1826 An experimental study on the characteristics of wing for a small vertical-axis wind turbine : The characteristics of a circular arc wing with finite span

2008 ◽  
Vol 2008.2 (0) ◽  
pp. 173-174
Author(s):  
Seiji YAMADA ◽  
Shinsuke MOCHIZUKI ◽  
Hironori YAMANE
Keyword(s):  
Experimental Study ◽  
Wind Turbine ◽  
Vertical Axis ◽  
Vertical Axis Wind Turbine ◽  
Circular Arc ◽  
Finite Span

scholarly journals An experimental study of the optimal design parameters of a wind power tower used to improve the performance of vertical axis wind turbines

2018 ◽  
Vol 10 (9) ◽  
pp. 168781401879954
Author(s):  
Soo-Yong Cho ◽  
Sang-Kyu Choi ◽  
Jin-Gyun Kim ◽  
Chong-Hyun Cho
Keyword(s):  
Experimental Study ◽  
Optimal Design ◽  
Wind Turbine ◽  
Wind Power ◽  
Wind Turbines ◽  
Vertical Axis ◽  
Power Coefficient ◽  
Design Parameters ◽  
Vertical Axis Wind Turbine ◽  
Vertical Axis Wind Turbines

In order to augment the performance of vertical axis wind turbines, wind power towers have been used because they increase the frontal area. Typically, the wind power tower is installed as a circular column around a vertical axis wind turbine because the vertical axis wind turbine should be operated in an omnidirectional wind. As a result, the performance of the vertical axis wind turbine depends on the design parameters of the wind power tower. An experimental study was conducted in a wind tunnel to investigate the optimal design parameters of the wind power tower. Three different sizes of guide walls were applied to test with various wind power tower design parameters. The tested vertical axis wind turbine consisted of three blades of the NACA0018 profile and its solidity was 0.5. In order to simulate the operation in omnidirectional winds, the wind power tower was fabricated to be rotated. The performance of the vertical axis wind turbine was severely varied depending on the azimuthal location of the wind power tower. Comparison of the performance of the vertical axis wind turbine was performed based on the power coefficient obtained by averaging for the one periodic azimuth angle. The optimal design parameters were estimated using the results obtained under equal experimental conditions. When the non-dimensional inner gap was 0.3, the performance of the vertical axis wind turbine was better than any other gaps.

scholarly journals Experimental investigation of a variable geometry vertical axis wind turbine

2020 ◽  
pp. 0309524X2093513
Author(s):  
Simon A Prince ◽  
Carmine Badalamenti ◽  
Dimitar Georgiev
Keyword(s):  
Experimental Study ◽  
Wind Turbine ◽  
Pitch Angle ◽  
Vertical Axis ◽  
Reynolds Numbers ◽  
Variable Geometry ◽  
Vertical Axis Wind Turbine ◽  
Wind Tunnel Experiments ◽  
Electrical Generator ◽  
Turbine Design

An experimental study is presented on the performance of a vertical axis wind turbine with variable blade geometry of the design developed by Austin Farrah. This is experimentally compared with the performance of a correspondingly sized Bach-type Savonius turbine using the same electrical generator and measurement instrumentation in a wind tunnel. Experiments were performed for Reynolds numbers, based on blade chord, in the range 5 × 103 to 1 × 105, and for blade settings between −40° and +40o. The study shows that for the tip speed ratios that have been investigated, the Farrah vertical axis wind turbine design can only marginally outperform a corresponding two-bladed Bach-type Savonius turbine and then only when its blades are set to 40° pitch angle. The presence of a small inner cylinder, which rotates with the turbine, does not enhance its performance due to the fact that it is immersed in an extensive column of relatively static air.

An Experimental Study of the Aerodynamics and Performance of a Vertical Axis Wind Turbine in a Confined and Unconfined Environment

2015 ◽  
Vol 137 (5) ◽  
Author(s):  
Vincenzo Dossena ◽  
Giacomo Persico ◽  
Berardo Paradiso ◽  
Lorenzo Battisti ◽  
Sergio Dell'Anna ◽  
...  
Keyword(s):  
Experimental Study ◽  
Wind Tunnel ◽  
Wind Turbine ◽  
Vertical Axis ◽  
Tip Vortex ◽  
Speed Ratio ◽  
Vertical Axis Wind Turbine ◽  
Tip Speed Ratio ◽  
And Performance ◽  
Power Curves

