Comparisons of particle size distribution from conventional and advanced compression ignition combustion strategies

2017 ◽  
Vol 19 (7) ◽  
pp. 699-717 ◽  
Author(s):  
Yizhou Zhang ◽  
Jaal Ghandhi ◽  
David Rothamer
Keyword(s):  
Particle Size ◽  
Natural Gas ◽  
Size Distribution ◽  
Homogeneous Charge Compression Ignition ◽  
Compression Ignition ◽  
Reactivity Controlled Compression Ignition ◽  
Advanced Combustion ◽  
Particulate Size ◽  
Early Injection ◽  
Homogeneous Charge

Particulate size distribution measurements are of importance in engine research as stricter regulations on particulate matter emissions (both mass and number based) are being implemented. Particulate size distribution measurements can be very sensitive to the laboratory environment or experimental setup, making it difficult to compare results for different combustion strategies acquired in different labs. In this study, a comparison of particulate size distribution measurements over a wide variety of conventional and advanced combustion strategies was conducted using a four-stroke single-cylinder diesel engine test setup to eliminate lab-to-lab variations and enable direct comparison of particulate size distribution results for different combustion strategies. Eight combustion strategies are included in the comparison: conventional diesel combustion, diesel/gasoline reactivity controlled compression ignition, homogeneous charge compression ignition, two types of gasoline compression ignition (early injection and late injection), diesel low temperature combustion, natural gas combustion with diesel pilot injection, and diesel/natural gas reactivity controlled compression ignition. Measurements were performed at four different load-speed points with matched combustion phasing when possible; for several strategies, it was necessary to operate with slightly different combustion phasing. Particle size distributions were measured using a scanning mobility particle sizer. To study the influence of volatile particles, measurements were performed with and without a volatile particle remover (thermodenuder) at low and high dilution ratios. The results show that non-uniformity in the fuel distribution caused by direct injection results in increased accumulation-mode particle concentrations compared to premixed strategies even for low particulate mass advanced combustion strategies. Premixed combustion strategies (homogeneous charge compression ignition) and early injection gasoline compression ignition show higher nuclei-mode particle concentrations. Overall particle number and mass concentrations vary significantly between engine operating conditions and between combustion strategies.

Decreasing hydrocarbon and carbon monoxide emissions of a natural-gas engine operating in the quasi-homogeneous charge compression ignition mode at low loads

2005 ◽  
Vol 219 (9) ◽  
pp. 1125-1131 ◽  
Author(s):  
Su Ling ◽  
Zhou Longbao ◽  
Liu Shenghua ◽  
Zhong Hui
Keyword(s):  
Carbon Monoxide ◽  
Natural Gas ◽  
Thermal Efficiency ◽  
Homogeneous Charge Compression Ignition ◽  
Compression Ignition ◽  
Brake Thermal Efficiency ◽  
Pilot Fuel ◽  
Cng Engine ◽  
Standard Mode ◽  
Homogeneous Charge

Experimental studies have been carried out on decreasing the hydrocarbon (HC) and carbon monoxide (CO) emissions of a compressed natural-gas (CNG) engine operating in quasi-homogeneous charge compression ignition (QHCCI) mode at low loads. The effects of three technical approaches including partial gas cut-off (PGC), intake air throttling, and increasing the pilot fuel quantity on emissions and the brake thermal efficiency of the CNG engine are studied. The results show that HC and CO emissions can be reduced with only a small penalty on the brake thermal efficiency. An increase in the brake thermal efficiency and reductions in HC and CO emissions can be simultaneously realized by increasing the pilot fuel quantity. It is also indicated from experiments that the HC and CO emissions of the engine can be effectively reduced when using intake air throttling and increasing the pilot fuel quantity are both adopted. However, nitrogen oxide (NOx) emissions increase with increase in the throttling and the pilot fuel quantity. Under PGC conditions, NOx emissions are lower than those in the standard mode; however, they increase and exceed the values in the standard mode in increases in the load and natural-gas supply.

Operating Characteristics of Natural Gas Fueled Homogeneous Charge Compression Ignition Engine

1999 ◽  
Author(s):  
Y. Kawabata ◽  
K. Nakagawa ◽  
F. Shoji
Keyword(s):  
Natural Gas ◽  
Homogeneous Charge Compression Ignition ◽  
Nox Emission ◽  
Compression Ignition ◽  
Operating Characteristics ◽  
Compression Ignition Engine ◽  
Gas Engine ◽  
Engine Combustion ◽  
Gas Fueled ◽  
Homogeneous Charge

Abstract Recently, a new design of engine combustion that achieves higher efficiency and less NOx emission has been proposed. Some researchers have started studying the concept, which is called Homogeneous Charge Compression Ignition (HCCI), but there have been few reports on investigations using a future prospective alternative fuel, natural gas. In this study, natural gas fueled operation of HCCI using a single cylinder gas engine was conducted. Operating and exhaust characteristics were obtained. Experimental data confirmed the potential of higher efficiency and less NOx emission, though THC and CO were higher. Based on these data, the feasibility of this concept for gas engines is also examined.

Sign in / Sign up

Export Citation Format

Share Document