Controlled Strategy for the Cooling Effect of the Solar-Driven Constant-Temperature Solid Sorption System

2021 ◽  
Vol 15 (9) ◽  
pp. 464
Author(s):  
Hassan Zohair Hassan ◽  
Ghada Emam Atteia
Keyword(s):  
Constant Temperature ◽  
Cooling Effect ◽  
Sorption System

Evaluation of a hybrid personal cooling system using a manikin operated in constant temperature mode and thermoregulatory model control mode in warm conditions

2016 ◽  
Vol 87 (1) ◽  
pp. 46-56 ◽  
Author(s):  
Dandan Lai ◽  
Fanru Wei ◽  
Yehu Lu ◽  
Faming Wang
Keyword(s):  
Cooling Rate ◽  
Constant Temperature ◽  
Cooling System ◽  
Cooling Effect ◽  
Control Mode ◽  
Air Velocity ◽  
Work Condition ◽  
Model Control ◽  
Thermoregulatory Model ◽  
Personal Cooling

In this study, the cooling effect of a portable hybrid personal cooling system (PCS) was investigated on a sweating manikin operated in the constant temperature (CT) mode and the thermoregulatory model control (TMC) mode. Both dry (i.e., no sweating) and wet manikin tests (i.e., sweating) were performed in the CT mode in a warm condition (30℃, 47% relative humidity (RH), air velocity va = 0.4 m/s). For the TMC mode, two case studies were simulated: light work condition (30℃, 47% RH, air velocity va = 0.15 m/s, duration: 60 min, metabolic rate: 1.5 METs) and construction work condition (30℃, 47% RH, va = 1.0 m/s, 40 min exercise [5.5 METs] and 20 min rest [1.2 METs]). Four test scenarios were selected: fans off with no phase change materials (PCMs) (i.e., Fan-off, the Control), fans on with no PCMs (i.e., Fan-on), fans off with fully solidified PCMs (i.e., PCM+Fan-off) and fans on with fully solidified PCMs (i.e., PCM+Fan-on). Under the dry condition, the cooling rate in PCM+Fan-off during the initial stage (e.g., 55 and 50 W for the first 15 min and 20 min, respectively) was higher than that in Fan-on (i.e., 45 ± 1 W); under the wet condition, the cooling rate in PCM+Fan-off (e.g., 45 W for 10 min) was much lower than that in Fan-on (i.e., 282 ± 1 W). The hybrid PCS (i.e., PCM+Fan-on) provided a continuous strong cooling effect. Simulation results indicated that ventilation fans or PCMs alone could provide sufficient cooling while doing light work. For the intensive work condition, the PCS in all three scenarios (i.e., PCM+Fan-off, Fan-on and PCM+Fan-on) exhibited beneficial cooling, and the hybrid PCS showed an optimized performance in alleviating heat strain during both exercise and recovery periods. It was thus concluded that the PCS could effectively remove body heat in warm conditions for moderate intensive activities.

Improvement in the Fock test for determining the reactivity of dissolving pulp

TAPPI Journal ◽  
2013 ◽  
Vol 12 (11) ◽  
pp. 21-26 ◽  
Author(s):  
CHAO TIAN ◽  
LINQIANG ZHENG ◽  
QINGXIAN MIAO ◽  
CHRIS NASH ◽  
CHUNYU CAO ◽  
...  
Keyword(s):  
Moisture Content ◽  
Sodium Hydroxide ◽  
Constant Temperature ◽  
Carbon Disulfide ◽  
Testing Procedure ◽  
Dissolving Pulp ◽  
Water Bath ◽  
Testing Conditions ◽  
Pulp Sample ◽  
Fock Reactivity

The Fock test is widely used for assessing the reactivity of dissolving pulp. The objective of this study was to modify the method to improve the repeatability of the test. Various parameters that affect the repeatability of the Fock test were investigated. The results showed that Fock reactivity is dependent on testing conditions affecting the xanthation between cellulose and carbon disulfide, such as the moisture content of the pulp sample, sodium hydroxide (NaOH) concentration, xanthation temperature, carbon disulfide dosage, and xanthation time. The repeatability of the test was significantly improved using the following modified testing procedure: air dried sample in the constant temperature/humidity room, xanthation temperature of 66°F (19°C) in a water bath, xanthation time of 3 h, NaOH concentration of 9% (w/w), and 1.3 mL carbon disulfide.

