Leaf Water and Stomatal Movement in Gossypium and a Method of Direct Visual Observation of Stomata in Situ

1913 ◽  
Vol 40 (1) ◽  
pp. 1 ◽  
Author(s):  
Francis E. Lloyd

1968 ◽  
Vol 32 (4) ◽  
pp. 468-470 ◽  
Author(s):  
S. L. Rawlins ◽  
W. R. Gardner ◽  
F. N. Dalton


2008 ◽  
Vol 38 (7) ◽  
pp. 1997-2003 ◽  
Author(s):  
Victor Fernando Büttow Roll ◽  
Gustavo Adolfo Maria Levrino ◽  
Ricardo Cepero Briz

The influences of floor and cage-rearing on behavioural adaptation to furnished cages were investigated in laying hens. Two groups of 180 Isa Brown commercial layer pullets were reared in cages (CR) or floor pens (FR) and transferred to furnished cages, where their behavioural adaptation was observed throughout the laying period (18-78 wks of age). At 17 weeks of age, hens were placed in one of the 36 furnished cages with 10 birds in each cage, each containing a nest box, perches, a dust bath, and abrasive strips. At 50 and 54 weeks of age, direct visual observation and video recording were used to assess hen’s behaviour. From 21 weeks of age, the dust-bath activities of leg-banded hens in eight cages per treatment were recorded. The amount of time spent walking was higher (3.5% vs. 1.8%) and perching was lower (7.5% vs. 13.4%) in CR hens than in FR hens (P<0.05). The use of dust baths and dust bathing behaviour increased throughout the laying period. The proportion of hens present at the sand bath area increased from 9.2% at 21 weeks to 21.4% at 72 weeks and the proportion of hens dust bathing increased from 4.7% to 21.0% (P<0.05). At 72 weeks of age, all dust-bath parameters were higher (P<0.05) in FR hens than in CR hens.





CORROSION ◽  
10.5006/3110 ◽  
2019 ◽  
Vol 75 (11) ◽  
pp. 1307-1314
Author(s):  
Bjørn H. Morland ◽  
Morten Tjelta ◽  
Arne Dugstad ◽  
Gaute Svenningsen

There are several proposed specifications for CO2 transport regarding how much impurities that can be allowed in the CO2 stream. Many of these specifications are based on health, safety, and environment (HSE) considerations in case of accidental spill, and only limited focus has been on the pipeline integrity. Previous work has demonstrated that many of the impurities that are expected to be present in CO2 captured from flue gasses may react and form corrosive species. The present paper studied impurity reactions and corrosion under simulated transport conditions (25°C and 10 MPa of CO2). An experiment was performed in a transparent autoclave which allowed for in situ visual observation. Chemical reactions between the impurities were observed even at very low concentrations (<100 ppmv). These reactions contributed to the production of nitric and sulfuric acid together with formation of elemental sulfur. Corrosion was observed on coupons of carbon steel, but not on stainless steels. The corrosion rate of carbon steel was low, but the amount of acids and solids (corrosion products) produced cannot be accepted from a pipeline integrity perspective. Further experimental studies are needed to determine specific limits for impurity concentrations in captured CO2 for transport.



1974 ◽  
Vol 66 (1) ◽  
pp. 24-27 ◽  
Author(s):  
Gaylon S. Campbell ◽  
Melvin D. Campbell


1978 ◽  
Vol 56 (13) ◽  
pp. 1537-1539 ◽  
Author(s):  
I. F. Ike ◽  
G. W. Thurtell ◽  
K. R. Stevenson

The relationship between leaf water potential (ψL) and transpiration rate (T) was investigated using indoor-grown cassava plants (Manihot esculenta Crantz cv. Llanera). Leaf water potentials were measured with in situ dew-point hygrometer and transpiration rates by gas exchange analysis technique.Regression analyses of the data showed that T was consistently linearly related to ψL (r2 = 0.94). This implies that the plant resistance to flow was constant and hence that an Ohm's Law analog is valid for the transpiration range studied. Extrapolated values of leaf water potential at zero transpiration were close to the osmotic potential of the nutrient solution. Calculated resistance values (slope of regression line for individual plants) varied between 2.90 and 3.05 bars dm2 h g−1 (1 bar = 100 kPa).



1999 ◽  
Vol 1999 (1) ◽  
pp. 1265-1267 ◽  
Author(s):  
Nir Barnea ◽  
Roger Laferriere

ABSTRACT SMART (Scientific Monitoring of Advanced Response Technologies) is a new monitoring program designed to provide the Unified Command with real-time field data when in situ burning and dispersants are used during oil spill response. For dispersant monitoring, SMART recommends a three-tiered approach. Tier I has visual observation by trained observers from vessels or from aerial platforms. Tier II combines visual observations with water-column sampling using a fluorometer at a single depth. Tier III expands the fluorometry monitoring to several water depths, and uses a water-quality lab. Water samples for later analysis and correlation of fluorometry readings are taken both in Tier II and Tier III. For in situ burning, SMART recommends deploying three or more monitoring teams, each equipped with a real-time particulate monitor with data-logging capability. The teams deploy downwind of the burn at sensitive locations, and report particulate concentration trends to the Unified Command.



Sign in / Sign up

Export Citation Format

Share Document