Three-Dimensional Numerical Simulations of Flow Past a Rotating Circular Cylinder at a Reynolds Number of 500

2020 ◽  
Vol 30 (1) ◽  
pp. 105-111
Author(s):  
Adnan Munir ◽  
Ming Zhao ◽  
Helen Wu
Keyword(s):  
Reynolds Number ◽  
Circular Cylinder ◽  
Numerical Simulations ◽  
Three Dimensional ◽  
Rotating Circular Cylinder ◽  
Flow Past

Numerical investigation of wake flow regimes behind a high-speed rotating circular cylinder in steady flow

2019 ◽  
Vol 878 ◽  
pp. 875-906
Author(s):  
Adnan Munir ◽  
Ming Zhao ◽  
Helen Wu ◽  
Lin Lu
Keyword(s):  
Reynolds Number ◽  
Circular Cylinder ◽  
Vortex Shedding ◽  
Rotation Rate ◽  
High Speed ◽  
Three Dimensional ◽  
Flow Regimes ◽  
Reynolds Numbers ◽  
Wake Flow ◽  
Rotating Circular Cylinder

Flow around a high-speed rotating circular cylinder for $Re\leqslant 500$ is investigated numerically. The Reynolds number is defined as $UD/\unicode[STIX]{x1D708}$ with $U$, $D$ and $\unicode[STIX]{x1D708}$ being the free-stream flow velocity, the diameter of the cylinder and the kinematic viscosity of the fluid, respectively. The aim of this study is to investigate the effect of a high rotation rate on the wake flow for a range of Reynolds numbers. Simulations are performed for Reynolds numbers of 100, 150, 200, 250 and 500 and a wide range of rotation rates from 1.6 to 6 with an increment of 0.2. Rotation rate is the ratio of the rotational speed of the cylinder surface to the incoming fluid velocity. A systematic study is performed to investigate the effect of rotation rate on the flow transition to different flow regimes. It is found that there is a transition from a two-dimensional vortex shedding mode to no vortex shedding mode when the rotation rate is increased beyond a critical value for Reynolds numbers between 100 and 200. Further increase in rotation rate results in a transition to three-dimensional flow which is characterized by the presence of finger-shaped (FV) vortices that elongate in the wake of the cylinder and very weak ring-shaped vortices (RV) that wrap the surface of the cylinder. The no vortex shedding mode is not observed at Reynolds numbers greater than or equal to 250 since the flow remains three-dimensional. As the rotation rate is increased further, the occurrence frequency and size of the ring-shaped vortices increases and the flow is dominated by RVs. The RVs become bigger in size and the flow becomes chaotic with increasing rotation rate. A detailed analysis of the flow structures shows that the vortices always exist in pairs and the strength of separated shear layers increases with the increase of rotation rate. A map of flow regimes on a plane of Reynolds number and rotation rate is presented.

scholarly journals Strouhal–Reynolds number relationship for flow past a circular cylinder

2017 ◽  
Vol 832 ◽  
pp. 170-188 ◽  
Author(s):  
Hongyi Jiang ◽  
Liang Cheng
Keyword(s):  
Reynolds Number ◽  
Circular Cylinder ◽  
Three Dimensional ◽  
Wake Flow ◽  
Pure Mode ◽  
Laminar Regime ◽  
3D Flow ◽  
Flow Past ◽  
3D Flows ◽  
Mode A

