Facility for Transformation of Magnetic Characteristics of Weak Magnetic Oxidized Iron Ores in Order to Improve Technologies for Iron Ore Concentrate Production

2016 ◽  
Vol 12 (1) ◽  
pp. 22-27
Author(s):  
O.M. Ponomarenko ◽  
◽  
O.B. Brik ◽  
N.O. Dudchenko ◽  
◽  
...  
Keyword(s):  
Iron Ore ◽  
Magnetic Characteristics ◽  
Iron Ores ◽  
Oxidized Iron ◽  
Iron Ore Concentrate ◽  
Concentrate Production

scholarly journals Production of pellet feed from slimes

2013 ◽  
Vol 66 (3) ◽  
pp. 391-395 ◽  
Author(s):  
Elias Fonseca Castro ◽  
Antonio Eduardo Clark Peres
Keyword(s):  
Representative Sample ◽  
Iron Ore ◽  
Silica Content ◽  
Iron Ores ◽  
Reverse Flotation ◽  
Iron And Steel ◽  
Steel Making ◽  
Pellet Feed ◽  
Iron Bearing ◽  
Iron Ore Concentrate

The recovery of iron bearing minerals from the reject products of the beneficiation of iron ores is a challenge concerning the sustainability of the preliminary stage of iron and steel making. This investigation addressed the production of iron ore concentrate within the specifications of Samarco's pellet feed from a representative sample of the concentrator I desliming cyclone's (101.6 mm, 4") overflow. The experiments included stages of microdesliming and flotation. The developed microdesliming method was efficient and the concentrate produced via cationic reverse flotation presented silica content compatible with pellet feed requirements.

CLEANING UP EMERGENCY OIL SPILLS FROM THE WATER SURFACE WITH MAGNETIC ADSORBENTS

2017 ◽  
Author(s):  
Yury Rubanov ◽  
Yury Rubanov ◽  
Yulia Tokach ◽  
Yulia Tokach ◽  
Marina Vasilenko ◽  
...  
Keyword(s):  
Oil Recovery ◽  
Water Surface ◽  
Iron Ore ◽  
Oil Spills ◽  
Air Cooling ◽  
Steelmaking Slag ◽  
Magnetic Adsorbents ◽  
Ratio Of Components ◽  
Iron Ore Concentrate ◽  
Electric Furnace Steelmaking

There was suggested a method of obtaining a complex adsorbent with magnetic properties for the oil spill clean-up from the water surface by means of controlled magnetic field. As magnetic filler a finely-dispersed iron-ore concentrate in the form of magnetite, obtained by wet magnetic separation of crushed iron ore, was suggested. As an adsorbing component the disintegrating electric-furnace steelmaking slag, obtained by dry air-cooling method, was selected. The mass ratio of components slag:magnetite is 1(1,5÷2,0). For cleaning up emergency oil spills with the suggested magnetic adsorbent a facility, which is installed on a twin-hulled oil recovery vessel, was designed. The vessel contains a rectangular case between the vessel hulls with inlet and outlet for the treated water, the bottom of which is a permanently moving belt. Above the belt, at the end point of it there is an oil-gathering drum with magnetic system. The adsorbent is poured to oil-products layer from a hopper, provided with drum feeder. Due to the increased bulk weight the adsorbent sinks rapidly into the oil layer on the water surface. If the large non-floating flocculi are formed, they sink and sedimentate on the moving belt and are moved to the oil-gathering drum. The saturated adsorbent is removed from the drum surface with a scraper, connected with a gutter, with contains a rotating auger.

Mechanism on reduction swelling of pellets prepared from Bayan Obo iron ore concentrate

2021 ◽  
pp. 1-11
Author(s):  
Yingjie Fan ◽  
Yunhao Zhang ◽  
Zhichao Li ◽  
Yifan Chai ◽  
Yici Wang ◽  
...  
Keyword(s):  
Iron Ore ◽  
Reduction Swelling ◽  
Bayan Obo ◽  
Iron Ore Concentrate

Carbon Doped Iron Ore Using Palm Kernel Shell

2013 ◽  
Vol 701 ◽  
pp. 28-31 ◽  
Author(s):  
Rusila Zamani Abd Rashid ◽  
Hadi Purwanto ◽  
Hamzah Mohd Salleh ◽  
Mohd Hanafi Ani ◽  
Nurul Azhani Yunus ◽  
...  
Keyword(s):  
Iron Ore ◽  
Palm Kernel ◽  
Reduction Process ◽  
Attractive Alternative ◽  
Low Grade ◽  
Iron Ores ◽  
Solid Carbon ◽  
Green Composite ◽  
Biomass Waste ◽  
Palm Kernel Shell

This paper pertains to the reduction process of local low grade iron ore using palm kernel shell (PKS). It is well known that low grade iron ores contain high amount of gangue minerals and combined water. Biomass waste (aka agro-residues) from the palm oil industry is an attractive alternative fuel to replace coal as the source of energy in mineral processing, including for the treatment and processing of low grade iron ores. Both iron ore and PKS were mixed with minute addition of distilled water and then fabricated with average spherical diameter of 10-12mm. The green composite pellets were subjected to reduction test using an electric tube furnace. The rate of reduction increased as temperature increases up to 900 °C. The Fe content in the original ore increased almost 12% when 40 mass% of PKS was used. The reduction of 60:40 mass ratios of iron ore to PKS composite pellet produced almost 11.97 mass% of solid carbon which was dispersed uniformly on the surface of iron oxide. The aim of this work is to study carbon deposition of PKS in iron ore through reduction process. Utilization of carbon deposited in low grade iron ore is an interesting method for iron making process as this solid carbon can act as energy source in the reduction process.

WATER CHEMISTRY EFFECTS IN IRON ORE CONCENTRATE AGGLOMERATION FEED

2005 ◽  
Vol 26 (3-4) ◽  
pp. 295-305 ◽  
Author(s):  
T. C. Eisele ◽  
S. K. Kawatra ◽  
S. J. Ripke
Keyword(s):  
Water Chemistry ◽  
Iron Ore ◽  
Iron Ore Concentrate

scholarly journals Iron-Ore Sintering Process Optimization / Optymalizacja Procesu Aglomeracji Rudy Żelaza

2015 ◽  
Vol 60 (4) ◽  
pp. 2895-2900 ◽  
Author(s):  
M. Fröhlichová ◽  
D. Ivanišin ◽  
A. Mašlejová ◽  
R. Findorák ◽  
J. Legemza
Keyword(s):  
Iron Content ◽  
Iron Ore ◽  
Raw Materials ◽  
Size Composition ◽  
Sintering Process ◽  
Iron Ore Sintering ◽  
Iron Ore Sinter ◽  
A Charge ◽  
Iron Ore Concentrate

The work deals with examination of the influence of the ratio between iron ore concentrate and iron ore on quality of produced iron ore sinter. One of the possibilities to increase iron content in sinter is the modification of raw materials ratio, when iron ore materials are added into sintering mixture. If the ratio is in favor of iron ore sinter, iron content in resulting sintering mixture will be lower. If the ratio is in favor of iron ore concentrate and recycled materials, which is more finegrained, a proportion of a fraction under 0.5 mm will increase, charge permeability property will be reduced, sintering band performance will decrease and an occurrence of solid particulate matter in product of sintering process will rise. The sintering mixture permeability can be optimized by increase of fuel content in charge or increase of sinter charge moisture. A change in ratio between concentrate and iron ore has been experimentally studied. An influence of sintering mixture grain size composition, a charge grains shape on quality and phase composition on quality of the produced iron sinter has been studied.

Sign in / Sign up

Export Citation Format

Share Document