Microwave dielectric properties of Ca[(Li1/3Nb2/3)1−xMx]O3−δ (M = Sn, Ti) ceramics

1999 ◽  
Vol 14 (9) ◽  
pp. 3567-3570 ◽  
Author(s):  
Ji-Won Choi ◽  
Chong-Yun Kang ◽  
Seok-Jin Yoon ◽  
Hyun-Jai Kim ◽  
Hyung-Jin Jung ◽  
...  
Keyword(s):  
Dielectric Constant ◽  
Dielectric Properties ◽  
Resonant Frequency ◽  
Temperature Coefficient ◽  
Quality Factor ◽  
Single Phase ◽  
Microwave Dielectric Properties ◽  
Multiphase Materials ◽  
Microwave Dielectric ◽  
Orthorhombic Perovskite

The microwave dielectric properties of Ca[(Li1/3Nb2/3)1−xMx]O3−δ (M = Sn, Ti, 0 ≤ x ≤ 0.5) ceramics were investigated. In general, the ceramics prepared were multiphase materials. However, single-phase specimens having orthorhombic perovskite structure similar to CaTiO3 could be obtained in the vicinity of Sn = 0.2 to 0.3, and Ti = 0.2. As Sn concentration increased, the dielectric constant (εr) decreased and the quality factor (Q) significantly increased within the limited Sn concentration. As Ti concentration increased, the dielectric constant (εr) increased, the quality factor (Q) decreased, and the temperature coefficient of resonant frequency (τf) changed from a negative to positive value. The temperature coefficient of resonant frequency of 0 ppm/°C was realized at Ti = 0.2. The Q · fo value and εr for this composition were found to be 26100 GHz and 38.6, respectively.

Effects of CuO and V2O5 Addition on Sintering Behavior and Microwave Dielectric Properties of (1-x)Ca2P2O7-xTiO2

2007 ◽  
Vol 336-338 ◽  
pp. 279-282
Author(s):  
In Sun Cho ◽  
Sang Gu Kang ◽  
Dong Wan Kim ◽  
Kug Sun Hong
Keyword(s):  
Dielectric Constant ◽  
Dielectric Properties ◽  
Resonant Frequency ◽  
Temperature Coefficient ◽  
Quality Factor ◽  
Sintering Temperature ◽  
Microwave Dielectric Properties ◽  
Sintering Behavior ◽  
Microwave Dielectric

The effects of CuO and V2O5 addition on sintering behaviors and microwave dielectric properties of 0.7Ca2P2O7-0.3TiO2 ceramics were investigated. With CuO and V2O5 addition, the sintering temperature of 0.7Ca2P2O7-0.3TiO2 can be effectively reduced from 1150 to 950oC. The dielectric constant of the low fired 0.7Ca2P2O7-0.3TiO2 ceramics was not significantly changed while the quality factor was affected by additives. The temperature coefficient of resonant frequency value was increased in negative value with the additive contents. V2O5 and CuO additives effectively improved the densification and dielectric properties of 0.7Ca2P2O7-0.3TiO2 ceramics. The correlation between the phase constituents and the dielectric properties was investigated with additive contents.

Dielectric properties of La-substituted Pb0.5Ca0.5[(Mg1/3Nb2/3)0.5Ti0.5]O3 ceramics

2001 ◽  
Vol 16 (7) ◽  
pp. 2053-2056
Author(s):  
X. J. Lu ◽  
X. M. Chen
Keyword(s):  
Dielectric Constant ◽  
Dielectric Properties ◽  
Resonant Frequency ◽  
Temperature Coefficient ◽  
Microwave Dielectric Properties ◽  
Present Approach ◽  
Calculated Temperature ◽  
Microwave Dielectric ◽  
La Substitution ◽  
Dielectric Ceramics

Modification of Pb0.5Ca0.5[(Mg1/3Nb2/3)0.5Ti0.5]O3 dielectric ceramics was performed by up to 20 mol% La substitution for Pb and Ca. The temperature coefficient of dielectric constant was significantly reduced by the present approach, while an increased Qf factor was achieved. Good microwave dielectric properties were obtained in a composition Pb0.425Ca0.425La0.1[(Mg1/3Nb2/3)0.5Ti0.5]O3: ε = 125; Qf = 3150 GHz; calculated temperature coefficient of resonant frequency δf = +253 ppm/°C.

