scholarly journals A case of tooth autotransplantation after long-term cryopreservation using a programmed freezer with a magnetic field

2014 ◽  
Vol 85 (3) ◽  
pp. 518-524 ◽  
Author(s):  
Masato Kaku ◽  
Hiroshi Shimasue ◽  
Junji Ohtani ◽  
Shunichi Kojima ◽  
Hiromi Sumi ◽  
...  

ABSTRACT This case report describes the treatment of a skeletal Class III malocclusion with autotransplantation of a cryopreserved tooth. To gain an esthetic facial profile and good occlusion, extraction of bimaxillary premolars and surgical therapy were chosen. The patient had chronic apical periodontitis on the lower left first molar. Although she did not feel any pain in that region, the tooth was considered to have a poor prognosis. Therefore, we cryopreserved the extracted premolars to prepare for autotransplantation in the lower first molar area because the tooth would probably need to be removed in the future. The teeth were frozen by a programmed freezer with a magnetic field (CAS freezer) that was developed for tissue cryopreservation and were cryopreserved in −150°C deep freezer. After 1.5 years of presurgical orthodontic treatment, bilateral sagittal split ramus osteotomy was performed for mandible setback. Improvement of the facial profile and the occlusion were achieved in the retention phase. Six years after the initial visit, the patient had pain on the lower left first molar, and discharge of pus was observed, so we extracted the lower left first molar and autotransplanted the cryopreserved premolar. Three years later, healthy periodontium was observed at the autotransplanted tooth. This case report suggests that long-term cryopreservation of teeth by a CAS freezer is useful for later autotransplantation, and this can be a viable technique to replace missing teeth.

Author(s):  
Vo Truong Nhu Ngoc ◽  
Nguyen Thi Thu Phuong ◽  
Nguyen Viet Anh

A skeletal Class III malocclusion with open bite tendency is considered very difficult to treat orthodontically without surgery. This case report describes the lingual orthodontic treatment of an adult skeletal Class III patient with mandibular deviation to the left side, lateral open bite, unilateral posterior crossbite, zero overbite and negative overjet. The lower incisors were already retroclined to compensate with the skeletal discrepancy. The patient was treated by asymmetric molar extraction in the mandibular arch to retract the lower incisors and correct the dental midline, with the help of intermaxillary elastics. Lingual appliance was used with over-torqued lower anterior teeth’s brackets to control the torque of mandibular incisors. After a 30-month treatment, satisfactory smile and facial esthetics and good occlusion was achieved. A 12-month follow-up confirmed that the outcome was stable. Asymmetric molar extraction could be a viable option to retract mandibular incisors in Class III malocclusion with lower dental midline deviation.


2021 ◽  
Vol 22 (1) ◽  
Author(s):  
Natalia Tejedor ◽  
Conchita Martín ◽  
José Antonio Alarcón ◽  
María Dolores Oteo-Calatayud ◽  
Juan Carlos Palma-Fernández

Abstract Background Class III malocclusion is associated with high sexual dimorphism, especially in individuals older than 13 years of age, with significant differences in growth between males and females during the pubertal and postpubertal stages, and in adulthood. The aim of this research was to examine differences between males and females in long-term stability (10 years) of treatment for skeletal Class III malocclusion. Methods Thirty patients (15 males and 15 females) with skeletal Class III malocclusion, who had been treated with rapid maxillary expansion (RME) combined with face mask protraction followed by fixed appliances, were selected sequentially. Thirty patients (15 males and 15 females) with skeletal Class I and mesofacial patterns treated only with fixed appliances for dental problems served as the control group. Differences between groups and sexes were evaluated using lateral cephalograms taken at the start of treatment (T0), immediately after the end of treatment (T1), and after 10 years (T2). The long-term treatment success rate was calculated. Results Ten years after Class III treatment, overjet and overbite relapse occurred similarly in females (− 0.68 ± 0.7 mm; − 0.38 ± 0.75 mm, respectively) and males (− 1.09 ± 1.47 mm; − 0.64 ± 0.9 mm, respectively); the ANB angle and Wits appraisal became significantly more negative in males (− 1.37 ± 1.06°; − 2.7 ± 2.53 mm) than in females (− 0.18 ± 1.26°; − 0.46 ± 1.94 mm). The success rate was 73.3% in males and 80% in females. Conclusions Significant differences in the long-term stability of Class III treatment outcomes have been found between males and females, with a larger skeletal Class III relapse and lower long-term success rates in males.