The Strouhal–Reynolds number ($St{-}Re$) relationship for flow past a circular cylinder in the low $Re$ range of $Re\leqslant 1000$ is investigated through two- (2D) and three-dimensional (3D) direct numerical simulations (DNS). An improved method is proposed for the determination of the separating velocity and the wake width to allow for a better estimation of the wake Strouhal number $St^{\ast }$. For $Re$ in the extended laminar regime calculated by 2D DNS, the $St^{\ast }$ values are found to be more uniform than the original $St$ for the 2D flow. It is also found that the $St^{\ast }$ values for the 2D and 3D flows agree well in the laminar regime of $Re$ up to approximately 270. In addition, uniform $St^{\ast }$ values are also obtained for different mode A and mode B flow structures triggered artificially by using different cylinder span lengths in DNS. It is demonstrated that the drop in $St$ (with respect to its 2D counterpart) with the development of different 3D wake structures is due to the decrease in the separating velocity and the increase in the wake width for a 3D flow, rather than the existence of a particular wake structure such as pure mode A or vortex dislocation. However, as the wake flow becomes increasingly turbulent with further increase in $Re$, the $St^{\ast }$ value for the 3D flow increases gradually and deviates from its 2D counterpart, since for turbulent 3D flows the vortex shedding frequency scales on a length smaller than the wake width.

Flow Past a Circular Cylinder: A Comparison Between RANS and Hybrid Turbulence Models for a Low Reynolds Number

2015 ◽  
Author(s):  
Filipe S. Pereira ◽  
Guilherme Vaz ◽  
Luís Eça
Keyword(s):  
Reynolds Number ◽  
Circular Cylinder ◽  
Three Dimensional ◽  
Turbulence Models ◽  
Substantial Improvement ◽  
Computational Domain ◽  
Numerical Predictions ◽  
Flow Past ◽  
Rans Models ◽  
Domain Width

Several offshore applications deal with highly unsteady and detached flows, dominated by three dimensional effects. On such conditions, the usage of scale-resolving simulation (SRS) turbulence models has increased due to the well-known limitations of common RANS models. However, some of these offshore applications, such as flows past cylinders or raisers, present highly complex non-turbulent phenomena which, if not properly resolved, may pollute the outcome of any turbulence model. Therefore, it is crucial to mimic the flow conditions of the problem, the physical settings, and fulfil the numerical requirements of such problems to obtain reliable and accurate predictions. This paper assesses RANS and hybrid turbulence models, focusing on the dependence of the numerical predictions on the physical settings. To this end, the flow past a circular cylinder at a Reynolds number of 3900 is simulated using RANS, DDES and XLES models. The obtained results reveal a large dependence on the grid spatial resolution and physical settings, in particular on the computational domain width and boundary conditions. A substantial improvement of RANS predictions is found when a 3D computational domain is used. As expected, the hybrid models, DDES and XLES, lead to a better agreement with the experiments.

Steady approach of unsteady low-Reynolds-number flow past two rotating circular cylinders

2013 ◽  
Vol 736 ◽  
pp. 414-443 ◽  
Author(s):  
Y. Ueda ◽  
T. Kida ◽  
M. Iguchi
Keyword(s):  
Reynolds Number ◽  
Circular Cylinder ◽  
Stokes Equations ◽  
Low Reynolds Number ◽  
Vortex Method ◽  
The Self ◽  
Circular Cylinders ◽  
Far Field ◽  
Flow Past ◽  
Low Reynolds