Effect of BaCu(B2O5) on the sintering temperature and microwave dielectric properties of Ba(Nd0.8Bi0.2)2Ti4O12 ceramics

2010 ◽  
Vol 25 (12) ◽  
pp. 2380-2383 ◽  
Author(s):  
Yi Zeng ◽  
Hong Wang ◽  
Huanfu Zhou
Keyword(s):  
Dielectric Properties ◽  
Low Temperature ◽  
Resonant Frequency ◽  
Temperature Coefficient ◽  
Quality Factor ◽  
Sintering Temperature ◽  
Microwave Dielectric Properties ◽  
Potential Candidate ◽  
Microwave Dielectric ◽  
Quality Factor Q

The effect of BaCu(B2O5) (BCB) on the sintering temperature and microwave dielectric properties of Ba(Nd0.8Bi0.2)2Ti4O12 (BNBT) ceramics was investigated. The sintering temperature of the BNBT ceramics was significantly reduced from 1300 to 900 °C. Due to adding BCB into Ba(Nd1–xBix)2Ti4O12, the temperature coefficient of resonant frequency can be adjusted to zero with BCB content increasing. Good microwave dielectric properties of quality factor (Q×f) = 2600 GHz, εr = 75, and τf = 5 ppm/°C were obtained for BNBT with 7 wt% BCB sintered at 925 °C for 2 h, which make it a potential candidate for low temperature cofired ceramics applications.

Crystal Structure and Microwave Dielectric Properties of Ca[(Li1/3Nb2/3)0.95Zr0.15]O3+δ Ceramics with Pr3+ Substitution at A-Site

2011 ◽  
Vol 181-182 ◽  
pp. 439-442
Author(s):  
Gang Xiong
Keyword(s):  
Crystal Structure ◽  
Dielectric Properties ◽  
Quality Factor ◽  
Perovskite Structure ◽  
Single Phase ◽  
Microwave Dielectric Properties ◽  
Microwave Dielectric ◽  
Resonator Frequency ◽  
Orthorhombic Perovskite ◽  
A Site

Crystal structure and microwave dielectric properties of (Ca1-xPrx) [(Li1/3Nb2/3)0.95Zr0.15]3+δ (0.0≤x≤0.2, CPLNZ) ceramics were investigated. A single phase with orthorhombic perovskite structure was obtained at x=0.0~0.08. With an increase of Pr3+ content, the quality factor value firstly increased, and then began to decrease at x=0.06 due to a decrease of the degree of B-site 1:2 ordering. The variation of τf with tolerance factor was discussed. When x=0.06, the optimum microwave dielectric properties: the permittivity is 33.2, the quality factor is 17120 GHz，and the temperature coefficient of resonator frequency is −5.7×10−6/°C.

Microwave Dielectric Properties of Ca[(Li1/3Nb2/3)0.95Zr0.15]O3+δ Ceramics with Sm3+ Substitution at A-Site

2010 ◽  
Vol 663-665 ◽  
pp. 698-701
Author(s):  
Gang Xiong
Keyword(s):  
Crystal Structure ◽  
Dielectric Properties ◽  
Quality Factor ◽  
Perovskite Structure ◽  
Single Phase ◽  
Microwave Dielectric Properties ◽  
Microwave Dielectric ◽  
Resonator Frequency ◽  
Orthorhombic Perovskite ◽  
A Site

Crystal structure and microwave dielectric properties of (Ca1-xSmx) [(Li1/3Nb2/3)0.95Zr0.15]3+δ(0.0≤x≤0.2,CSLNZ) ceramics were investigated. A single phase with orthorhombic perovskite structure was obtained at x=0.0~0.08. With an increase of Sm3+ content, the quality factor value firstly increased, and then began to decrease at x=0.03 due to a decrease of the degree of B-site 1:2 ordering. The variation of τf with tolerance factor was discussed. When x=0.05, the optimum microwave dielectric properties: the permittivity is 32.4，the quality factor is 16560GHz，and the temperature coefficient of resonator frequency is −6.3×10−6/°C。

