CONTINENTAL SHELF FRESHWATER WATER RESOURCES AND IMPROVED OIL RECOVERY BY LOW-SALINITY WATER FLOODIN

2016 ◽  
Author(s):  
Mark Person ◽  
◽  
John L. Wilson ◽  
Norman Morrow ◽  
Vincent E.A. Post
AAPG Bulletin ◽  
2017 ◽  
Vol 101 (01) ◽  
pp. 1-18 ◽  
Author(s):  
Mark Person ◽  
John L. Wilson ◽  
Norman Morrow ◽  
Vincent E.A. Post

SPE Journal ◽  
2019 ◽  
Vol 24 (06) ◽  
pp. 2859-2873 ◽  
Author(s):  
Pedram Mahzari ◽  
Mehran Sohrabi ◽  
Juliana M. Façanha

Summary Efficiency of low–salinity–water injection primarily depends on oil/brine/rock interactions. Microdispersion formation (as the dominant interfacial interaction between oil and low–salinity water) is one of the mechanisms proposed for the reported additional oil recovery by low–salinity–water injection. Using similar rock and brines, here in this work, different crude–oil samples were selected to examine the relationship between crude–oil potency to form microdispersions and improved oil recovery (IOR) by low–salinity–water injection in sandstone cores. First, the potential of the crude–oil samples to form microdispersions was measured; next, coreflood tests were performed to evaluate the performance of low–salinity–water injection in tertiary mode. Sandstone core plugs taken from a whole reservoir core were used for the experiments. The tests started with spontaneous imbibition followed by forced imbibition of high–salinity brine. Low–salinity brine was then injected in tertiary mode. The oil–recovery profiles and compositions of the produced brine were measured to investigate the IOR benefits as well as the geochemical interactions. The results demonstrate that the ratio of the microdispersion quantity to bond water is the main factor controlling the effectiveness of low–salinity–water injection. In general, a monotonic trend was observed between incremental oil recovery and the microdispersion ratio of the different crude–oil samples. In addition, it can be inferred from the results that geochemical interactions (pH and ionic interactions) would be mainly controlled by the rock's initial wettability, and also that these processes could not affect the additional oil recovery by low-salinity-water injection. To further verify the observations of geochemical interactions, a novel experiment was designed and performed on a quartz substrate to investigate the ionic interactions on the film of water between an oil droplet and a flat quartz substrate, when the high–salinity brine was replaced with the low–salinity brine. The results of the flat–substrate test indicated that the water film beneath the oil could not interact with the surrounding brine, which is in line with the results of the core tests.


2014 ◽  
Vol 17 (01) ◽  
pp. 49-59 ◽  
Author(s):  
Ramez A. Nasralla ◽  
Hisham A. Nasr-El-Din

Summary Literature review shows that improved oil recovery (IOR) by low-salinity waterflooding could be attributed to several mechanisms, such as sweep-efficiency improvement, interfacial-tension (IFT) reduction, multicomponent ionic exchange, and electrical-double-layer (EDL) expansion. Although these mechanisms might contribute to IOR by low-salinity water, they may not be the primary mechanism. Therefore, the main objective of this study is to investigate if the mechanism of EDL expansion could be the principal reason for IOR during low-salinity waterflooding. Low-salinity water results in a thicker EDL when compared to high-salinity water, so we tried to eliminate the effect of low-salinity brines on double-layer expansion to show to what extent IOR is related to EDL expansion caused by low-salinity water. The double-layer expansion is dependent on the electric surface charge, which is a function of the pH of brine; therefore, the pH levels of low-salinity brines were decreased in this study to provide low-salinity brines that can produce a thinner EDL, similar to high-salinity brines. ζ-potential measurements were performed on both rock/brine and oil/brine interfaces to demonstrate the effect of brine pH and salinity on EDL. Contact angle and coreflood experiments were conducted to test different brine salinities at different pH values, which could assess the effect of water salinity and pH on rock wettability and oil recovery, and hence involvement of EDL expansion in the IOR process. ζ-potential results in this study showed that decreasing the pH of low-salinity brines makes the electrical charges at both oil/brine and brine/rock interfaces slightly negative, which reduces the double-layer expansion caused by low-salinity brine. As a result, the rock becomes more oil-wet, which was confirmed by contact-angle measurements. Moreover, coreflood experiments indicated that injecting low-salinity brine at lower pH values recovered smaller amounts of oil when compared to the original pH because of the elimination of the low-salinity-water effect on the thickness of the double layer. In conclusion, this study demonstrates that expansion of the double layer is a dominant mechanism of oil-recovery improvement by low-salinity waterflooding.


2015 ◽  
Author(s):  
M. Sohrabi ◽  
P. Mahzari ◽  
S. A. Farzaneh ◽  
J. R. Mills ◽  
P. Tsolis ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document