Slave River delta: geomorphology, sedimentology, and Holocene reconstruction

1988 ◽  
Vol 25 (12) ◽  
pp. 1990-2004 ◽  
Author(s):  
Sandy Vanderburgh ◽  
Derald G. Smith

The Holocene Slave River delta (8300 km2) is a long (170 km), narrow (42 km average width) alluvial sand body, which extends north from the Slave River rapids at Fort Smith to Great Slave Lake, Northwest Territories. The delta is flanked by the Talston and Tethul rivers and Canadian Shield to the east and by the Little Buffalo River to the west. Wave-associated sedimentary structures in lithostratigraphic logs from river cutbanks indicate that the sandy delta was wave influenced. Most of the logs (34) consist of three facies: basal laminated mud (unknown thickness), interbedded mud and sand (2.5 m), and planar-tabular ripple sets interbedded with cross-laminated to flat-bedded sand (3.0–14.5 m).Eleven radiocarbon-dated wood samples from river cutbanks were used to reconstruct the delta paleoshoreface and to calculate the rate of progradation, which averaged 20.7 m/year from 8070 BP to the present. In the same period isostatic rebound of the delta region relative to the Liard River delta averaged 12 cm/km (a total rebound of 48 m). The data were calculated normal to the retreating Laurentide ice front.From the surface to depths of 59 m, the subaerial and subaqueous delta front exhibits barrier islands, lagoons, offshore bars or sand waves, tensional cracks, slumps and pressure ridges. The barriers and offshore bars consist of medium grain-sized sand, whereas the slumps and pressure ridges are interpreted as mud.

1983 ◽  
Vol 20 (4) ◽  
pp. 603-616 ◽  
Author(s):  
J. L. Luternauer ◽  
W. D. Liam Finn

The distributary front deposits of the delta consist mainly of interlayered sand and silt and lie in one of the most seismically active zones in Canada. Subsurface deposits at the north tend to be siltier than those at the south. Sediments on the surface of the delta slope range from clayey silts at the north to pure sands at the south. Slope angles vary from 23° at the head of the slope to 1–2° within 2 km beyond the tidal flats.Hydraulic bedforms observed on the sandy slopes southeast of the main channel gradually increase in size from small ripples to large asymmetric sand waves 2–3 m high and approximately 30 m long. They are generated primarily by flood tidal currents which scour the seabed to a water depth in excess of 100 m.Formation of gullies which crease the delta slope probably is initiated principally by failure of oversteepened deposits at a channel mouth. Previous studies have suggested that the large hummocks or ridges at the base of the slope off the Main Channel have been formed by the compressional folding of failed deposits. Recent reflection seismic surveys suggest that such a process has recurred in this area during the growth of the delta.Interpretation of SPT data, in the light of recent research findings, suggests that previous analyses have overestimated failure potential. It is estimated that the slope may withstand an earthquake with a duration corresponding to approximately 15 significant cycles of motion and a peak acceleration in the range of 11–13% G. Keywords: stability, Fraser River Delta front, mass wasting, erosion, liquefaction potential, cyclic mobility.


2006 ◽  
Vol 20 (19) ◽  
pp. 4051-4072 ◽  
Author(s):  
J. T. Gardner ◽  
M. C. English ◽  
T. D. Prowse

Sedimentology ◽  
2021 ◽  
Author(s):  
Lina Jin ◽  
Xin Shan ◽  
Xuefa Shi ◽  
Marco Fonnesu ◽  
Shuqing Qiao ◽  
...  