AbstractThe long-time viscous flow about two identical rotating circular cylinders in a side-by-side arrangement is investigated using an adaptive numerical scheme based on the vortex method. The Stokes solution of the steady flow about the two-cylinder cluster produces a uniform stream in the far field, which is the so-called Jeffery’s paradox. The present work first addresses the validation of the vortex method for a low-Reynolds-number computation. The unsteady flow past an abruptly started purely rotating circular cylinder is therefore computed and compared with an exact solution to the Navier–Stokes equations. The steady state is then found to be obtained for $t\gg 1$ with ${\mathit{Re}}_{\omega } {r}^{2} \ll t$, where the characteristic length and velocity are respectively normalized with the radius ${a}_{1} $ of the circular cylinder and the circumferential velocity ${\Omega }_{1} {a}_{1} $. Then, the influence of the Reynolds number ${\mathit{Re}}_{\omega } = { a}_{1}^{2} {\Omega }_{1} / \nu $ about the two-cylinder cluster is investigated in the range $0. 125\leqslant {\mathit{Re}}_{\omega } \leqslant 40$. The convection influence forms a pair of circulations (called self-induced closed streamlines) ahead of the cylinders to alter the symmetry of the streamline whereas the low-Reynolds-number computation (${\mathit{Re}}_{\omega } = 0. 125$) reaches the steady regime in a proper inner domain. The self-induced closed streamline is formed at far field due to the boundary condition being zero at infinity. When the two-cylinder cluster is immersed in a uniform flow, which is equivalent to Jeffery’s solution, the streamline behaves like excellent Jeffery’s flow at ${\mathit{Re}}_{\omega } = 1. 25$ (although the drag force is almost zero). On the other hand, the influence of the gap spacing between the cylinders is also investigated and it is shown that there are two kinds of flow regimes including Jeffery’s flow. At a proper distance from the cylinders, the self-induced far-field velocity, which is almost equivalent to Jeffery’s solution, is successfully observed in a two-cylinder arrangement.

The flow past a rapidly rotating circular cylinder

1957 ◽  
Vol 242 (1228) ◽  
pp. 108-115 ◽  
Keyword(s):  
Boundary Layer ◽  
Circular Cylinder ◽  
Present Theory ◽  
Stream Velocity ◽  
Two Dimensional ◽  
Rotating Circular Cylinder ◽  
Flow Past ◽  
Separating Flow ◽  
Two Dimensional Flow ◽  
Uniform Stream

This paper considers the two-dimensional flow past a circular cylinder immersed in a uniform stream, when the cylinder rotates about its axis so fast that separation in suppressed. The solution of the flow in the boundary layer on the cylinder is obtained in the form of a power series in the ratio of the stream velocity to the cylinder's peripheral velocity, and expressions are deduced for the value of the circulation and the torque on the cylinder. The terms calculated explicitly are sufficient to give reliable numerical values over the whole range of rotational speeds for which the postulate of non-separating flow is justifiable. The previously accepted theory, due to Prandtl, predicted that the circulation should not exceed a certain limit, while the present theory indicates that the circulation increases indefinitely with increase of rotaional speed. Strong arguments against the older theory are put forward, but the experimental evidence available is inconclusive.

Detailed Investigation of Detached-Eddy Simulation for the Flow Past a Circular Cylinder at Re=3900

2012 ◽  
Vol 232 ◽  
pp. 471-476 ◽  
Author(s):  
Rui Zhao ◽  
Chao Yan
Keyword(s):  
Reynolds Number ◽  
Circular Cylinder ◽  
Flow Structures ◽  
Detached Eddy Simulation ◽  
Eddy Simulation ◽  
Flow Past ◽  
Large Eddy ◽  
Mesh Resolution ◽  
Physical Phenomena

The flow past a circular cylinder at a subcritical Reynolds number 3900 was simulated by the method of detached-eddy simulation (DES). The objective of this present work is not to investigate the physical phenomena of the flow but to study modeling as well as numerical aspects which influence the quality of DES solutions in detail. Firstly, four typical spanwise lengths are chosen and the results are systematically compared. The trend of DES results along the span increment is different from previous large-eddy simulation (LES) investigation. A wider spanwise length does not necessary improve the results. Then, the influence of mesh resolution is studied and found that both too coarse and over refined grids will deteriorate the performance of DES. Finally, different orders of numerical schemes are applied in the inviscid fluxes and the viscous terms. The discrepancies among different schemes are found tiny. However, the instantaneous flow structures produced by 5th order WENO with 4th order central differencing scheme are more abundant than the others. That is, for the time-averaged quantities, the second-order accurate schemes are effective enough, whereas the higher-order accurate methods are needed to resolve the transient characteristics of the flow.

Sign in / Sign up

Export Citation Format

Share Document