Differences in nitrification potential between fully aerobic and nitrogen removal activated sludge systems

2002 ◽  
Vol 46 (1-2) ◽  
pp. 297-304
Author(s):  
G.J. Hatziconstantinou ◽  
A. Andreadakis
Keyword(s):  
Activated Sludge ◽  
Decay Rate ◽  
Nitrogen Removal ◽  
Nitrogen Loss ◽  
Performance Evaluations ◽  
Available Nitrogen ◽  
Nitrification Potential ◽  
Autotrophic Biomass ◽  
Heterotrophic Biomass ◽  
Activated Sludge Systems

Experimental observations made on two pilot plants, showed that nitrogen removal activated sludge systems, operating under favourable conditions, seem to develop increased nitrification potential compared to fully aerobic systems under similar conditions. This increased potential, which cannot be detected by simple nitrification performance evaluations, is attributed to higher autotrophic populations sustained – developed in similar systems employing anoxic reactors or phases. A reduced autotrophic decay rate under anoxic conditions as reported by some researchers, seems to play a significant role in such a response, most likely together with a more efficient use of available nitrogen for additional nitrifying microorganisms production, resulting from a reduced nitrogen loss to autotrophic biomass maintenance needs and heterotrophic biomass synthesis requirements.

Retrofitting activated sludge systems to intermittent aeration for nitrogen removal

2002 ◽  
Vol 46 (8) ◽  
pp. 75-82 ◽  
Author(s):  
O. Hanhan ◽  
N. Artan ◽  
D. Orhon
Keyword(s):  
Activated Sludge ◽  
Nitrogen Removal ◽  
Design Procedure ◽  
Intermittent Aeration ◽  
System Operation ◽  
Conceptual Approach ◽  
Available Nitrogen ◽  
Model Simulations ◽  
Activated Sludge Systems

The paper provides the basis and the conceptual approach of applying process kinetics and modelling to the design of alternating activated sludge systems for retrofitting existing activated sludge plants to intermittent aeration for nitrogen removal. It shows the significant role of the two specific parameters, namely, the aerated fraction and the cycle time ratio on process performance through model simulations and proposes a way to incorporate them into a design procedure using process stoichiometry and mass balance. It illustrates the effect of these parameters, together with the sludge age, in establishing the balance between the denitrification potential and the available nitrogen created in the anoxic/aerobic sequences of system operation.

Excess nitrogen accumulation in activated sludge in sequencing batch reactor with a single-stage oxic process

2009 ◽  
Vol 59 (3) ◽  
pp. 573-582 ◽  
Author(s):  
Xiao-ming Li ◽  
Dong-bo Wang ◽  
Qi Yang ◽  
Wei Zheng ◽  
Jian-bin Cao ◽  
...  
Keyword(s):  
Activated Sludge ◽  
Nitrogen Removal ◽  
Sequencing Batch Reactor ◽  
Ph Value ◽  
Batch Reactor ◽  
Nitrogen Loss ◽  
Single Stage ◽  
Synthetic Wastewater ◽  
Nitrogen Accumulation ◽  
Excess Nitrogen

It was occasionally found that a significant nitrogen loss in solution under neutral pH value in a sequencing batch reactor with a single-stage oxic process using synthetic wastewater, and then further studies were to verify the phenomenon of nitrogen loss and to investigate the pathway of nitrogen removal. The result showed that good performance of nitrogen removal was obtained in system. 0–7.28 mg L−1 ammonia, 0.08–0.38 mg L−1 nitrite and 0.94–2.12 mg L−1 nitrate were determined in effluent, respectively, when 29.85–35.65 mg L−1 ammonia was feeding as the sole nitrogen source in influent. Furthermore, a substantial nitrogen loss in solution (95% of nitrogen influent) coupled with a little gaseous nitrogen increase in off-gas (7% of nitrogen influent) was determined during a typical aerobic phase. In addition, about 322 mg nitrogen accumulation (84% of nitrogen influent) was detected in activated sludge. Based on nitrogen mass balance calculation, the unaccounted nitrogen fraction and the ratio of nitrogen accumulation in sludge/nitrogen loss in solution were 14.6 mg (3.7% of nitrogen influent) and 0.89, respectively. The facts indicated that the essential pathway of nitrogen loss in solution in this study was excess nitrogen accumulation in activated sludge.

Nitrogen removal in activated sludge systems including denitrification in secondary clarifiers

1994 ◽  
Vol 30 (6) ◽  
pp. 101-111 ◽  
Author(s):  
H. Siegrist ◽  
W. Gujer
Keyword(s):  
Activated Sludge ◽  
Nitrogen Removal ◽  
Retention Time ◽  
Secondary Clarifier ◽  
Solids Retention Time ◽  
Solids Retention ◽  
Activated Sludge Systems

Denitrification in the secondary clarifier can contribute substantially to the nitrogen removal of activated sludge systems. This is illustrated on two treatment plants with different secondary clarifier systems. A model to estimate denitrification capacity and to design activated sludge systems for nitrogen removal is developed and verified with data from two treatment plants. The model includes denitrification in the secondary clarifier, wastewater composition (soluble readily biodegradable COD, particulate degradable COD), oxygen input into the anoxic volume, temperature, and solids retention time (SRT). The influence of aerated grit chambers and primary sedimentation on denitrification is discussed.

scholarly journals Maximum growth and decay rates of autotrophic biomass to simulate nitrogen removal at 10°C with municipal activated sludge plants

Water SA ◽  
2018 ◽  
Vol 34 (1) ◽  
pp. 71 ◽  
Author(s):  
J-M Choubert ◽  
A Marquot ◽  
A-E Stricker ◽  
S Gillot ◽  
Y Racault ◽  
...  
Keyword(s):  
Activated Sludge ◽  
Nitrogen Removal ◽  
Maximum Growth ◽  
Decay Rates ◽  
Autotrophic Biomass

Understanding the contribution of biofilm in an integrated fixed-film-activated sludge system (IFAS) designed for nitrogen removal

2015 ◽  
Vol 71 (10) ◽  
pp. 1500-1506 ◽  
Author(s):  
P. Moretti ◽  
J. M. Choubert ◽  
J. P. Canler ◽  
O. Petrimaux ◽  
P. Buffiere ◽  
...  
Keyword(s):  
Activated Sludge ◽  
Nitrogen Removal ◽  
Loading Rate ◽  
Pilot Scale ◽  
Operating Conditions ◽  
Biofilm Growth ◽  
Operational Conditions ◽  
Solids Concentration ◽  
Fixed Film ◽  
Autotrophic Biomass

The objective of this study is to improve knowledge on the integrated fixed-film-activated sludge (IFAS) system designed for nitrogen removal. Biofilm growth and its contribution to nitrification were monitored under various operating conditions in a semi-industrial pilot-scale plant. Nitrification rates were observed in biofilms developed on free-floating media and in activated sludge operated under a low sludge retention time (4 days) and at an ammonia loading rate of 45–70 gNH4-N/kgMLVSS/d. Operational conditions, i.e. oxygen concentration, redox potential, suspended solids concentration, ammonium and nitrates, were monitored continuously in the reactors. High removal efficiencies were observed for carbon and ammonium at high-loading rate. The contribution of biofilm to nitrification was determined as 40–70% of total NOx-N production under the operating conditions tested. Optimal conditions to optimize process compacity were determined. The tested configuration responds especially well to winter and summer nitrification conditions. These results help provide a deeper understanding of how autotrophic biomass evolves through environmental and operational conditions in IFAS systems.

Sign in / Sign up

Export Citation Format

Share Document