Effects of Seed Treatment and Foliar Spray Applications of Gibbberellic Acid on Grain Sorghum 1

1961 ◽  
Vol 53 (3) ◽  
pp. 137-139
Author(s):  
A. W. Pauli ◽  
F. C. Stickler
2013 ◽  
Vol 38 (1) ◽  
pp. 61-70 ◽  
Author(s):  
SMA Hossain ◽  
MA Baque ◽  
MR Amin

The Imidacloprid insecticide, Gaucho 70 WS at 1.5, 2.5, 3.5, 4.5 and 5.5 g/kg seed was used as seed treatment and monocrotophos 40 WSC at 1120 ml/ha was applied as foliar spray on CB9 cotton cultivar to suppress aphid, whitefly and thrips, and impact on their natural enemies during 2008-2011 at the Regional Cotton Research Station, Dinajpur, Bangladesh. The activity of natural enemies, such as ladybird beetle, lacewing, syrphid, and spider population on the sucking pests attacking cotton cultivar CB9 and yield of cotton were recorded. Imidacloprid significantly reduced aphid, whitefly, and thrips population on cotton crops compared to untreated control or foliar spray of monocrotophos 40 WSC at 1120 ml/ha. Ladybird beetles, lacewings, syrphids, and spiders were abundant in the field but their population decreased in the treated plots compared to untreated control. The CB9 cotton cultivar produced significantly higher yield (1.73 t/ha) with a benefit cost ratio 12.47 when seeds were treated with Imidacloprid at 5.5 g/kg fuzzy seed. This study indicated that Imidacloprid (Gaucho 70 WS) used as a seed treatment may be suggested to the cotton growers for controlling sucking pests. Bangladesh J. Agril. Res. 38(1): 61-70, March 2013 DOI: http://dx.doi.org/10.3329/bjar.v38i1.15190


1970 ◽  
Vol 34 (3) ◽  
pp. 425-434 ◽  
Author(s):  
PK Malaker ◽  
IH Mian

The efficacy of seed treatment and foliar spray with fungicides in controlling black point incidence of wheat seeds was evaluated in the field. Two seed treating fungicides, namely Vitavax-200 and Homai-80WP were used @ 0.25% of dry seed weight and foliar spray with Tilt-250EC (0.05%) was applied in six different schedules. Untreated and unsprayed controls were also maintained. Seed treatment with either Vitavax-200 or Homai-80WP significantly increased plant population and grain yield, but none of them was found effective in reducing black point incidence. On the other hand, foliar sprays with Tilt-250EC under all the spray schedules except spraying at 70 and 90 DAS significantly minimized the disease severity over unsprayed control. Among the different spray schedules, spraying at 30, 40, 50, 60, 70, 80, and 90 DAS appeared to be most effective, which was similar to spraying at 30, 45, 60, 75, and 90 DAS in reducing black point incidence and increasing grain yield. Economic analysis on yield advantage showed that the highest additional gross margin of Tk. 6120/ha with BCR 2.57 was obtained from five sprays applied at 30, 45, 60, 75, and 90 DAS. Key Words: Seed treatment, foliar spray, black point, wheat. DOI: 10.3329/bjar.v34i3.3968 Bangladesh J. Agril. Res. 34(3) : 425-434, September 2009


2019 ◽  
Vol 47 (5) ◽  
pp. 723-731 ◽  
Author(s):  
Ashlesha Atri ◽  
U. S. Tiwana

Plant Disease ◽  
2020 ◽  
Vol 104 (3) ◽  
pp. 610-623 ◽  
Author(s):  
Jay Ram Lamichhane ◽  
Ming Pei You ◽  
Véronique Laudinot ◽  
Martin J. Barbetti ◽  
Jean-Noël Aubertot

The use of fungicide seed treatment (FST) is a very common practice worldwide. The purported effectiveness of many fungicides in providing broad-spectrum and systemic control of important diseases and the perception that FST reduces overall pesticide use, hence lowering environmental impacts, have greatly promoted the use of FST in the last five decades. Since there have been rapid advancements in the types, formulations, and application methods for seed treatments, there is a need to re-evaluate the benefits versus the risks of FST as a practice. While the use of seeds treated with neonicotinoid insecticides has come under scrutiny due to concern over potential nontarget effects, there are knowledge gaps on potential negative impacts of FST on operators’ (those who apply, handle, and use treated seeds) health and nontarget soil organisms (both macro- and microorganisms). Here we review existing knowledge on key fungicides used for seed treatments, benefits and risks related to FST, and propose recommendations to increase benefits and limit risks related to the use of FST. We found FST is applied to almost 100% of sown seeds for the most important arable crops worldwide. Fungicides belonging to 10 chemical families and with one or several types of mobility (contact, locally systemic, and xylem mobile) are used for seed treatment, although the majority are xylem mobile. Seed treatments are applied by the seed distributor, the seed company, and the farmer, although the proportion of seed lots treated by these three groups vary from one crop to another. The average quantity of fungicide active ingredient (a.i.) applied via seed treatment depends on the crop species, environment(s) into which seed is planted, and regional or local regulations. Cost-effectiveness, protection of the seed and seedlings from pathogens up to 4–5 weeks from sowing, user friendliness, and lower impact on human health and nontarget soil organisms compared with foliar spray and broadcast application techniques, are among the most claimed benefits attributed to FST. In contrast, inconsistent economic benefits, development of resistance by soilborne pathogens to many fungicides, exposure risks to operators, and negative impacts on nontarget soil organisms are the key identified risks related to FST. We propose eight recommendations to reduce risks related to FST and to increase their benefits.


