scholarly journals Direct analysis of volatile components from intact jujube by carbon fiber ionization mass spectrometry

BMC Chemistry ◽  
2019 ◽  
Vol 13 (1) ◽  
Author(s):  
Shihao Sun ◽  
Yihan Zhang ◽  
Peng Li ◽  
Hui Xi ◽  
Lei Wu ◽  
...  

Abstract In situ analysis of odor is an important approach to connect odor with chemical composition. However, it is difficult to conduct a rapid direct analysis of the odor sample because of low analyte concentration and sampling. To achieve the direct analysis, a carbon fiber ionization mass spectrometry (CFI-MS) method has been developed and applied to measure volatile components releasing from intact jujube. To build the CFI source, a 2.0-cm long carbon fiber bundle was integrated on the pin of a commercial corona discharge needle by mean of a 1.3-cm long stainless hollow tube. Odor sample driven by N2 gas can be directly introduced to the carbon fiber bundle to complete the ionization of analytes. Acetic acid, ethyl acetate, ethyl caproate, octyl acetate, and damascone present in jujube were selected to evaluate the performance of the CFI-MS method on quantitative analysis of the gaseous sample. Good lineary was obtained (R2 ≥ 0.9946) between 5.0 and 500.0 ng/L with limits of detection (LOD) ranging from 0.5 to 1.5 ng/L. Recoveries of five volatile compounds for the spiked jujube samples were between 94.36 and 106.74% with relative standard deviations (RSDs) less than 7.27% (n = 5). Jujube of different varieties can be distinguished by principal components analysis based on the analytical results of volatile compounds. The developed method demonstrated obvious advantages such as simplicity, high throughput, good sensitivity and wide range of applicability, which will be an alternative way for in situ analysis of the odor sample.

2009 ◽  
Vol 2 (1) ◽  
pp. 119-151 ◽  
Author(s):  
J. P. Kercher ◽  
T. P. Riedel ◽  
J. A. Thornton

Abstract. We report a new method for the simultaneous in situ detection of nitryl chloride (ClNO2) and dinitrogen pentoxide (N2O5) using chemical ionization mass spectrometry (CIMS). The technique relies on the formation and detection of iodide ion-molecule clusters, I(ClNO2)− and I(N2O5)−. The novel N2O5 detection scheme is direct. It does not suffer from high and variable chemical interferences, which are associated with the typical method of nitrate anion detection. We address the role of water vapor, electric field strength, and instrument zero determinations, which influence the overall sensitivity and detection limit of this method. For both species, the method demonstrates high sensitivity (>1 Hz/pptv), precision (~10% for 100 pptv in 1 s), and accuracy (~20%), the latter ultimately determined by the nitrogen dioxide (NO2) cylinder calibration standard and characterization of inlet effects. For the typically low background signals (<10 Hz) and high selectivity, we estimate signal-to-noise (S/N) ratios of 2 for 1 pptv in 60 s averages, but uncertainty associated with the instrumental zero currently leads to an ultimate detection limit of ~5 pptv for both species. We validate our approach for the simultaneous in situ measurement of ClNO2 and N2O5 while on board the Research Vessel (RV) Knorr as part of the ICEALOT 2008 Field Campaign.


2021 ◽  
Author(s):  
Thais A. M. da Silva ◽  
Igor Pereira ◽  
Deborah V. A. de Aguiar ◽  
Gabriel F. dos Santos ◽  
Talita P. de Brito ◽  
...  

An NH2-surface-coated wooden-tip electrospray ionization mass spectrometry method was developed for naphthenic acid analysis in water samples.


Sign in / Sign up

Export Citation Format

Share Document