This paper presents the results of a wide experimental study on an H-type vertical axis wind turbine (VAWT) carried out at the Politecnico di Milano. The experiments were carried out in a large-scale wind tunnel, where wind turbines for microgeneration can be tested in real-scale conditions. Integral torque and thrust measurements were performed, as well as detailed aerodynamic measurements to characterize the flow field generated by the turbine downstream of the rotor. The machine was tested in both a confined (closed chamber) and unconfined (open chamber) environment, to highlight the effect of wind tunnel blockage on the aerodynamics and performance of the VAWT under investigation. The experimental results, compared with the blockage correlations presently available, suggest that specific correction models should be developed for VAWTs. The experimental thrust and power curves of the turbine, derived from integral measurements, exhibit the expected trends with a peak power coefficient of about 0.28 at tip-speed ratio equal to 2.5. Flow measurements, performed in three conditions for tip speed ratio equal to 1.5, 2.5, and 3.5, show the fully three-dimensional character of the wake, especially in the tip region where a nonsymmetrical wake and tip vortex are found. The unsteady evolution of the velocity and turbulence fields further highlights the effect of aerodynamic loading on the wake unsteadiness, showing the time-dependent nature of the tip vortex and the onset of dynamic stall for tip speed ratio lower than 2.

scholarly journals Experimental Study of Vertical Axis Wind Turbine Performance under Vibration

2021 ◽  
Vol 1 (2) ◽  
pp. 177-185
Author(s):  
Md Rasel Sarkar ◽  
Sabariah Julai ◽  
Mst Jesmin Nahar ◽  
Moslem Uddin ◽  
Mahmudur Rahman ◽  
...  
Keyword(s):  
Power Generation ◽  
Experimental Study ◽  
Wind Tunnel ◽  
Wind Turbine ◽  
Dynamic Characteristics ◽  
Vertical Axis ◽  
Vertical Axis Wind Turbine ◽  
Flow Uniformity ◽  
Aerodynamic Forces ◽  
Turbine Performance

An experimental study was conducted to study the effects of flow uniformity on vibration and power generation of a small vertical axis wind turbine (VAWT). Previous studies have confirmed that one of the sources of vibration in the turbine is due to aerodynamic forces, which are due to incident wind. Firstly, understanding vibration is essential before proceeding to the measurements. In this experiment, further understand the vibrations of the turbine in operation, the operating deflection shape (ODS) technique was used. A wind tunnel and flow conditioner were fabricated. Experimental modal analysis (EMA) was conducted, and the dynamic characteristics are gathered. The ODS was conducted for operating the turbine at different speeds, with and without the flow conditioner. Results from EMA and ODS are correlated to explain the behavior of structures. In conclusion, the flow conditioner tested did have a big impact on the response of the structure in terms of vibration up to 30% indifference, but not so much in power generated about 2% indifference.

scholarly journals Experimental Study on Efficiency of Floating Vertical Axis Wind Turbine with Variable-Pitch

2018 ◽  
Vol 32 (3) ◽  
pp. 202-207
Author(s):  
Jae-Heui Kim ◽  
Hyo-Jae Jo ◽  
Jae-Hyuk Hwang ◽  
Min-Suk Jang ◽  
Byeong-Seong Lee
Keyword(s):  
Experimental Study ◽  
Wind Turbine ◽  
Vertical Axis ◽  
Vertical Axis Wind Turbine ◽  
Variable Pitch

scholarly journals NUMERICAL AND EXPERIMENTAL STUDY OF A TWO-STAGE SAVONIUS WIND TURBINE

2019 ◽  
Vol 18 (2) ◽  
pp. 52
Author(s):  
L. B. Kothe ◽  
A. P. Petry
Keyword(s):  
Experimental Study ◽  
Numerical Simulations ◽  
Wind Turbine ◽  
Vertical Axis ◽  
Relative Difference ◽  
Performance Comparison ◽  
Speed Ratio ◽  
Vertical Axis Wind Turbine ◽  
Two Stage ◽  
Index Method

This article presents a numerical and experimental study of vertical axis wind turbine performance comparison involving a two-stage Savonius rotor with similar parameters. The experimental study is conducted in the aerodynamic tunnel at the Fluid Mechanics Laboratory of the Federal University of Rio Grande do Sul. The aerodynamics rotors are manufactured by 3D prototyping technique. Numerical simulations are performed using the Finite Volumes Method performed by the solution of the Reynolds Averaged Navier-Stokes (RANS) and continuity equations using the SST k-ω turbulence model. The numerical domain is modeled in order to maintain the same characteristics of the experimental model. The mesh quality is evaluated through the GCI (Grid Convergence Index) method. The static and dynamic torque coefficients and the power coefficients are compared. The tests are made without blockage corrections due to the small blockage ratio from 7.5%. Results show that the turbine has a positive static torque coefficient for any rotor angles. The dynamic torque reaches the maximum value for a tip speed ratio (λ) of 0.2 for the experimental and numerical cases. The relative difference between the numerical simulations and the experimental results are between 3.8% and 13.4%.

Sign in / Sign up

Export Citation Format

Share Document