Mechanical Relaxation Time Scales in a Zr–Ti–Ni–Cu–Be Bulk Metallic Glass

2002 ◽  
Vol 17 (6) ◽  
pp. 1254-1257 ◽  
Author(s):  
Daewoong Suh ◽  
Reinhold H. Dauskardt

The relaxation time scales in a commercial-grade Zr41.25Ti13.75Ni10Cu12.5Be22.5 (at.%) bulk metallic glass were examined using transient and dynamic mechanical experiments. The viscoelastic and sub-Tg relaxations were well described by the Kohlrausch–Williams–Watts relaxation function. A large activation energy (4.0 eV) and small nonexponentiality parameter (approximately 0.5) were observed for viscoelastic relaxation above Tg consistent with the cooperative nature of atomic movements leading ultimately to viscous flow. Conversely, a small activation energy (0.1 eV) and large nonexponentiality parameter (approximately 0.9) were observed for the sub-Tg relaxation suggesting localized atomic adjustments which may involve different structural units or mechanisms. The glass transition was manifested as a decoupling of the sub-Tg and viscoelastic relaxation. The resulting transition temperature determined at a selected time scale was in agreement with the value obtained from calorimetric studies.

2003 ◽  
Vol 18 (8) ◽  
pp. 1998-1999 ◽  
Author(s):  
K. Schröter

The stress relaxation results below the glass-transition temperatureTgare a continuation of the viscoelastic relaxation aboveTg. This means that the dynamic glass transition and not a secondary relaxation is the reason for the observed effects.


Nanomaterials ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 1670
Author(s):  
Abhilash Gunti ◽  
Parijat Pallab Jana ◽  
Min-Ha Lee ◽  
Jayanta Das

The effect of cold rolling on the evolution of hardness (H) and Young’s modulus (E) on the rolling-width (RW), normal-rolling (NR), and normal-width (NW) planes in Zr41.2Ti13.8Cu12.5Ni10Be22.5 (Vitreloy 1) bulk metallic glass (BMG) was investigated systematically using nanoindentation at peak loads in the range of 50 mN–500 mN. The hardness at specimen surface varied with cold rolling percentage (%) and the variation is similar on RW and NR planes at all the different peak loads, whereas the same is insignificant for the core region of the specimen on the NW plane. Three-dimensional (3D) optical surface profilometry studies on the NR plane suggest that the shear band spacing decreases and shear band offset height increases with the increase of cold rolling extent. Meanwhile, the number of the pop-in events during loading for all the planes reduces with the increase of cold rolling extent pointing to more homogeneous deformation upon rolling. Calorimetric studies were performed to correlate the net free volume content and hardness in the differently cold rolled specimens.


2001 ◽  
Vol 79 (11) ◽  
pp. 1605-1607 ◽  
Author(s):  
C. C. Hays ◽  
J. Schroers ◽  
W. L. Johnson ◽  
T. J. Rathz ◽  
R. W. Hyers ◽  
...  

2018 ◽  
Vol 32 (6) ◽  
pp. 726-732 ◽  
Author(s):  
J. C. Qiao ◽  
Y. H. Chen ◽  
G. J. Lyu ◽  
K. K. Song ◽  
J. M. Pelletier ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document