Direct observation of the S1 level of the carotenoid spheroidene using near-infrared femtosecond spectroscopy

Abstract Based on the different absorption spectra of H2O and D2O in the near infrared (NIR, 800-2200 nm) a strategy is developed to measure H2O/D2O-fluxes in thin sections. The physical background of the method is presented. Results on the H2O/D2O-fluxes in filter paper and plant leaves together with both the physical and biological limitations of the new method are discussed.

Download Full-text

Direct observation of bulk and surface chemical morphologies of Ginkgo biloba leaves by Fourier transform mid- and near-infrared microspectroscopic imaging

Analytical and Bioanalytical Chemistry ◽

10.1007/s00216-013-7366-3 ◽

2013 ◽

Vol 405 (29) ◽

pp. 9385-9400 ◽

Cited By ~ 19

Author(s):

Jianbo Chen ◽

Suqin Sun ◽

Qun Zhou

Keyword(s):

Fourier Transform ◽

Direct Observation ◽

Ginkgo Biloba ◽

Near Infrared ◽

Surface Chemical

Download Full-text

Direct Observation of Heat Exchanger Deposits by Cross Sectioning

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100061835 ◽

1967 ◽

Vol 25 ◽

pp. 364-365

Author(s):

R. W. Anderson ◽

D. L. Senecal

Keyword(s):

Electron Microscopy ◽

Transmission Electron Microscopy ◽

Heat Exchanger ◽

Direct Observation ◽

Cross Sections ◽

Preparation Method ◽

Specimen Preparation ◽

Flowing Water ◽

Transmission Electron ◽

Deposit Layer

A problem was presented to observe the packing densities of deposits of sub-micron corrosion product particles. The deposits were 5-100 mils thick and had formed on the inside surfaces of 3/8 inch diameter Zircaloy-2 heat exchanger tubes. The particles were iron oxides deposited from flowing water and consequently were only weakly bonded. Particular care was required during handling to preserve the original formations of the deposits. The specimen preparation method described below allowed direct observation of cross sections of the deposit layers by transmission electron microscopy.The specimens were short sections of the tubes (about 3 inches long) that were carefully cut from the systems. The insides of the tube sections were first coated with a thin layer of a fluid epoxy resin by dipping. This coating served to impregnate the deposit layer as well as to protect the layer if subsequent handling were required.

Download Full-text

Application of a Simple Cold Stub to the Direct Observation of Frozen Hydrated Sand

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100071508 ◽

1973 ◽

Vol 31 ◽

pp. 212-213

Author(s):

John M. Wehrung ◽

Richard J. Harniman

Keyword(s):

United States ◽

Surface Water ◽

Direct Observation ◽

Controlled Study ◽

Clay Particles ◽

Organic Debris ◽

Rock Formations ◽

Water Tables ◽

Permeable Rock ◽

Natural Means

Water tables in aquifer regions of the southwest United States are dropping off at a rate which is greater than can be replaced by natural means. It is estimated that by 1985 wells will run dry in this region unless adequate artificial recharging can be accomplished. Recharging with surface water is limited by the plugging of permeable rock formations underground by clay particles and organic debris.A controlled study was initiated in which sand grains were used as the rock formation and water with known clay concentrations as the recharge media. The plugging mechanism was investigated by direct observation in the SEM of frozen hydrated sand samples from selected depths.

Download Full-text

Direct Observation of the Diffusionless β → β + ω Transformation in Titanium Alloys

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100064669 ◽

1971 ◽

Vol 29 ◽

pp. 122-123

Author(s):

N. E. Paton ◽

D. de Fontaine ◽

J. C. Williams

Keyword(s):

Electron Microscope ◽

Titanium Alloys ◽

Direct Observation ◽

Dark Field ◽

X Ray Diffraction ◽

Resistivity Measurements ◽

Selected Area Electron Diffraction ◽

Ti Alloys ◽

Thin Foils ◽

Field Device

The electron microscope has been used to study the diffusionless β → β + ω transformation occurring in certain titanium alloys at low temperatures. Evidence for such a transformation was obtained by Cometto et al by means of x-ray diffraction and resistivity measurements on a Ti-Nb alloy. The present work shows that this type of transformation can occur in several Ti alloys of suitable composition, and some of the details of the transformation are elucidated by means of direct observation in the electron microscope.Thin foils were examined in a Philips EM-300 electron microscope equipped with a uniaxial tilt, liquid nitrogen cooled, cold stage and a high resolution dark field device. Selected area electron diffraction was used to identify the phases present and the ω-phase was imaged in dark field by using a (101)ω reflection. Alloys were water quenched from 950°C, thinned, and mounted between copper grids to minimize temperature gradients in the foil.

Download Full-text