2002 ◽  
Vol 39 (4) ◽  
pp. 505-518 ◽  
Author(s):  
Caroline Lavoie ◽  
Michel Allard ◽  
Philip R Hill

Eastern Hudson Bay is characterized by falling relative sea level as a result of post-glacial isostatic rebound, which makes the region a natural laboratory for rapid forced regression, where the evolution of deltaic systems and offshore sedimentation patterns can be studied. A multidisciplinary approach involving airphoto analysis, offshore geophysical surveys, sediment coring, and facies and diatom analyses was used in this study of the Nastapoka River delta. The delta has formed as a result of the fluvial erosion of emerged Quaternary sediments but is mainly subaqueous. Offshore, in the prodelta zone, the oldest deposits are glaciomarine, laid down when the ice front of the receding Laurentide ice sheet stood on the Nastapoka hills some 7700–6800 years BP. Lateral equivalents of this glaciomarine unit are presently exposed on land. The shallow-water platform of the delta shows a thin surficial unit of wave-worked sand that overlies fine-grained, deeper water deposits derived from erosion of clay soils in the river catchment a few centuries ago, probably during periods of intense thermokarst activity. As the isostatic uplift continues, the deltaic platform will gradually emerge and be incised by the river channel.


2009 ◽  
Vol 46 (12) ◽  
pp. 1406-1417 ◽  
Author(s):  
Guohui Xu ◽  
Yongfu Sun ◽  
Xin Wang ◽  
Guanghai Hu ◽  
Yupeng Song

Slope instability processes occur widely on the underwater slopes of the Yellow River delta during storms. Roughly circular depressions on the upper delta front in water depths of 4 to 8 m have been detected by acoustic surveying and their processes were observed in the laboratory. This paper analyzes the properties of geomorphic and acoustic profiles of the upper delta front and compares the engineering geologic properties of samples from the disturbed and undisturbed areas. The results indicate that the weak superficial mass could oscillate with waves and the oscillation weakened the surrounding soil under the cyclic loading. The stratum was disturbed or even destroyed with depth, the area of the slide mass enlarged gradually, and finally a collapse depression formed.


2019 ◽  
Vol 23 (2) ◽  
pp. 119-126 ◽  
Author(s):  
Qingshao Liang ◽  
Jingchun Tian ◽  
Feng Wang ◽  
Xiang Zhang

Soft-sediment deformation (SSD) structures of the Upper Triassic Yanchang Formation are laterally widespread in the Ordos Basin. In the Huachi-Qingyang (H-Q) area of the Ordos Basin, the Chang6 oil member of the Upper Triassic Yanchang Formation is among the most significant Mesozoic oil-bearing strata. It is characterized by the development of reservoir sand bodies. During the depositional evolution of the Chang6 oil member, SSD structures induced by paleo-seismic events developed in the H-Q area in the middle of the basin. The SSD structures developed in the sand bodies of the Chang6 oil member are mainly ball-and-pillow structures, fold structures, sand dikes, irregular convolute stratifications and synsedimentary faults. The architecture of the sand bodies resulted from paleo-seismic events and gravity slumping and mainly include two types of structures: 1) SSD structures driven by paleo-seismic events with normal sedimentation (delta front sand body) (SN-SSD) and 2) SSD structures driven by paleo-seismic events with turbidites (formed by delta-front slumping and re-distribution due to seismic action) (ST-SSD). As a consequence, genetic models of the sand bodies formed by different sedimentation processes are established.


2014 ◽  
Vol 608-609 ◽  
pp. 1141-1146
Author(s):  
Zheng Shi ◽  
Long Wei Qiu ◽  
Yong Qiang Yang

Zhunzhong area Qingshui River group has top and bottom boundaries,which are not clear,and research on the evolution of the lack in sequence stratigraphic framework of deposition and on the reservoir sand body types do not have a clear understanding problem.In seismic interpretation, core description and based on the analysis of the related test,combining with the mud logging and well logging data,for the redefinition of Qingshui River group on the top and bottom boundaries,it identifies 6 time significance of sequence boundary,taking Qingshui River group can be divided into 2 sequences, 5 system tracts;clear and definite the study area mainly developed delta lacustrine depositional system,which can be further divided into the delta front subfacies, beach bar facies and semi deep lake subfacies. It takes an analysis on the sedimentary characteristics and distribution rules of different types, and it controls effect of topography and hydrodynamic conditions on deposition system, and then puts forward the corresponding sedimentary patterns.


Sign in / Sign up

Export Citation Format

Share Document