Shifting τf Value of (Mg0.95Co0.05)TiO3 Ceramics by Ca0.61Nd0.78/3TiO3 Addition

2013 ◽  
Vol 807-809 ◽  
pp. 2703-2706
Author(s):  
Ping Cheng Chen ◽  
Chung Long Pan ◽  
Wei Cheng Lin ◽  
Chun Hsu Shen
Keyword(s):  
Dielectric Constant ◽  
Dielectric Properties ◽  
Resonant Frequency ◽  
Temperature Coefficient ◽  
Significant Role ◽  
Microwave Dielectric Properties ◽  
Dielectric Measurement ◽  
Zero Temperature ◽  
Microwave Dielectric

Modification of (Mg0.95Co0.05)TiO3ceramics by Ca0.61Nd0.78/3TiO3addition was investigated. The Ca0.61Nd0.78/3TiO3content plays a significant role in improving the dielectric properties. Microwave dielectric measurement showed an increase in dielectric constant (εr) and temperature coefficient of the resonant frequency (τf) and a decrease inQvalue with increasing Ca0.61Nd0.78/3TiO3content. By properly adjusting the Ca0.61Nd0.78/3TiO3content, zero temperature coefficient of resonate frequencyτfcan also be obtained. It becomes more promising in the application of wireless system.At 1375°C, the 0.85(Mg0.95Co0.05)TiO3-0.15Ca0.61Nd0.78/3TiO3ceramics possesses excellent microwave dielectric properties: a dielectric constant εr of 24.37, aQfvalue of 66200 ( at 7 GHz ) and a τf value of-1.4 ppm/°C.

INFLUENCE OF n ON STRUCTURE AND MICROWAVE DIELECTRIC PROPERTIES OF SOME AnBn - 1O3n PEROVSKITES

2011 ◽  
Vol 01 (01) ◽  
pp. 135-140
Author(s):  
LIANG FANG ◽  
ZHAO YANG ◽  
HUI ZHANG ◽  
CHUNCHUN LI ◽  
HEPING SU
Keyword(s):  
Dielectric Constant ◽  
Dielectric Properties ◽  
Resonant Frequency ◽  
Temperature Coefficient ◽  
General Formula ◽  
Microwave Dielectric Properties ◽  
Structure And Properties ◽  
Quality Factors ◽  
Microwave Dielectric

Two series of B-site deficient perovskites Ba 5+m Ti m Nb 4 O 15+3m(m = 1, 2, 3) and Sr 3+m LaTi m Nb 3 O 12+3m(m = 0, 1, 2) with the general formula A n B n - 1 O 3n(n = 4 - 8; A = Ba , Sr , La ; B = Nb , Ti ) have been synthesized, and their structure and microwave dielectric properties have been investigated. The effects of n (number of octahedra layers within a perovskite blocks) on structure and properties are investigated. The values of dielectric constant εr and temperature coefficient of resonant frequency τf gradually increase, but quality factors Q × f values significantly decreases as the values of n increase.

Micr owave Dielectric Properties of (1-x)CaTiO3-xNd(Mg1/2Ti1/2)O3 Ceramics System

2003 ◽  
Vol 783 ◽  
Author(s):  
Cheng-Liang Huang ◽  
Yuan-Bin Chen ◽  
Ching-Wen Lo
Keyword(s):  
Solid Solution ◽  
Dielectric Constant ◽  
Dielectric Properties ◽  
Resonant Frequency ◽  
Quality Factor ◽  
Sintering Temperature ◽  
Microwave Dielectric Properties ◽  
Compositional Range ◽  
Microwave Dielectric

ABSTRACTThe microwave dielectric properties of (1-x)CaTiO3-xNd(Mg1/2Ti1/2)O3 (0.1≤x≤1.0) have been investigated. The system forms a solid solution throughout the entire compositional range. The dielectric constant decreases from 152 to 27 as x varies from 0.1 to 1.0. In the (1-x)CaTiO3-xNd(Mg1/2Ti1/2)O3 system, the microwave dielectric properties can be effectively controlled by varying the x value. A maximum quality factor Qxf=43000GHz (where f is the resonant frequency) was achieved for samples with x=0.9, although the dielectric properties varied with sintering temperature. The Qxf value of (1-x)CaTiO3-xNd(Mg1/2Ti1/2)O3 almost increased up to 1500°C, after which it decreased. At 1400°C, 0.1CaTiO3-0.9Nd(Mg1/2Ti1/2)O3 ceramics gives a dielectric constant εr of 42, a Qxf value of 35000 (GHz) and a τf value of -10 (ppm/°C).

Sign in / Sign up

Export Citation Format

Share Document