Two mechanisms have been proposed for the build-up of detonation by solid explosives: (
a
) In the
self-heating
mechanism, when
heat
is evolved during thermal decomposition of the explosive faster than it can be conducted away, the temperature of the mass and the consequent rate of decomposition rise more and more. Ultimately the whole mass deflagrates more or less violently. The mathematical condition for self-heating has been formulated, but experiments show that a further condition is required for transition from deflagration to detonation, which has not yet been formulated mathematically. (
b
) In the
mass-flow
mechanism, when the
gas
evolved during chemical decomposition of the explosive becomes comparable with the molecular mass flow required for stable detonation in the explosive, thermal decomposition changes into detonation. To test these mechanisms measurements of delay to detonation were made with loose masses of lead azide, both Service and dextrinated, ranging from 10 to 200 mg. using previously described apparatus. The azides were wetted with measured volumes of liquids with various boiling points, including: water, benzene, quinoline, diethylene glycol, glycerol, dibutyl phthalate, benzyl benzoate, nujol, tricresyl phosphate, and the effect on the detonation was observed. Mixtures of benzene with nujol and with dibutyl phthalate were also investigated. Comparative measurements were made on the deflagration of cyclonite in the same apparatus, both dry and with added liquids. The effect of liquids on the detonation of lead azide when heated was found to belong broadly to one of two classes: (i) For liquids with the boiling points considerably below the temperature at which the test was being carried out, detonation followed after a longer delay than in the absence of liquid. There was evidence that the liquid first evaporated, and then normal detonation of the azide grains took place in the vapour phase thus formed. This behaviour was shown by the following liquids: liquid b.p. (°C) azide range of testing temperatures (°C) benzene 80 dextrinated 270-340 Service 325-350 water 100 dextrinated 270-340 Service 310-370 quinoline 238 dextrinated 300-350 diethylene glycol 244 dextrinated Service 260-350 320-360 A noteworthy feature was that the threshold detonation temperature was lower when the grains of azide were surrounded by various vapours in place of air (see also tables 22 and 24). azide vapour lowering of threshold temperature compared with air 10 mg. dextrin benzene 23° water 30° diethylene glycol 22° dibutyl phthalate (raised 5°) 10 mg. Service benzene no effect water (raised 3°) diethylene glycol 5° dibutyl phthalate 6° (ii) For liquids with boiling points considerably above the temperature of test,
no detonation
was observed. However, under certain circumstances a new phenomenon was observed, in that the lead azide
‘deflagrated’
in a manner closely resembling the behaviour of the (self-heating) deflagration of an explosive such as cyclonite. This is quite different from the sharp detonation obtained with loose azide in air, when the masses are small. When the boiling point was in the neighbourhood of the testing temperature, or with mixtures of liquids with boiling points above and below the testing temperature, both classes of behaviour were observed, according to the conditions of test. Further, the temperature coefficient of the induction period for azide wetted with these intermediate liquids suggested that detonation occurred after the liquid had been displaced by nitrogen produced by thermal decomposition of some of the lead azide. From the experimental results, it is concluded that (
a
) With the masses used, lead azide will
detonate
only when the grains are surrounded by gas or vapour. (
b
) Lead azide can
deflagrate
by a self-heating mechanism even under conditions where it will not detonate, e.g. when wetted by a liquid of very high boiling point such as tricresyl phosphate. These conclusions support the view that the 'normal’ mechanism of detonation of lead azide is controlled not by self-heating but by some process such as mass flow. When this normal mechanism fails to operate explosion may still occur by self-heating.
Influence of Plasticizers on the Stress State of Epoxy Composites
