foundation

Scientific community is still lacking of research in sound field characteristics of the Chinese traditional architecture courtyard currently, the author chose three outdoor courtyards sound field in Shenyang Palace Museum as the research object, and firstly used the sound cutting method to do system testing of the important acoustic indicators reverberation time T10 in the Palace courtyard, then placed a dodecahedron sound player as a continuous sound source in the courtyard, test the sound pressure level on the adjacent courtyard, the purpose is to analyze the sound privacy degree of the inner courtyard of the Palace. The results may help to understand the sound field characteristics of the palace courtyard, and lay a solid foundation for the future research.

Prediction and analysis of sound field in long enclosures with a modal-based method

2021 ◽  
Vol 69 (6) ◽  
pp. 518-529
Author(s):  
Changyong Jiang ◽  
Xiang Liu ◽  
Stephany Y. Xu ◽  
Shangyu Zhang
Keyword(s):  
Porous Material ◽  
Point Source ◽  
Sound Pressure Level ◽  
High Frequency ◽  
Sound Pressure ◽  
Prediction Method ◽  
Sound Field ◽  
Pressure Level ◽  
Noise Levels ◽  
Level Reduction

In this paper, the efficacy of porous ceiling treatment to reduce noise levels inside a typical tunnel is examined with a validated modal-based prediction method. It is found that, for a point source, the effect of increasing porous ceiling thickness on sound pressure level (SPL) attenuation along the tunnel is limited. A porous ceiling with thickness of 0.3 m is comparable with an infinite porous ceiling in middle and high frequency ranges. For a line source, the effect of ceiling thickness on SPL reduc- tion in this typical tunnel is limited. Sound pressure level reduction of 4 dBA is real- ized with 0.3 m porous ceiling, which is the same as infinite ceiling and only 1 dBA smaller than the theoretically optimized value. These results suggest that, in the event only ceiling treatment is considered, 0.3 m porous material is sufficient for noise re- duction in this typical tunnel.

Sign in / Sign up

Export Citation Format

Share Document