1984 ◽  
Vol 8 (1) ◽  
pp. 51-54
Author(s):  
S. J. Rowan

Abstract Bayleton foliar sprays eradicated all fusiform rust infections when applied up to 7 days after artificial inoculation and eradicated a significant number of infections when applied 28 days after inoculation. A combination of seed treatment and foliar spray provided complete control when the spray was applied up to 14 days after inoculation and further reduced disease incidence when the foliar spray was applied 28 days after inoculation. Foliar sprays applied before inoculation prevented infections up to four weeks after application but sprays applied to nongerminated seed did not prevent infections in seedlings originating from these seed. Seed treatment would, therefore, significantly improve fusiform rust control in forest nurseries. Without seed treatment, applications of both ferbam and Bayleton during the period of seed germination may be necessary to adequately control the disease in high rust-hazard nurseries. When seed are treated with Bayleton, the first foliar spray must be applied 14 days after germination begins or no later than 7 days after the first infection period following the first 14 days of seed germination. Thereafter, sprays should be applied at intervals not to exceed 35 days.


2002 ◽  
Vol 37 (4) ◽  
pp. 308-316 ◽  
Author(s):  
J. C. Faircloth ◽  
J. R. Bradley ◽  
J. W. Van Duyn

Field experiments were conducted in 1997–1999 in Washington Co., NC, to examine how cotton, Gossypium hirsutum, is affected by thrips species composition and abundance, environmental factors, and insecticide applications. Populations of adult and juvenile thrips were monitored in seedling cotton treated with insecticide applications of either imidacloprid as a seed treatment, acephate as a foliar spray, or aldicarb applied in-furrow. The number of plants per 3.05 row-m, location of the first fruiting branch, number of open bolls per 1.52 row-m, yields, accumulated degree-d 60′s (DD60′s), and accumulated rainfall were recorded each year the studies were conducted. Aldicarb and acephate provided better thrips control than did imidacloprid in all 3 yrs. Thrips species ratios differed among years. In 1997, the aldicarb treatment resulted in a better “earliness profile” (lower fruit set and more early opening bolls) than either acephate or imidacloprid, while in 1998 and 1999 there were few differences in these plant parameters. In 1997, all insecticide treatments resulted in statistically higher yields compared with the untreated check. Accumulated DD60′s were consistently higher in 1998 and 1999 than in 1997 after the first thrips sampling date. Cumulative rainfall appeared to be inversely associated with juvenile thrips populations.


Plant Disease ◽  
2001 ◽  
Vol 85 (7) ◽  
pp. 780-784 ◽  
Author(s):  
M. A. Davis ◽  
W. W. Bockus

Pythium spp. have been reported to reduce stands and cause stalk rot of grain sorghum. Evidence is presented that it also can cause a serious seed and root rot in the field under a continuous grain sorghum production system. Experiments were conducted for 4 years in a field that had been cropped continuously to grain sorghum for at least 10 years. Effects of seed treatments with captan and metalaxyl on plant stands, early to mid-season plant vigor, and grain yields were evaluated. In five field experiments, seed treatment with metalaxyl (73 g a.i./100 kg) increased grain yields by an average of 24.0% compared with nontreated seed. In three out of four field experiments, seed treatment with metalaxyl increased grain yields by an average of 13.1% above seed treated with captan (73 g a.i./100 kg). The yield increases could not always be explained in terms of differences among treatments in plant stands or in visual estimates of the amount of top growth 26 to 72 days after sowing. Apparently, the Pythium sp. causes a chronic root and seed rot that has a significant negative effect on grain production without necessarily affecting stands or early to mid-season growth. P. ultimum var. ultimum was the fungus most commonly isolated from roots and seeds collected from the field. Tests for Koch's postulates conducted in a greenhouse verified it as the causal organism. In the greenhouse, treatment with metalaxyl protected seeds and roots from attack by P. ultimum var. ultimum for at least 28 days after planting.


1995 ◽  
Vol 75 (3) ◽  
pp. 287-291 ◽  
Author(s):  
J. A. MacLeod ◽  
Umesh C. Gupta

This study was conducted in Prince Edward Island (PEI), Canada, to determine the effect selenium (Se) treated seed on Se concentrations in soybean seed (Glycine max). Seed Se concentrations were also compared to those obtained with foliar applied Se. An application of 10 g Se ha−1 as seed treatment raised soybean Se concentrations to more than 0.5 mg kg−1. Soybeans with these Se concentrations, when included in rations at 200 kg t−1 with other low Se ingredients, would produce rations exceeding 0.1 mg Se kg−1, i.e., the minimum level required to prevent Se deficiency in livestock. Seed treatment with 100 g Se ha−1 produced soybean Se concentrations greater than 10 mg Se kg−1. When included in rations at 200 kg t−1 with other low Se feed sources, soybeans with such Se levels would produce rations in excess of the maximum tolerable dietary concentration of 2 mg Se kg−1 dry matter. Even higher soybean Se concentrations were obtained from equivalent Se rates when applied as foliar spray. In summary, treatment of soybean seed with Se has a potential for improving the Se status of rations that would be formulated with ingredients originating from Se deficient areas. Key words: Foliar applied Se, seed Se, sandy loam, Eastern Canada


Sign in / Sign up

Export Citation Format

Share Document