scholarly journals Поверхностное дефектообразование в CdTe при воздействии излучения CO-=SUB=-2-=/SUB=--лазера

2018 ◽  
Vol 52 (9) ◽  
pp. 986
Author(s):  
П.С. Шкумбатюк
Keyword(s):  
Continuous Radiation ◽  
Cdte Surface

AbstractThe effect of the continuous radiation of a CO_2 laser on a cleaved (110) CdTe surface is investigated. It is shown based on an analysis of the morphology of the irradiating and irradiated surface that the formation of observed defects is caused by the evaporation of CdTe in the dislocation region.

Variation of the amount of hydrogen along the galactic ridge

1967 ◽  
Vol 31 ◽  
pp. 171-172
Author(s):  
Th. Schmidt-Kaler
Keyword(s):  
Surface Brightness ◽  
Milky Way ◽  
Neutral Hydrogen ◽  
Line Of Sight ◽  
Optical Surface ◽  
Hydrogen Density ◽  
Continuous Radiation ◽  
Galactic Longitude

The integralNHof neutral-hydrogen density along the line of sight is determined from the Kootwijk and Sydney surveys. The run ofNHwith galactic longitude agrees well with that of thermal continuous radiation and that of the optical surface brightness of the Milky Way.

Nanosecond laser-induced breakdown assisted by femtosecond laser pre-ionization in air: the effect on spatial resolution and continuous radiation

2020 ◽  
Vol 92 (2) ◽  
pp. 20701
Author(s):  
Bo Li ◽  
Xiaofeng Li ◽  
Zhifeng Zhu ◽  
Qiang Gao
Keyword(s):  
Femtosecond Laser ◽  
Spatial Resolution ◽  
Laser Induced Breakdown Spectroscopy ◽  
Nanosecond Laser ◽  
Breakdown Threshold ◽  
Powerful Technique ◽  
Breakdown Spectroscopy ◽  
Continuous Radiation ◽  
Laser Induced Breakdown

Laser-induced breakdown spectroscopy (LIBS) is a powerful technique for quantitative diagnostics of gases. The spatial resolution of LIBS, however, is limited by the volume of plasma. Here femtosecond-nanosecond dual-pulsed LIBS was demonstrated. Using this method, the breakdown threshold was reduced by 80%, and decay of continuous radiation was shortened. In addition, the volume of the plasma was shrunk by 85% and hence, the spatial resolution of LIBS was significantly improved.

Determination of the profile of the temperature field of material heated by continuous laser radiation

2020 ◽  
pp. 51-10
Author(s):  
B.A. Lapshinov ◽  
◽  
N.I. Timchenko ◽  
Keyword(s):  
Temperature Field ◽  
Optical Fiber ◽  
Prolonged Exposure ◽  
Radiation Spectrum ◽  
Visible Range ◽  
Continuous Laser ◽  
Surface Temperature Distribution ◽  
Continuous Radiation ◽  
Spectral Pyrometry

Spectral pyrometry was used to determine the surface temperature distribution of Si, Nb, Cu, and graphite samples when they were locally heated by continuous radiation of an Nd:YAG laser (λ = 1.064 μm). With prolonged exposure to radiation, a stationary temperature field was established in the samples. The thermal spectra were recorded with a small spectrometer in the visible range in the temperature range above 850 K. The optical fiber used to transmit the radiation spectrum to the spectrometer had an additional diaphragm with a diameter of 1 mm located at a certain distance from the fiber end, which ensured the locality of the recorded spectra. The optical fiber moved continuously along the sample, and the spectrometer recorded up to 100 spectra with a frequency of 5-10 Hz. The temperature profile of the samples was calculated based on the results of processing the spectra using the Spectral Pyrometry program.

Double Crystal X‐Ray Dilatometer Using Continuous Radiation

1971 ◽  
Vol 42 (2) ◽  
pp. 196-199 ◽  
Author(s):  
Virgil E. Bottom ◽  
Renê Ayres Carvalho
Keyword(s):  
Double Crystal ◽  
X Ray ◽  
Continuous Radiation

Effect of passivation of the p-CdTe surface in (NH4)2Sx on the current-voltage characteristics of contacts

2006 ◽  
Vol 40 (9) ◽  
pp. 1048-1051 ◽  
Author(s):  
Yu. V. Klevkov ◽  
S. A. Kolosov ◽  
A. F. Plotnikov
Keyword(s):  
Current Voltage ◽  
Current Voltage Characteristics ◽  
Cdte Surface

Surface Composition Changes and Ablation Dynamics in Excimer Laser Irradiated CdTe

1990 ◽  
Vol 191 ◽  
Author(s):  
P. D. Brewer ◽  
J. J. Zinck ◽  
G. L. Olson
Keyword(s):  
Laser Ablation ◽  
Excimer Laser ◽  
Surface Composition ◽  
Laser Ablation Process ◽  
Flight Mass Spectrometry ◽  
Rich Condition ◽  
Thermal Mechanism ◽  
Krf Excimer Laser ◽  
Composition Changes ◽  
Cdte Surface

ABSTRACTWe have investigated the dynamics of KrF excimer laser ablation of CdTe and the fluence dependent changes in surface stoichiometry that accompany the laser ablation process. The composition of the CdTe surface was reversibly controlled between stoichiometric and a Te-rich condition by varying the laser fluence over the range from 15–65 mJ/cm2. The primary species ejected from the irradiated surface were Cd atoms and Te2 molecules. Their velocity distributions as measured by time-of-flight mass spectrometry were found to be Maxwellian. From the analysis of the velocity distributions, the preferential desorption of surface atoms, and the reversible nature of the process, we conclude that the desorption is due to a photo-thermal mechanism which mediates the competition between Te2 formation and desorption and the desorption of Cd atoms.

Continuous radiation of excimer complexes in argon and neon crystals

1998 ◽  
Vol 24 (6) ◽  
pp. 440-451 ◽  
Author(s):  
A. G. Belov ◽  
I. Ya. Fugol’ ◽  
E. M. Yurtaeva
Keyword(s):  
Continuous Radiation
Sign in / Sign up

Export Citation Format

Share Document