scholarly journals Experimental Study on Efficiency of Floating Vertical Axis Wind Turbine with Variable-Pitch

2018 ◽  
Vol 32 (3) ◽  
pp. 202-207
Author(s):  
Jae-Heui Kim ◽  
Hyo-Jae Jo ◽  
Jae-Hyuk Hwang ◽  
Min-Suk Jang ◽  
Byeong-Seong Lee
2008 ◽  
Vol 2008.2 (0) ◽  
pp. 175-176
Author(s):  
Hiroyuki TOMIOKA ◽  
Takahiro KIWATA ◽  
Michel Elkhoury ◽  
Tetsuyoshi KITA ◽  
Nobuyoshi KOMATSU ◽  
...  

2018 ◽  
Author(s):  
Mateusz Jakubowski ◽  
Roman Starosta ◽  
Pawel Fritzkowski

2018 ◽  
Vol 10 (9) ◽  
pp. 168781401879954
Author(s):  
Soo-Yong Cho ◽  
Sang-Kyu Choi ◽  
Jin-Gyun Kim ◽  
Chong-Hyun Cho

In order to augment the performance of vertical axis wind turbines, wind power towers have been used because they increase the frontal area. Typically, the wind power tower is installed as a circular column around a vertical axis wind turbine because the vertical axis wind turbine should be operated in an omnidirectional wind. As a result, the performance of the vertical axis wind turbine depends on the design parameters of the wind power tower. An experimental study was conducted in a wind tunnel to investigate the optimal design parameters of the wind power tower. Three different sizes of guide walls were applied to test with various wind power tower design parameters. The tested vertical axis wind turbine consisted of three blades of the NACA0018 profile and its solidity was 0.5. In order to simulate the operation in omnidirectional winds, the wind power tower was fabricated to be rotated. The performance of the vertical axis wind turbine was severely varied depending on the azimuthal location of the wind power tower. Comparison of the performance of the vertical axis wind turbine was performed based on the power coefficient obtained by averaging for the one periodic azimuth angle. The optimal design parameters were estimated using the results obtained under equal experimental conditions. When the non-dimensional inner gap was 0.3, the performance of the vertical axis wind turbine was better than any other gaps.


2020 ◽  
pp. 0309524X2093513
Author(s):  
Simon A Prince ◽  
Carmine Badalamenti ◽  
Dimitar Georgiev

An experimental study is presented on the performance of a vertical axis wind turbine with variable blade geometry of the design developed by Austin Farrah. This is experimentally compared with the performance of a correspondingly sized Bach-type Savonius turbine using the same electrical generator and measurement instrumentation in a wind tunnel. Experiments were performed for Reynolds numbers, based on blade chord, in the range 5 × 103 to 1 × 105, and for blade settings between −40° and +40o. The study shows that for the tip speed ratios that have been investigated, the Farrah vertical axis wind turbine design can only marginally outperform a corresponding two-bladed Bach-type Savonius turbine and then only when its blades are set to 40° pitch angle. The presence of a small inner cylinder, which rotates with the turbine, does not enhance its performance due to the fact that it is immersed in an extensive column of relatively static air.


2012 ◽  
Vol 225 ◽  
pp. 338-343 ◽  
Author(s):  
J.J. Miau ◽  
S.Y. Liang ◽  
R.M. Yu ◽  
C.C. Hu ◽  
T.S. Leu ◽  
...  

The concept of pitch control has been implemented in the design of a small vertical-axis wind turbine. Benefits gained can be shown by the experimental and numerical results presented in this paper. As found, the method of variable pitch control outperforms the one of fixed pitch control. The present results show that the former can make remarkable improvement on the starting torque as well as the aerodynamic characteristics at low tip speed ratios.


2015 ◽  
Vol 137 (5) ◽  
Author(s):  
Vincenzo Dossena ◽  
Giacomo Persico ◽  
Berardo Paradiso ◽  
Lorenzo Battisti ◽  
Sergio Dell'Anna ◽  
...  

This paper presents the results of a wide experimental study on an H-type vertical axis wind turbine (VAWT) carried out at the Politecnico di Milano. The experiments were carried out in a large-scale wind tunnel, where wind turbines for microgeneration can be tested in real-scale conditions. Integral torque and thrust measurements were performed, as well as detailed aerodynamic measurements to characterize the flow field generated by the turbine downstream of the rotor. The machine was tested in both a confined (closed chamber) and unconfined (open chamber) environment, to highlight the effect of wind tunnel blockage on the aerodynamics and performance of the VAWT under investigation. The experimental results, compared with the blockage correlations presently available, suggest that specific correction models should be developed for VAWTs. The experimental thrust and power curves of the turbine, derived from integral measurements, exhibit the expected trends with a peak power coefficient of about 0.28 at tip-speed ratio equal to 2.5. Flow measurements, performed in three conditions for tip speed ratio equal to 1.5, 2.5, and 3.5, show the fully three-dimensional character of the wake, especially in the tip region where a nonsymmetrical wake and tip vortex are found. The unsteady evolution of the velocity and turbulence fields further highlights the effect of aerodynamic loading on the wake unsteadiness, showing the time-dependent nature of the tip vortex and the onset of dynamic stall for tip speed ratio lower than 2.


Sign in / Sign up

Export Citation Format

Share Document