Effect of thermal radiation on transient combustion of a fuel droplet

1993 ◽  
Vol 7 (1) ◽  
pp. 94-100 ◽  
Author(s):  
Takeo Saitoh ◽  
Kouji Yamazaki ◽  
Raymond Viskanta
2005 ◽  
Author(s):  
B. Abramzon ◽  
S. Sazhin

This paper describes an improved, simplified model of convective vaporization of a fuel droplet injected into a hot gas environment, based on the previous publications of the authors (Abramzon and Sazhin, 2005a,b). The model represents a generalization of the so-called “effective conductivity” model developed by Abramzon and Sirignano (1989). In addition to the effects of the Stefan flow (vapor blowing) and internal liquid circulation taken into account in the previous model, the proposed new model includes the effects of thermal radiation absorption and variable physical properties in the liquid phase. The simplified model for thermal radiation absorption suggested by Dombrovsky and Sazhin (2003) is employed for calculation of the heat sources distribution within the droplet. The computations were performed for n-decane and diesel fuel droplets whose spectral absorption data are available in the literature. It was found that, the effect of thermal radiation on the vaporization rate of the diesel fuel is considerably greater than for n-decane, especially in the regions of semi-transparency (λ not close to 3.4 μm). The effect of variable physical properties in the liquid phase is exhibited at the initial stage of the droplet heating when evaporation rate is relatively low and the droplet radius may increase due to the thermal expansion of the liquid. The results obtained using the “effective-conductivity” model with the uniformly distributed internal radiation heat source match very closely the predictions of the “extended vaporization” model with the non-uniform distribution of radiation absorption. The agreement is exceptionally good even for a very coarse finite-difference mesh within the droplet. Therefore, combining the relatively low computational cost and sufficient accuracy, the above “effective-conductivity” model with uniformly-distributed radiation absorption can be employed in sophisticated CFD codes for spray combustion analysis.


Author(s):  
Ahmed M Abdel-Ghanya ◽  
Ibrahim M Al-Helal

Plastic nets are extensively used for shading purposes in arid regions such as in the Arabian Peninsula. Quantifying the convection exchange with shading net and understanding the mechanisms (free, mixed and forced) of convection are essential for analyzing energy exchange with shading nets. Unlike solar and thermal radiation, the convective energy, convective heat transfer coefficient and the nature of convection have never been theoretically estimated or experimentally measured for plastic nets under arid conditions. In this study, the convected heat exchanges with different plastic nets were quantified based on an energy balance applied to the nets under outdoor natural conditions. Therefore, each net was tacked onto a wooden frame, fixed horizontally at 1.5-m height over the floor. The downward and upward solar and thermal radiation fluxes were measured below and above each net on sunny days; also the wind speed over the net, and the net and air temperatures were measured, simultaneously. Nets with different porosities, colors and texture structures were used for the study. The short and long wave’s radiative properties of the nets were pre-determined in previous studies to be used. Re and Gr numbers were determined and used to characterize the convection mechanism over each net. The results showed that forced and mixed convection are the dominant modes existing over the nets during most of the day and night times. The nature of convection over nets depends mainly on the wind speed, net-air temperature difference and texture shape of the net rather than its color and its porosity.


Sign in / Sign up

Export Citation Format

Share Document