ACTION OF ENZYME DIGESTED PITUITARY GLANDS OF THE SKIPPER-FROG ON THE OVULATION OF THE SAME

1960 ◽  
Vol XXXIII (II) ◽  
pp. 255-260 ◽  
Author(s):  
L. S. Ramaswami ◽  
A. B. Lakshman
Keyword(s):  
Pituitary Gland ◽  
Constant Temperature ◽  
Constant Temperature Bath ◽  
Predominant Role ◽  
Lower Vertebrates ◽  
Pituitary Glands ◽  
Stimulating Factor

ABSTRACT By using enzymes, the gonadotrophic factors in the skipper-frog pituitary glands have been selectively inactivated or destroyed. By incubating a known number of pituitary gland homogenate with ptyalin in a constant temperature bath for 5–6 h the follicle-stimulating factor is inactivated; with trypsin or pepsin, the luteinizing factor is inactivated. Bioassay on gravid skipper-frogs indicate that the ptyalin digested homogenate brings about profuse spawning while the trypsin or pepsin digested homogenates do not. When a combination of ptyalin digested and trypsin digested homogenates is injected into fresh gravid skipper-frogs, poor spawning is brought about. These experiments show that the luteinizing factor alone brings about more profuse spawning than when it is combined with the follicle-stimulating factor. It is likely, therefore, that in the lower vertebrates the luteinizing factor of the pituitary gland plays a more predominant role. The exact proportions in which the different dosages for the control and test animals are administered are also tabulated.

PENGARUH BEBAN PENDINGIN PADA MESIN PENKONDISIAN UDARA HIBRIDA DENGAN KONDENSOR DUMMY TIPE MULTI HELICAL COIL SEBAGAI WATER HEATER

2019 ◽  
Vol 17 (2) ◽  
pp. 69
Author(s):  
Afdhal Kurniawan Mainil ◽  
Sarwo Fikri ◽  
Azridjal Aziz
Keyword(s):  
Cooling Effect ◽  
Coefficient Of Performance ◽  
Helical Coil ◽  
Water Heater

Mesin pengkondisian udara umumnya digunakan untuk memberikan efek pendinginan (cooling effect). Efek pendinginan dimaksudkan untuk memberikan kenyamanan di ruang yang didinginkan, sehingga rasa nyaman membuat orang betah didalamnya. Mesin pengkondisian udara secara termodinamika kebanyakan beroperasi menggunakan siklus kompresi uap, dimana panas diserapkan disisi evaporator di dalam ruangan, kemudian panas tersebut dibuang di kondensor di luar ruangan. Proses tersebut dapat berlangsung karena kerja kompresor dan penurunan tekanan yang terjadi pada katup ekpansi atau pipa kapiler, sehingga siklus kompresi uap bekerja sempurna. Pada sistem pengkondisian udara biasanya panas terbuang kelingkungan begitu saja, panas tersebut dapat dimanfaatkan untuk memanaskan air dengan penambahan kondensor dummy. Penambahan kondensor dummy pada penelitian ini dilakukan untuk melihat pengaruh penambahan kondensor dummy terhadap beban pendingin, daya kompresi, temperatur, dan Coefficient of Performance (COP). Metode yang digunakan pada penelitian ini ialah metode rancang bangun dan eksperimental. Berdasarkan hasil pengujian, selama pengoperasian 120 menit diperoleh temperatur air panas pada  kondisi tanpa beban (0W), beban 1000W, 2000W dan 3000W berturut-turut adalah 52,83oC, 56,58oC, 57,93oC dan 64,73oC.

Control of the adiabatic flow reactor by feeding the catalyst solution

1979 ◽  
Vol 44 (8) ◽  
pp. 2352-2365
Author(s):  
Josef Horák ◽  
Zina Sojková ◽  
František Jiráček
Keyword(s):  
Steady State ◽  
Constant Temperature ◽  
Reaction Temperature ◽  
Control Algorithm ◽  
Flow Reactor ◽  
Operating Temperature ◽  
Temperature Deviation ◽  
Adiabatic Flow ◽  
Dosing Frequency ◽  
Laboratory Reactor

Control algorithm of the operating temperature is described in the reactor, which is operated at constant temperature and composition of the inlet mixture. The temperature is controlled by dosing a constant volume of the catalyst solution. The dosing frequency is determined according to the reaction temperature (deviation of the temperature from the desired value and the sign of the derivative of temperature). The control algorithm has been verified experimentally for the laboratory reactor in unstable steady state.

Temperature and concentration dependence of equivalent conductivity in Ca(NO3)2-CaI2-H2O system

1980 ◽  
Vol 45 (6) ◽  
pp. 1639-1645 ◽  
Author(s):  
Jindřich Novák ◽  
Ivo Sláma
Keyword(s):  
Linear Function ◽  
Concentration Dependence ◽  
Mole Fraction ◽  
Constant Temperature ◽  
Salt Concentration ◽  
Free Water ◽  
Water Molecules ◽  
Equivalent Conductivity ◽  
Calcium Salts ◽  
Fraction I

The dependence of the equivalent conductivity on the temperature and composition of the Ca(NO3)2-CaI2-H2O system was studied. The ionic fraction [I-]/([I-] + [NO-3]) was changed from 0.1 to 0.5, the mole fraction of calcium salts (assumed in anhydrous form in the presence of free water molecules) was 0.075-0.200. The equivalent conductivity was found to be a linear function of the ionic fraction at constant temperature and salt concentration.

Sign in / Sign up

Export Citation Format

Share Document