scholarly journals Influence of Porosity on Grinding Performance of Porous Cast-iron Bonded Diamond Grinding Wheel Made by Pulse Electric Current Sintering Method.

1999 ◽  
Vol 46 (3) ◽  
pp. 257-261 ◽  
Author(s):  
Hisakazu Tomino ◽  
Akira Tsukuda ◽  
Yoshihito Kondo ◽  
Kozo Ishizaki
Keyword(s):  
Cast Iron ◽  
Electric Current ◽  
Grinding Wheel ◽  
Diamond Grinding Wheel ◽  
Pulse Electric Current ◽  
Diamond Grinding ◽  
Grinding Performance ◽  
Pulse Electric ◽  
Sintering Method

Joining of Tungsten-Copper Using Pulse Electric Current Sintering Method

2005 ◽  
Vol 502 ◽  
pp. 443-448
Author(s):  
Yasushi Fukuzawa ◽  
Shigeru Nagasawa ◽  
Masahiro Watanabe ◽  
Shigehiko Takaoka
Keyword(s):  
Heat Treatment ◽  
Electric Current ◽  
Bonding Temperature ◽  
Bonding Pressure ◽  
Pulse Electric Current ◽  
Layer 2 ◽  
Bonding Method ◽  
Pulse Electric ◽  
Sintering Method ◽  
Plating Layer

To develop the new bonding method under low bonding temperature and short holding duration, pulse electric current sintering (PECS) method is applied. The Ni plating layer was used as the interlayer. The following experimental factors were researched:(1) Thickness of Ni plating layer, (2) Bonding temperature, (3) Bonding pressure and (4) Heat treatment after plating. The bonding strength of W-Ni plate-Cu joint could be obtained under low bonding temperature of 773 K and short bonding duration of 10 min.

Sign in / Sign up

Export Citation Format

Share Document