Selective conversion of aldehydes to carboxylic acids by hemoglobin and air

2018 ◽  
Vol 22 (08) ◽  
pp. 679-685 ◽  
Author(s):  
Mahdi Hajimohammadi ◽  
Maryam Khalaji Verjani ◽  
Hoda Ghasemi ◽  
Nasser Safari ◽  
Günther Knör

A new green, environmentally friendly and economically feasible method for the oxygenation of benzaldehyde, cinnamaldehyde, 4-chlorobenzaldehyde and 4-bromobenzaldehyde to the corresponding carboxylic acids using air in the presence of hemoglobin as a water-soluble catalyst in aqueous media at room temperature is illustrated. The resulting products were obtained with (77–100%) conversion and 100% selectivity within a reasonable amount of time. In addition, the first direct characterization of a high-valent iron intermediate (HbFe[Formula: see text]O) measured using Mass Spectroscopy (MS) and UV-vis spectroscopy proved that the major route for oxidation of aldehydes is (HbFe[Formula: see text]O) production.

2022 ◽  
Author(s):  
Jose Luis Serrano ◽  
Sujeet Gaware ◽  
Jose Antonio Pérez de Haro ◽  
Jose Pérez ◽  
Pedro Lozano ◽  
...  

Commercially available Quadrol, N,N,N',N'-tetrakis(2-hydroxypropyl)ethylenediamine (THPEN), has been used for the first time as N^N- donor neutral hydrophilic ligand in the synthesis and characterization of new water soluble palladium (II) complexes...


2012 ◽  
Vol 531 ◽  
pp. 219-222
Author(s):  
Li Hua Shen ◽  
Ting Shang ◽  
Jun Zhou ◽  
Dong Wang ◽  
Yu Han ◽  
...  

Extremely small-sized superparamagnetic magnetite nanoparticles of 3Cit). The resulting Cit-coated magnetite nanoparticles exhibited long-term colloidal stability in aqueous media without any surface modification. Regarding the magnetic properties, the nanoparticles were superparamagnetic at room temperature, and might be the potential candidate for MRI contrast agents.


2021 ◽  
Vol 21 (10) ◽  
pp. 8067-8088
Author(s):  
Vincent Michoud ◽  
Elise Hallemans ◽  
Laura Chiappini ◽  
Eva Leoz-Garziandia ◽  
Aurélie Colomb ◽  
...  

Abstract. The characterization of the molecular composition of organic carbon in both gaseous and aerosol is key to understanding the processes involved in the formation and aging of secondary organic aerosol. Therefore a technique using active sampling on cartridges and filters and derivatization followed by analysis using a thermal desorption–gas chromatography–mass spectrometer (TD–GC–MS) has been used. It is aimed at studying the molecular composition of organic carbon in both gaseous and aerosol phases (PM2.5) during an intensive field campaign which took place in Corsica (France) during the summer of 2013: the ChArMEx (Chemistry and Aerosol Mediterranean Experiment) SOP1b (Special Observation Period 1B) campaign. These measurements led to the identification of 51 oxygenated (carbonyl and or hydroxyl) compounds in the gaseous phase with concentrations between 21 and 3900 ng m−3 and of 85 compounds in the particulate phase with concentrations between 0.3 and 277 ng m−3. Comparisons of these measurements with collocated data using other techniques have been conducted, showing fair agreement in general for most species except for glyoxal in the gas phase and malonic, tartaric, malic and succinic acids in the particle phase, with disagreements that can reach up to a factor of 8 and 20 on average, respectively, for the latter two acids. Comparison between the sum of all compounds identified by TD–GC–MS in the particle phase and the total organic matter (OM) mass reveals that on average 18 % of the total OM mass can be explained by the compounds measured by TD–GC–MS. This number increases to 24 % of the total water-soluble OM (WSOM) measured by coupling the Particle Into Liquid Sampler (PILS)-TOC (total organic carbon) if we consider only the sum of the soluble compounds measured by TD–GC–MS. This highlights the important fraction of the OM mass identified by these measurements but also the relative important fraction of OM mass remaining unidentified during the campaign and therefore the complexity of characterizing exhaustively the organic aerosol (OA) molecular chemical composition. The fraction of OM measured by TD–GC–MS is largely dominated by di-carboxylic acids, which represent 49 % of the PM2.5 content detected and quantified by this technique. Other contributions to PM2.5 composition measured by TD–GC–MS are then represented by tri-carboxylic acids (15 %), alcohols (13 %), aldehydes (10 %), di-hydroxy-carboxylic acids (5 %), monocarboxylic acids and ketones (3 % each), and hydroxyl-carboxylic acids (2 %). These results highlight the importance of polyfunctionalized carboxylic acids for OM, while the chemical processes responsible for their formation in both phases remain uncertain. While not measured by the TD–GC–MS technique, humic-like substances (HULISs) represent the most abundant identified species in the aerosol, contributing for 59 % of the total OM mass on average during the campaign. A total of 14 compounds were detected and quantified in both phases, allowing the calculation of experimental partitioning coefficients for these species. The comparison of these experimental partitioning coefficients with theoretical ones, estimated by three different models, reveals large discrepancies varying from 2 to 7 orders of magnitude. These results suggest that the supposed instantaneous equilibrium being established between gaseous and particulate phases assuming a homogeneous non-viscous particle phase is questionable.


