Optimum organic loading rate for semi-continuous operation of an anaerobic process for biogas production from Jatropha curcas seed cake

2010 ◽  
Vol 2 (2) ◽  
pp. 179 ◽  
Author(s):  
Nusara Sinbuathong ◽  
Boonsong Sillapacharoenkul ◽  
Roj Khun Anake ◽  
Daniel Watts
2011 ◽  
Vol 29 (11) ◽  
pp. 1171-1176 ◽  
Author(s):  
Thomas Schmidt

Oil production from Jatropha curcas L. seeds generates large amounts of Jatropha press cake (JPC) which can be utilized as a substrate for biogas production. The objective of this work was to investigate anaerobic mono-digestion of JPC and the effects of an iron additive (IA) on gas quality and process stability during the increase of the organic loading rate (OLR). With the increase of the OLR from 1.3 to 3.2 gVS L−1 day−1, the biogas yield in the reference reactor (RR) without IA decreased from 512 to 194 LN kgVS−1 and the CH4 concentration decreased from 69.3 to 44.4%. In the iron additive reactor (IAR), the biogas yield decreased from 530 to 462 LN kgVS−1 and the CH4 concentration decreased from 69.4 to 61.1%. The H2S concentration in the biogas was reduced by addition of the IA to values below 258 ppm in the IAR while H2S concentration in the RR increased and exceeded the detection limit of 5000 ppm. The acid capacity (AC) in the RR increased to more than 20 g L−1, indicating an accumulation of organic acids caused by process instability. AC values in the IAR remained stable at values below 5 g L−1. The results demonstrate that JPC can be used as sole substrate for anaerobic digestion up to an OLR of 2.4 gVS l−1 day−1. The addition of IA has effectively decreased the H2S content in the biogas and has improved the stability of the anaerobic process and the biogas quality.


2011 ◽  
Vol 64 (2) ◽  
pp. 320-325 ◽  
Author(s):  
J. Gustavsson ◽  
B. H. Svensson ◽  
A. Karlsson

The aim of this study was to investigate the effect of trace element supplementation on operation of wheat stillage-fed biogas tank reactors. The stillage used was a residue from bio-ethanol production, containing high levels of sulfate. In biogas production, high sulfate content has been associated with poor process stability in terms of low methane production and accumulation of process intermediates. However, the results of the present study show that this problem can be overcome by trace element supplementations. Four lab-scale wheat stillage-fed biogas tank reactors were operated for 345 days at a hydraulic retention time of 20 days (37 °C). It was concluded that daily supplementation with Co (0.5 mg L−1), Ni (0.2 mg L−1) and Fe (0.5 g L−1) were required for maintaining process stability at the organic loading rate of 4.0 g volatile solids L−1 day−1.


Processes ◽  
2020 ◽  
Vol 8 (11) ◽  
pp. 1487
Author(s):  
Vicky De Groof ◽  
Marta Coma ◽  
Tom C. Arnot ◽  
David J. Leak ◽  
Ana B. Lanham

Production of medium chain carboxylic acids (MCCA) as renewable feedstock bio-chemicals, from food waste (FW), requires complicated reactor configurations and supplementation of chemicals to achieve product selectivity. This study evaluated the manipulation of organic loading rate in an un-supplemented, single stage stirred tank reactor to steer an anaerobic digestion (AD) microbiome towards acidogenic fermentation (AF), and thence to chain elongation. Increasing substrate availability by switching to a FW feedstock with a higher COD stimulated chain elongation. The MCCA species n-caproic (10.1 ± 1.7 g L−1) and n-caprylic (2.9 ± 0.8 g L−1) acid were produced at concentrations comparable to more complex reactor set-ups. As a result, of the adjusted operating strategy, a more specialised microbiome developed containing several MCCA-producing bacteria, lactic acid-producing Olsenella spp. and hydrogenotrophic methanogens. By contrast, in an AD reactor that was operated in parallel to produce biogas, the retention times had to be doubled when fed with the high-COD FW to maintain biogas production. The AD microbiome comprised a diverse mixture of hydrolytic and acidogenic bacteria, and acetoclastic methanogens. The results suggest that manipulation of organic loading rate and food-to-microorganism ratio may be used as an operating strategy to direct an AD microbiome towards AF, and to stimulate chain elongation in FW fermentation, using a simple, un-supplemented stirred tank set-up. This outcome provides the opportunity to repurpose existing AD assets operating on food waste for biogas production, to produce potentially higher value MCCA products, via simple manipulation of the feeding strategy.


