scholarly journals Mechanical behavior and corrosion properties of some AA6xxx aluminum alloys in T5 temper

2006 ◽  
Vol 12 (4) ◽  
pp. 231-235
Author(s):  
Kemal Delijic ◽  
Vanja Asanovic ◽  
Dragan Radonjic
Keyword(s):  
Tensile Strength ◽  
Aluminum Alloys ◽  
Chloride Solution ◽  
Sodium Chloride Solution ◽  
Continuous Cast ◽  
Corrosion Properties ◽  
Aqueous Sodium Chloride Solution ◽  
Aqueous Sodium ◽  
The Press ◽  
Mechanical And Corrosion Properties

The paper describes the mechanical and corrosion properties of three heat treatable extruded Al-Mg-Si aluminum alloys. The alloys were tested as T5 tempered (air-quenched directly on the press and artificially aged) after processing by the extrusion of semi-continuous cast and homogenized billets. The addition of small amounts of zirconium and manganese in the base AIMgSiO.7 alloy increased the strength, reaching 310 MPa of tensile strength and increased the corrosion rate by 15% in aqueous sodium chloride solution.

DETERMINATION OF TRACE AMOUNTS OF SILVER IN GALENA ORES

1960 ◽  
Vol 38 (9) ◽  
pp. 1488-1494 ◽  
Author(s):  
E. J. Bounsall ◽  
W. A. E. McBryde
Keyword(s):  
Aqueous Solution ◽  
Nitric Acid ◽  
Sodium Chloride ◽  
Hydrochloric Acid ◽  
Chloride Solution ◽  
Sodium Chloride Solution ◽  
Silver Content ◽  
Aqueous Sodium Chloride Solution ◽  
Aqueous Sodium

An analytical method is described for the determination of microgram amounts of silver in galena ores, based on the "reversion" of silver dithizonate. Silver is separated from relatively large amounts of lead by extraction as dithizonate into chloroform from an aqueous 1:99 nitric acid solution. Separation from mercury, which is also extracted under these conditions and would, if present, interfere in the analysis, is achieved by reverting the dithizonate solution with a 5% aqueous sodium chloride solution which is also 0.015 molar in hydrochloric acid. Following dilution of this aqueous solution and adjustment of pH, silver is again extracted into chloroform as the dithizonate, and determined absorptiometrically. Analyses of a number of galena ore samples showed a precision of within 3% for a silver content ranging from 0.03 to 0.4%.Some other methods for isolating silver from these samples, which were tried but found unsatisfactory, are discussed.

Sign in / Sign up

Export Citation Format

Share Document