2018 ◽  
Vol 73 (9) ◽  
pp. 641-645 ◽  
Author(s):  
Sepehr Sadegh-Samiei ◽  
Shahrzad Abdolmohammadi

AbstractA novel and efficient synthesis of eight 5-aryl-1,3-dimethyl-2,4-dioxo-1,2,3,4,5,8-hexahydropyrido[2,3-d]pyrimidine-7-carboxylic acids using a TiO2/SiO2 nanocomposite with a molar ratio of 1:1 as a recyclable heterogeneous catalyst is described. The desired products, five of which are new, are formed in short reaction times (2–3 h) with high to excellent yields (94%–98%) under very moderate reaction conditions (room temperature, aqueous media).


2016 ◽  
Vol 52 (88) ◽  
pp. 12960-12963 ◽  
Author(s):  
Andrea Monas ◽  
Krunoslav Užarević ◽  
Ivan Halasz ◽  
Marina Juribašić Kulcsár ◽  
Manda Ćurić

Room-temperature accelerated aging in the solid state has been applied for quantitative azobenzene C–H bond activation by Pd(OAc)2. Water-soluble dicyclopalladated methyl orange is a selective chromogenic biothiol sensor at physiologically-relevant micromolar concentrations in aqueous media.


2013 ◽  
Vol 690-693 ◽  
pp. 573-576
Author(s):  
Qi Feng Liu

A novel gadolinium triple-decker sandwich-type complex containing tetrabenzoporphyrin (TBP) ligands-Gd (TBP)3was prepared from porphyrin 1 and Gd (acac)3.nH2O in boiling 1, 2, 4-Tcb for 45~48 h under Ar. Its structure is characterized by Uv-Vis spectroscopy and HR-MS. The spectroscopic properties show that its longest-wavelength visible band (600-800 nm) is obviously red-shifted due to the extension of the π conjugated systems derived from the linear benzoannulation in the TBP ring. The magnetic studies also indicate that there is no magnetic interactions between two Gd (III) ions in the triple-deckers in the range from room temperature down to 20K and very weak antiferromagnetic coupling exists between two Gd (III) ions below 20K.


2013 ◽  
Vol 17 (12) ◽  
pp. 1204-1208
Author(s):  
Majid Hashemi ◽  
Zahra Solati ◽  
Pegah Mohammadpour

Reaction of chloro(tetraphenylporphyrinato)manganese(III) with tetra-n-butylammonium hydrogen monopersulfate (n- Bu 4 NHSO 5) in the presence of high ratio of imidazole was followed by UV-Vis spectroscopy in CH 2 Cl 2 at room temperature. The variation in the UV-vis spectra shows that the reaction goes through Mn ( III ), high valent Mn ( V ) or Mn ( IV ), Mn ( III ), low valent Mn ( II ) and again Mn ( III ) complexes. The Mn ( III ) complex before the addition of n- Bu 4 NHSO 5 could not be reduced to Mn ( II ), but Mn ( III ) complex which was obtained after decay of high valent Mn complexes was reduced to Mn ( II ), probably because its spin state is different from the first one. Addition of methanol to the reaction mixture (in the presence or absence of ferrocene) shows that two high valent Mn complexes [( Mn V ( TPP )-( O )( X )] ( X = Im - or OMe -) and [ Mn IV ( TPP )( OMe )2] are involved in the course of the reaction. Using meta-choloroperbenzoic acid instead of (n- Bu 4 NHSO 5) as oxidant showed that reduction of Mn ( III ) to Mn ( II ) is taking place only in the presence of HSO 4.


2021 ◽  
Author(s):  
Govindaraju K ◽  
K. Vijai Anand ◽  
S. Muthamilselvan ◽  
M. Kannan ◽  
M. Elanchezhiyan

Abstract In this study, a simple environmental benign approach have been adopted for the preparation of highly luminescent (blue emitting) water soluble carbon nano-dots using Pongammia pinnata (Pp) leaves via hydrothermal technique. The prepared Pp-carbon nano- dots were characterized using UV-vis spectroscopy, fluorescence spectroscopy, Fourier transform infrared (FT-IR) spectroscopy, transmission electron microscopy (TEM) and dynamic light scattering (DLS) measurements. The Pp-carbon nano-dots are spherical in shape with an average size of 32 nm.


2019 ◽  
Vol 20 (22) ◽  
pp. 5582 ◽  
Author(s):  
Ranjit De ◽  
Minhyuk Jung ◽  
Hohjai Lee

Polystyrene microparticles were covalently impregnated into the networks of functional polyelectrolyte chains designed via a tandem run of three reactions: (i) synthesis of water-soluble polyelectrolyte, (ii) fast azidation and (iii) a ‘click’ reaction, using the single-catalyst, single-pot strategy at room temperature in mild aqueous media. The model polyelectrolyte sodium polystyrenesulfonate (NaPSS) was synthesized via the well-controlled atom transfer radical polymerization (ATRP) whose halogen living-end was transformed to azide and subsequently coupled with an alkyne carboxylic acid through a ‘click’ reaction using the same ATRP catalyst, throughout. Halogen to azide transformation was fast and followed the radical pathway, which was explained through a plausible mechanism. Finally, the success of microparticle impregnation into the NaPSS network was evaluated through Kaiser assay and imaging. This versatile synthetic procedure, having a reduced number of discrete reaction steps and eliminated intermediate work-ups, has established a fast and simple pathway to design functional polymers required to fabricate stable polymer-particle composites where the particles are impregnated covalently and controllably.


2002 ◽  
Vol 337 (8) ◽  
pp. 711-717 ◽  
Author(s):  
Anna Jacobs ◽  
Jon Lundqvist ◽  
Henrik Stålbrand ◽  
Folke Tjerneld ◽  
Olof Dahlman

Sign in / Sign up

Export Citation Format

Share Document