scholarly journals Morphology and optical constants of nanographite films created by thermal vacuum deposition

2015 ◽  
Vol 18 (1) ◽  
pp. 106-109
Author(s):  
V. Kozachenko ◽  
2013 ◽  
Vol 538 ◽  
pp. 125-128 ◽  
Author(s):  
Hirofumi Saito ◽  
Hiroki Komatsuzaki ◽  
Ryuta Ikoma ◽  
Takayuki Komori ◽  
Keigo Kuroda ◽  
...  

Improved fabrication processes of a micro electroosmotic flow pump using hot embossing are described. The microchannels in the micropump were fabricated by hot embossing on a polymethylmethacrylate (PMMA) substrate. A silicon micromachined mold was pressed into the PMMA substrate at a temperature of 145 °C to form microchannel patterns on the substrate. The depth and width of the microchannels were 50 μm and 100 μm, respectively. Aluminum electrodes were deposited using thermal vacuum deposition. A UV ozone treatment was performed to improve adhesion between the PMMA substrate and a PMMA capping layer. This UV ozone treatment enhanced adhesion and resulted in the reduction of the adhesion temperature as low as 70 °C, and nearly no deformation of the microchannels was observed. As a result, the electroosmotic flow pump exhibited the flow rate of 0.5 μl/min when a voltage of 50 V was given between the electrodes separated 8 mm each other.


2021 ◽  
Vol 66 (1) ◽  
pp. 175-175
Author(s):  
A. K. Shokanov ◽  
M. F. Vereshchak ◽  
I. A. Manakova ◽  
A. N. Ozernoy ◽  
Zh. K. Tleubergenov ◽  
...  

2016 ◽  
Vol 4 (1) ◽  
pp. 22-30
Author(s):  
Vitalii Borblik ◽  
Andrey Korchevoi ◽  
Andrii Nikolenko ◽  
Viktor Strelchuk ◽  
Alexander Fonkich ◽  
...  

Author(s):  
А. Папикян ◽  
С. Арутюнян ◽  
Н. Агамалян ◽  
Р. Овсепян ◽  
А. Хачатурова ◽  
...  

Abstract Single-layer Sb2Te3 films and three-layer Sb2Te3/Sb2S3/Sb2Te3 structures are obtained by thermal vacuum deposition. Their thermoelectric characteristics have been investigated in a wide temperature range (5350 K). It is shown that the conductivity of Sb2Te3/Sb2S3/Sb2Te3 has a semiconductor behavior, the resistivity is an order of magnitude higher than the resistivity of the Sb2Te3 film; the Seebeck coefficient of Sb2Te3/Sb2S3/Sb2Te3 is 1.5 and 3 times higher than the Seebeck coefficient of the film and single-crystal Sb2Te3, respectively. The currentvoltage characteristics of the Sb2Te3 film exhibit memristive properties with unipolar resistive switching, whereas Sb2Te3/Sb2S3/Sb2Te3 can be considered as a memristor with a parallel connected capacitance.


2018 ◽  
Vol 10 (1) ◽  
pp. 01028-1-01028-3 ◽  
Author(s):  
I. P. Koziarskyi ◽  
◽  
E. V. Maistruk ◽  
D. P. Koziarskyi ◽  
P. D. Maryanchuk ◽  
...  

2020 ◽  
Vol 65 (3) ◽  
pp. 363-366
Author(s):  
A. K. Shokanov ◽  
M. F. Vereshchak ◽  
I. A. Manakova ◽  
A. N. Ozernoy ◽  
Zh. K. Tleubergenov ◽  
...  

1994 ◽  
Vol 72 (3) ◽  
pp. 678-694 ◽  
Author(s):  
Bishun N. Khare ◽  
Carl Sagan ◽  
W. Reid Thompson ◽  
Edward T. Arakawa ◽  
Caroline Meisse ◽  
...  

Matthews (1992) has proposed that HCN "polymer" is ubiquitous in the solar system. We apply vacuum deposition and spectroscopic techniques previously used on synthetic organic heteropolymers (tholins), kerogens, and meteoritic organic residues to the measurement of the optical constants of poly-HCN in the wavelength range 0.05–40 µm. These measurements allow quantitative comparison with spectrophotometry of organic-rich bodies in the outer solar system. In a specific test of Matthews' hypothesis, poly-HCN fails to match the optical constants of the haze of the Saturnian moon, Titan, in the visible and near-infrared, derived from astronomical observations and standard models of the Titan atmosphere. In contrast, a tholin produced from a simulated Titan atmosphere matches within the probable errors. Poly-HCN is much more N-rich than Titan tholin.


Sign in / Sign up

Export Citation Format

Share Document