In developing a wave energy converter (WEC), assessing and rating the device is a difficult, but important issue. Conventionally, a large scaled device (maybe large enough for accommodating a power takeoff (PTO) system) or prototype device is needed to be tested in wave tanks or in seas in different wave conditions so that a power matrix for the device can be defined using scaling or interpolation/extrapolation methods. Alternatively, a pure numerical simulation in time-domain may be used for assessing the power capture capacities of wave energy devices. For the former, it is convincing, but can be especially difficult in the early stages of development, when small scaled models are normally used; and for the latter, the pure numerical simulation may not be very reliable and convincing, especially when the dynamic problem is very complicated. In this paper, a method for assessing the captured wave power for a device from its power capture response is presented. In the proposed method, a measured or calculated linear power capture response of the device is combined with wave spectrum to compute the average captured power function. Once the average captured power function is obtained, the overall average captured power corresponding to the wave state can be easily calculated. If a linear power capture response is obtained from a model test, the power assessment based on this proposed method can be very convincing and reliable. To illustrate the application of the proposed method, an example of a fully linear dynamic system, including the linear hydrodynamics of the floating structure and a linear power takeoff, is considered. For such a system, the frequency-domain analysis can be employed to obtain the performance of the floating device under waves and the power takeoff system. The hydrodynamic performance of the wave energy converter is then used to define the power capture response and to calculate the average captured power functions in different sea states. Then, the captured power of the device in different sea states, i.e, the power matrix, can be calculated, and accordingly, the device can be assessed and rated. To validate the proposed method, a time-domain analysis is also performed for a cross-check. In the time-domain analysis, the hydrodynamic coefficients and responses are first assessed in frequency-domain, and then transformed into the relevant terms by means of impulse response functions for establishing the time-domain (TD) equation. By comparing the results from frequency-domain and time-domain analyses of irregular waves, it can be concluded that the proposed wave energy capture assessment method can be used in assessing or rating the device.
Frequency- and time-domain analysis of a multi-degree-of-freedom point absorber wave energy converter
