INFLUENCES OF MELT COMPOSITION AND HEAT-LOSS RATE ON THE GROWTH OF ALKALI-FELDSPAR MEGACRYSTS IN FELSIC INTRUSIONS

2016 ◽  
Author(s):  
William H. Hirt ◽  
2015 ◽  
Vol 21 ◽  
pp. 601-608 ◽  
Author(s):  
Jaakko Vihola ◽  
Jaakko Sorri ◽  
Juhani Heljo ◽  
Paavo Kero

Author(s):  
Chaolei Zhang ◽  
Yongsheng Lian ◽  
Michael Kempiak ◽  
Erik Hitzelberger ◽  
Scott Crane

An integrated experimental and numerical investigation was carried out to gain insight into the heat transfer phenomena and flow characteristics inside a domestic refrigerator. A refrigerator model was constructed using insulation foam sheets according to the inner dimensions of a household refrigerator. A reversal heat leak analysis was conducted on the constructed model in a temperature-controlled chamber, where the chamber temperature was lower than the inner temperature of the refrigerator. A temperature-controlled heater was mounted where the evaporator was. The heater was enclosed in a heater box to heat the air and to maintain a high temperature in the refrigerator. A variable speed fan was used to force air circulation. Thermocouples were used to measure the temperature at specified positions and to measure the average temperature difference across the refrigerator side walls. The correlation between the status of the heater and the control temperature variation pattern was analyzed. Heat loss rate was calculated using the data from the thermocouples too. The calculated heat loss rate closely matched the generated heat by the heater and the fan. Moreover, according to the results with different input voltages, the variation trend of the heat flux density was analyzed. A conjugate heat transfer analysis was conducted based on the constructed model using Fluent. The heater was modeled as a heat volume source and the fan was modeled using a pressure jump condition based on the experiment result. Comparisons were made between the experimental and numerical results. The predicted heat loss rate and the heat flux density through the walls matched very well with the experimental results. And the variation trend of the heat flux density with different input voltages also showed the same trend as the experimental result. And the airflow pattern and the temperature distribution were also analyzed in detail.


2018 ◽  
Vol 48 (11) ◽  
pp. 2627-2647 ◽  
Author(s):  
Xiaodong Wu ◽  
Douglas Cahl ◽  
George Voulgaris

AbstractThe formation of coastal dense shelf water in winter provides the available potential energy (APE) to fuel baroclinic instability. The combined effects of baroclinic instability and wind forcing in driving cross-shelf exchange are investigated using idealized numerical simulations with varied bottom slope, wind stress, and heat loss rate. The results show that under upwelling-favorable winds, the intensity of the instability decreases as the wind stress increases. This is caused primarily by enhanced turbulence frictional dissipation. Under downwelling-favorable winds, an increase in wind stress and/or a decrease in heat loss rate tends to constrain the baroclinic instability, leading to a circulation resembling that driven purely by wind forcing. In the latter case, once a critical value of cross-shore density gradient is reached, isopycnal slumping is initiated, leading to increased vertical stratification and narrowing of the inner shelf. The change in depth of the inner-shelf outer boundary, defined as the location corresponding to the maximum cross-shore gradient of the surface Ekman transport, is proportional to an empirically derived multiparametric quantity , where a2 is a dimensional constant, B0 is a constant heat loss rate, γ = 0.43, f is the Coriolis parameter, α is the shelf slope, B is the heat loss rate, and τ is the wind stress. This relationship is found to hold for cases when instabilities are present.


2019 ◽  
Vol 36 (01) ◽  
pp. 55-61
Author(s):  
Jun Hwa Kwon ◽  
Jun Gu Kang ◽  
Young Hyun Kwon ◽  
Ha Nyoung Yoo ◽  
Young Jae Ko ◽  
...  

1983 ◽  
Vol 54 (5) ◽  
pp. 1361-1367 ◽  
Author(s):  
R. P. Layton ◽  
W. H. Mints ◽  
J. F. Annis ◽  
M. J. Rack ◽  
P. Webb

Regional and total body heat loss rates of human subjects at rest were measured simultaneously by means of an array of heat flux transducers and with a tube suit calorimeter. Conditions ranged from thermal comfort to strong cooling. A high degree of correlation was found between heat loss rates determined by the two independent techniques. For the head and arms, the transducer array system measured less heat loss than the suit. For the torso and legs, measurements by the two methods were equivalent. For the whole body, the transducer system yielded a heat loss rate 87% of the suit calorimeter value.


Sign in / Sign up

Export Citation Format

Share Document