scholarly journals Gas Chromatography Mass Spectrometry Identification of Labile Radicals Formed during Pyrolysis of Catechool, Hydroquinone, and Phenol through Neutral Pyrolysis Product Mass Analysis

2013 ◽  
Vol 2013 ◽  
pp. 1-8 ◽  
Author(s):  
Julien Adounkpe ◽  
Martin Aina ◽  
Daouda Mama ◽  
Brice Sinsin

Catechol, hydroquinone, and phenol are known to be environmental pollutants due to their ability to generate environmentally free radicals, which cause millions of deaths worldwide. Recently, efforts have been done to precisely identify the origin and the nature of those free radicals employing EPR-LTMI technique. All the three precursors generate cyclopentadienyl radical as major pyrolysis products and phenoxyl radical as both pyrolysis and photolysis products which were obtained from phenol; ortho-semiquinone and para-semiquinone were seen, respectively, from the pyrolysis of catechol and hydroquinone. However, it has been suspected that the solely use of the EPR-LTMI did not allow the isolation of the more labile radicals that is supposedly terminated by radical-radical or radical-surface interaction. The present study reports the gas chromatography mass analysis of the pyrolysis products from catechol, hydroquinone, and phenol. Naphthalene , indene, and hydroxyindene were observed as the pyrolysis products of hydroquinone, while fluorene, 1H-indenol and its isomer 1H-inden-1-one 2,3 dihydro, acenaphthylene, benzofuran-7-methyl, and benzofuran-2-methyl were observed as pyrolysis products of catechol. Dibenzo dioxin and dibenzo furan were observed from pyrolysis of catechol and hydroquinone. Those products result from the combination of radicals such as cyclopentadienyl, para-semiquinone, ortho-semiquinone, hydroxyl-cyclohexadienyl, phenoxyl, and most importantly Hydroxycyclopentadienyl which was not identified by EPR-LTMI.

2021 ◽  
Vol 21 (7) ◽  
pp. 3971-3974
Author(s):  
Young-Kwon Park ◽  
Muhammad Zain Siddiqui ◽  
Sangjae Jeong ◽  
Eun-Suk Jang ◽  
Young-Min Kim

The effect of seawater aging on the thermal and catalytic pyrolysis of polypropylene (PP) was investigated using a thermogravimetric analyzer and pyrolyzer-gas chromatography/mass spectrometry. Although the surface properties of PP were of the oxidized form by seawater aging, the decomposition temperature and non-catalytic pyrolysis products of PP were relatively unchanged largely due to seawater aging. The catalytic pyrolysis of seawater-aged PP over all the catalysts produced smaller amounts of aromatic hydrocarbons than that of fresh PP due to catalyst poisoning caused by the residual inorganics. Among the catalysts, microporous HZSM-5 (SiO2/Al2O3:23) produced the largest amount of aromatic hydrocarbons followed in order by microporous HY(30) and nanoporous Al-MCM-41(20) from seawater-aged PP due to the high acidity and appropriate pore size for the generation of aromatic hydrocarbons.


1982 ◽  
Vol 16 (12) ◽  
pp. 883-886 ◽  
Author(s):  
Herman R. Van Langenhove ◽  
Fredy A. Van Wassenhove ◽  
Jos K. Coppin ◽  
Marc R. Van Acker ◽  
Niceas M. Schamp

Holzforschung ◽  
2014 ◽  
Vol 68 (5) ◽  
pp. 505-517 ◽  
Author(s):  
Maree Brennan ◽  
J. Paul McLean ◽  
Andreas Klingberg ◽  
Clemens Altaner ◽  
Philip J. Harris

Abstract The potential of pyrolysis followed by gas-chromatography and mass-spectrometry (Py-GC/MS) was investigated for identifying compression wood (CW) in saplings of radiata pine (Pinus radiata) by examining samples of CW and opposite wood (OW). Phenolic compounds and anhydrosugars were identified among the pyrolysis products that provided information about the cell-wall polymers. Sample preparation, such as coarse-milling, fine-milling, and fine-milling followed by calcium-chloride treatment was also investigated. Fine-milling typically decreased the total yield of phenolic compounds compared with coarse-milling. Fine-milling followed by calcium-chloride washing significantly increased the proportions of pyrolysis products from polysaccharides, specifically from (1→4)-β-D-galactans that were of interest in distinguishing CW from OW. Six pyrolysis products were identified that were unique to the CW samples examined, including derivatives of (1→4)-β-D-galactans and H-units of lignin. Other pyrolysis products were identified that had significantly different proportions between the two wood types, and sometimes among samples of the same wood type.


Sign in / Sign up

Export Citation Format

Share Document