AbstractThis paper investigates on optimization of process control parameters during machining (drilling and turning) of Glass Fiber Reinforced Polymer (GFRP) composites by considering multiple process performance yields. The main characteristic indices for evaluating drilling performance are thrust force, torque and delamination factor (at entry as well as exit); the corresponding machining parameters are drill speed, feed rate and diameter of the drill bit. The following process parameters viz. spindle speed, feed rate, and depth of cut have been considered to investigate multiple process responses viz. Material Removal Rate (MRR), surface roughness (Ra), tool-tip temperature (maximum temperature generated during machining at tool-tip) and resultant cutting force whilst turning of GFRP (epoxy) composite specimens. As traditional Taguchi method is unable to solve multi-objective optimization problem; to overcome this limitation; the study proposes Principal Component Analysis (PCA) along with fuzzy logic and finally Taguchi philosophy towards multiple-objective optimization in machining of GFRP composites. Analysis of the solutions for the multi-objective optimization by aforesaid approach has been depicted through two case experimental researches. It has also been observed from drilling experiments that PCA-fuzzy (integrated with Taguchi method) has provided better result as compared to WPCA (Weighted Principal Component Analysis) based Taguchi method. The proposed PCA-Fuzzy based Taguchi method can fruitfully be applied for continuous quality improvement and off-line quality control of the process/product.
Multi Objective Optimization in Turning of EN25 Steel Using Taguchi Based Utility Concept Coupled With Principal Component Analysis
