EFFECT OF ELECTRICAL CONDUCTIVITY AND SUPPLY RATE OF THE NUTRIENT SOLUTION ON STOMATAL CONDUCTANCE OF ROSE PLANT LEAVES

1996 ◽  
pp. 131-134 ◽  
Author(s):  
S. Isaac ◽  
L. Urban
Agronomy ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 1237
Author(s):  
Antonios Chrysargyris ◽  
Spyridon A. Petropoulos ◽  
Dejan Prvulovic ◽  
Nikolaos Tzortzakis

Abiotic factors in nutrient solutions (NSs), such as salinity and high electrical conductivity (EC), may adversely alter plant growth and crop performance. However, there are medicinal/aromatic plants which can not only withstand these adverse conditions, but which can also increase their productivity or even enhance their quality in such conditions. As fresh water sources suitable for irrigation are becoming more and more limited, the use of low-quality water sources and hydroponic growing systems have been suggested as the main alternatives. Towards that direction, this study aims to evaluate the effect of high EC levels in NSs on geranium (Pelargonium graveolens L’Hér.) and common verbena (Verbena officinallis L.) plants cultivated in a soilless (perlite) hydroponics system. Plants were irrigated with a full nutrient solution of EC 2.1 dS m−1 and pH 5.8 until they reached a uniform size. Then, three treatments were applied, namely: (a) a control treatment with an EC of 2.1 dS m−1 in the NS, (b) a high-salinity NS created by adding 75 mM of NaCl (EC under 8.5 dS m−1) and (c) a concentrated NS with an EC of 8.5 dS m−1. In pelargonium, high salinity decreased the total phenolic and total flavonoid contents; antioxidant capacity; N, K, Mg and P content; as well as chlorophyll fluorescence, compared to the control treatment. On the other hand, increased salinity levels increased the Na and Ca content and stomatal resistance. In common verbena, salinity decreased total phenolic content and chlorophyll fluorescence but increased total flavonoid content; antioxidants; leaf K, P, Na, Cu and Zn content; and stomatal resistance, compared to the control. In both species, high EC did not affect polyphenols, flavonoids or antioxidants, whereas it increased stomatal resistance and nutrient accumulation in the leaves, and decreased chlorophyll fluorescence compared to the control treatment. Damage indices, indicated by lipid peroxidation, hydrogen peroxide production and the elevation of enzymes’ antioxidant activities, were evidenced in both saline- and high-EC-treated plants. In conclusion, despite having the same EC levels in the nutrient solution, it seems that ionic stress caused by high mineral concentrations in the nutrient solution had less severe effects on the tested plants than the relevant osmotic stress caused by high salinity due to the addition of NaCl in the nutrient solution.


2001 ◽  
pp. 503-508 ◽  
Author(s):  
A. Elia ◽  
F. Serio ◽  
A. Parente ◽  
P. Santamaria ◽  
G. Ruiz Rodriguez

2019 ◽  
Vol 20 (2) ◽  
pp. 484-492 ◽  
Author(s):  
Obed I. Hernández-Pérez ◽  
Luis A. Valdez-Aguilar ◽  
Irán Alia-Tejacal ◽  
Andrew D. Cartmill ◽  
Donita L. Cartmill

1998 ◽  
Author(s):  
D. Davis ◽  
N. Dogan ◽  
H. Aglan ◽  
D. Mortley ◽  
P. Loretan

Author(s):  
Muhammad Khairie Idham Abd Rahman ◽  
Salinda Buyamin ◽  
M. S. Zainal Abidin ◽  
Musa Mohd Mokji

This work proposed an automatic mixing system of nutrient solution for rock melon fertigation according to the required electrical conductivity (EC) level. Compared to the manual practice, this automatic system will ensure continuous supply of mixed nutrient solution without the need to daily check and mix new nutrient. Thus, this easy to use and low cost automatic system will reduce the burden of the farmers. This system uses an EC sensor to automatically check the concentration level of the mixed nutrient solution. Other than that, the system only consists of electronic pumps for mixing process and an Arduino board as the controller. The controller will monitor the EC level and run the mixing process when the EC level is below the required level. By calibrating the EC sensors, the test shows that the automatic mixing system is able to accurately keep the mixed nutrient solution concentration in a 400 L mixing reservoir at several required levels.


Sign in / Sign up

Export Citation Format

Share Document