Author(s):  
Javkhlan Ariunbaatar ◽  
Robert Bair ◽  
Onur Ozcan ◽  
Harish Ravishankar ◽  
Giovanni Esposito ◽  
...  

Anaerobic digestion of food waste (FW) is typically limited to large reactors due to high hydraulic retention times (HRTs). Technologies such as anaerobic membrane reactors (AnMBRs) can perform anaerobic digestion at lower HRTs while maintaining high chemical oxygen demand (COD) removal efficiencies. This study evaluated the effect of HRT and organic loading rate (OLR) on the stability and performance of a side-stream AnMBR in treating diluted fresh food waste (FW). The reactor was fed with synthetic FW at an influent concentration of 8.24 (± 0.12) g COD/L. The OLR was increased by reducing the HRT from 20 to 1 d. The AnMBR obtained an overall removal efficiency of >97 and >98% of the influent COD and total suspended solids (TSS), respectively, throughout the course of operation. The biological process was able to convert 76% of the influent COD into biogas with 70% methane content, while the cake layer formed on the membrane gave an additional COD removal of 7%. Total ammoniacal nitrogen (TAN) and total nitrogen (TN) concentrations were found to be higher in the bioreactor than in the influent, and average overall removal efficiencies of 17.3 (± 5) and 61.5 (± 3)% of TAN and TN, respectively, were observed with respect to the bioreactor concentrations after 2 weeks. Total phosphorus (TP) had an average removal efficiency of 40.39 (± 5)% with respect to the influent. Membrane fouling was observed when the HRT was decreased from 7 to 5 d and was alleviated through backwashing. This study suggests that the side-stream AnMBR can be used to successfully reduce the typical HRT of wet anaerobic food waste (solids content 7%) digesters from 20 days to 1 day, while maintaining a high COD removal efficiency and biogas production.


2020 ◽  
Vol 265 ◽  
pp. 121688
Author(s):  
Sayed Mohammad Nasiruddin ◽  
Zifu Li ◽  
Heinz-Peter Mang ◽  
Sayed Mohammad Nazim Uddin ◽  
Xiaoqin Zhou ◽  
...  

2014 ◽  
Vol 2014 ◽  
pp. 1-10 ◽  
Author(s):  
Patrice Ramm ◽  
Carsten Jost ◽  
Elisabeth Neitmann ◽  
Ulrich Sohling ◽  
Oliver Menhorn ◽  
...  

The use of recently developed magnetic foam glass particles for immobilization of microbial biomass was tested. The effect of the particles was illustrated at the production of biogas from sugar beet silage as the sole substrate. Lab-scale fermentation experiments were conducted using a mesophilic completely stirred tank reactor and a magnetic separator. Microscopic analysis revealed biofilm coverage of 50–60% on the surface of the particles within 110 days. It was possible to recover 76.3% of the particles from fermentation effluent by means of a separation procedure based on magnetic forces. Comparing a particle charged reactor with a control reactor showed a small performance gain. The methane rate was increased from1.18±0.09to1.25±0.06 L L−1 d−1and the methane yield was increased from0.302±0.029to0.318±0.022 L g−1(volatile solids) at an organic loading rate of3.93±0.22 g L−1 d−1(volatile solids). Maximum methane rates of 1.42 L L−1d−1at an organic loading rate of 4.60 g (volatile solids) L−1 d−1(reactor including magnetic particles) and 1.34 L L−1 d−1at 3.73 g L−1 d−1(control reactor) were achieved. Based on the results, it can be concluded that the use of magnetic particles could be an attractive option for the optimization of biogas production.


2018 ◽  
Vol 29 (7) ◽  
pp. 1130-1141 ◽  
Author(s):  
Emmanuel Alepu Odey ◽  
Kaijun Wang ◽  
Zifu Li ◽  
Ruiling Gao

This study investigated the efficiency of biogas production from sewage concentrate through anaerobic digestion. A continuous stirred tank reactor with a 900-mL working volume was used. The experiment was designed to investigate the influence of organic loading rate on the efficiency of biogas production and to determine the most suitable organic loading rate condition for methane production from sewage concentrate by using continuous stirred tank reactor. The reactor was operated at different organic loading rates of 1.8, 0.8, and 0.6 gCOD/(L.d). The methane composition of the biogas produced from the treatment organic loading rate (OLR). The beginning of the experiment recorded low methane production because of the high organic loading rate. However, the later part of the experiment recorded high and stable biogas production because of the relatively low OLR. Results suggested that a 0.6 gCOD/(L.d) OLR was the most efficient setup parameter for ideal methane production from sewage concentrate by using continuous stirred tank reactor.


Sign in / Sign up

Export Citation Format

Share Document