2016 ◽  
Vol 21 (4) ◽  
pp. 89-98 ◽  
Author(s):  
Marcel Marchiori Farret ◽  
Milton M. Benitez Farret ◽  
Alessandro Marchiori Farret

ABSTRACT Introduction: Skeletal Class III malocclusion is often referred for orthodontic treatment combined with orthognathic surgery. However, with the aid of miniplates, some moderate discrepancies become feasible to be treated without surgery. Objective: To report the case of a 24-year-old man with severe skeletal Angle Class III malocclusion with anterior crossbite and a consequent concave facial profile. Methods: The patient refused to undergo orthognathic surgery; therefore, orthodontic camouflage treatment with the aid of miniplates placed on the mandibular arch was proposed. Results: After 18 months of treatment, a Class I molar and canine relationship was achieved, while anterior crossbite was corrected by retraction of mandibular teeth. The consequent decrease in lower lip fullness and increased exposure of maxillary incisors at smiling resulted in a remarkable improvement of patient's facial profile, in addition to an esthetically pleasing smile, respectively. One year later, follow-up revealed good stability of results.


2021 ◽  
Vol 10 (34) ◽  
pp. 2954-2959
Author(s):  
Shilpa Venkatesh Pharande

The Alt-RAMEC protocol was introduced by Liou in the year 2005. It allows for sutural mobilisation by opening and closing the RME screw for 7-9 weeks. Maxillary protraction after the use of Alt-Ramec (alternate rapid maxillary expansion and contraction) protocol is an efficient method for early treatment of skeletal Class III malocclusion. This case report shows the results of using a hyrax bonded maxillary expander with the Alt-RAMEC protocol to treat a maxillary hypoplasia Class III malocclusion. A 12-year-old patient with skeletal class III malocclusion with anterior as well as the unilateral posterior crossbite was treated using this protocol. CBCT scans were taken before and after expansion. These CBCT scans were used for assessing and analysing the skeletal changes that have occurred after using the AltRamec protocol. The objective of this case report is to assess skeletal changes after using the Alt-RAMEC protocol.


2020 ◽  
Vol 54 (2) ◽  
pp. 150-156
Author(s):  
Sanjeev Verma

VG, 25-year-old male, presented with c/c of forwardly placed lower jaw and history of unsatisfactory previous orthodontic treatment. Extraorally, the patient had asymmetrical face and concave profile, competent lips, positive lip step, and chin deviated toward left side by 2 mm. Intraorally, the patient had Angle’s class III type 3 malocclusion with an overjet of (–1) mm, overbite of 0%, and cross-bite wrt 12, 21. The patient was skeletal class III due to macrognathic and prognathic mandible with hypodivergent growth pattern, and proclined upper and retroclined lower incisors. The patient was managed orthosurgically with bimaxillary surgery (maxillary advancement 3 mm + mandibular setback 7 mm) after presurgical decompensation. The case report discusses in detail the diagnosis and comprehensive management of the skeletal class III case.


2014 ◽  
Vol 61 (1) ◽  
pp. 18-20 ◽  
Author(s):  
Kevin Croft ◽  
Stephen Probst

Abstract Deliberate hypotension is an important technique for use in select anesthetics for procedures such as orthognathic surgery, specifically LeFort I maxillary osteotomy. We present a case report of an anesthetic involving deliberate hypotension for a 17-year-old female patient who presented for a LeFort I osteotomy, bilateral sagittal split of the mandible, and a genioplasty in order to correct a skeletal class III malocclusion. After reaching a steady-state general anesthetic, deliberate hypotension was induced solely with a bolus and subsequent continuous infusion of the ultrashort acting calcium channel blocker, clevidipine. The preoperative, intraoperative, and postoperative course and anesthetic management are discussed.


2018 ◽  
Vol 6 (02/03) ◽  
pp. 118-121
Author(s):  
Suruchi Jatol-Tekade ◽  
Satyajit Tekade ◽  
Sachin Sarode ◽  
Vishal Patni ◽  
Vihang Naphde

AbstractTandem appliance is preferred over face mask mainly because of compliance reasons. In the given case report, clinicians have used tandem appliance for correcting skeletal class III malocclusion patient in later stage of growth. Operators utilized residual growth. Facial harmony was achieved by gaining positive overjet. Adolescent class III malocclusion is challenging to treat. Occurrence of class III malocclusion is just 5% in India. If patient reports in growing stage, clinicians get many relevant treatment options. Lack of knowledge about growth modulation therapy causes loss of growing stage of patients. This situation reduces available treatment modalities. Here is a case of female patient with class III malocclusion who is near completion of her growth; maxillary growth was stimulated in forward direction taking anchorage from overgrown mandible with the help of tandem appliance.


Sign in / Sign up

Export Citation Format

Share Document