This study was performed to investigate the bond strength between 4 dentin adhesives
and resin luting cements by means of μTBS test. The materials used in this study were four resin
cements (Choice, Panavia F, RelyX ARC, Bistite II DC), one 3-step adhesive (All-Bond2), one 2-
step self-etching adhesive (Clearfil SE-Bond) and two 1-step self-etching adhesives(Prompt L-Pop
and One-Up Bond F). Combination of 4 different dentin adhesives with 4 resin cements made up 16
experimental groups. Extracted human mandibular third molars without caries and restoratives were
stored in saline and used within 1 month of extraction. All adhesive systems and resin cements were
manipulated and applied to the dentin surfaces according to the manufactures’ instructions. The
resin composite “overlays” prepared with 6 mm thickness (Tescera, Bisco Inc., Schaumburg, IL,
USA) were luted with each resin cement. Each sample was measured μTBS.
1-step self-etching adhesives coupled with all resin luting cements used in this study resulted in
lower bond strength except of OU-PA group. When Choice, RelyX ARC and Bistite II were used,
Clearfil SE-Bond showed significantly higher μTBS values than 1-step self-etching adhesives
(p<0.05). Clearfil SE-Bond did not show significant μTBS values than All-Bond 2 that is
conventional 3-step dentin adhesive (p>0.05).