Aft Fan Noise Shielding by a Lifting Surface: Analytical, Numerical and Experimental Results

Author(s):  
Johanna Chappuis ◽  
Julien Ricouard ◽  
Michel Roger
1997 ◽  
Vol 34 (3) ◽  
pp. 313-321 ◽  
Author(s):  
Kenneth B. Lazarus ◽  
Edward F. Crawley ◽  
Charrissa Y. Lin

1982 ◽  
Vol 104 (2) ◽  
pp. 162-168 ◽  
Author(s):  
W. Neise ◽  
B. Barsikow

In order to verify experimentally acoustic similarity laws for fans, experiments were made with three, dimensionally similar centrifugal fans of 140, 280, and 560 mm impeller diameter. The fans were connected to anechoically terminated discharge ducts. It is shown that the influence of the Reynolds number on the radiated sound pressure is negligible within 1.4•105 ≦ Re ≦ 2.2•106, which is the range covered by the measurements. This is in agreement with earlier studies in which the Reynolds number was varied from 1.4•104 to 4.5•105. From the experimental results it is concluded that fan noise data that are taken on model fans can be extrapolated to other dimensionally similar fans of different size for arbitrary fan speeds and working fluids, provided that the operating condition and the measurement position are the same.


2006 ◽  
Author(s):  
Rafael Ballesteros-Tajadura ◽  
Sandra Velarde-Sua´rez ◽  
Juan Pablo Hurtado-Cruz ◽  
Bruno Pereiras-Garci´a

Centrifugal fans are widely used in several applications and, in some cases, the noise generated by these machines has become a serious problem. Usually, the centrifugal fan noise is dominated by tones at the blade passage frequency and its higher harmonics. This is a consequence of the strong interaction between the flow discharged from the impeller and the volute tongue. The purpose of this study is to develop a prediction method for the noise generated by a centrifugal fan. A three-dimensional numerical simulation of the complete unsteady flow on the whole impeller-volute configuration has been carried out using the computational fluid dynamics code FLUENT®. The unsteady forces applied by the fan blades to the fluid are obtained from the data provided by the simulation. The Ffowcs Williams and Hawkings model extension of Lighthill’s analogy predicts the aerodynamic noise generated by the centrifugal fan from these unsteady forces. Also, the noise generated by the fan has been measured experimentally, and the experimental results have been compared to the numerical results in order to validate the aerodynamic noise prediction methodology. A good agreement has been found between the numerical and the experimental results.


2021 ◽  
Author(s):  
Stanislav Proskurov ◽  
Michael Moessner ◽  
Roland Ewert ◽  
Markus Lummer ◽  
Jan W. Delfs

2011 ◽  
Vol 129 (4) ◽  
pp. 2584-2584 ◽  
Author(s):  
John K. Boyle ◽  
J. James Esplin ◽  
Scott D. Sommerfeldt ◽  
Kent L. Gee

1975 ◽  
Vol 19 (03) ◽  
pp. 164-165
Author(s):  
A. J. Acosta ◽  
O. Furuya

The three-dimensional or finite-span effect on supercavitating hydrofoils has received much attention in recent years. Among others may be mentioned the work of Tsen and Gullbaud [1], 3 who give the numerical results of their own fully linearized supercavitating lifting-surface theory together with some experimental data, both their own and from other sources. The numerical results are somewhat different from what one might expect based on existing theories, and some of the experimental findings appear to differ from previously published results. The purpose of this brief note is to compare some of the theoretical and experimental results from reference [1] with other recent works both for fully linearized treatments (valid only for vanishing angles of attack), and nonlinear theories and other experimental data that have been used in the past.


Author(s):  
Yuma Fukushima ◽  
Takashi Misaka ◽  
Shigeru Obayashi ◽  
Daisuke Sasaki ◽  
Kazuhiro Nakahashi

Author(s):  
Gil Felix Greco ◽  
Lothar Bertsch ◽  
Tobias P. Ring ◽  
Sabine C. Langer

AbstractThe investigation of technologies that can improve the sustainability of the air transport system requires not only the development of alternative fuel concepts and novel vehicle technologies but also the definition of appropriate assessment strategies. Regarding noise, the assessment should reflect the situation of communities living near airports, i.e., not only addressing sound levels but also accounting for the annoyance caused by aircraft noise. For this purpose, conventional A-weighted sound pressure level metrics provide initial but limited information as the level- and frequency-dependency of the human hearing is accounted for in a simplified manner. Ideally, subjective evaluations are required to adequately quantify the perceived short-term annoyance associated with aircraft noise. However, listening tests are time-consuming and not suitable to be applied during the conceptual aircraft design stage, where a large solution space needs to be explored. Aiming at bridging this gap, this work presents a methodology for the sound quality assessment of computational aircraft noise predictions, which is hereby conducted in terms of objective psychoacoustic metrics. The proposed methodology is applied to a novel medium-range vehicle with fan noise shielding architecture during take-off and landing procedures. The relevance of individual sound sources, i.e., airframe and engine noise contributions, and their dependencies on the aircraft architecture and flight procedures are assessed in terms of loudness, sharpness, and tonality. Moreover, the methodology is steered towards community noise assessment, where the impacts on short-term annoyance brought by the novel aircraft design are analysed. The assessment is based on the modified psychoacoustic annoyance, a metric that provides a quantitative description of human annoyance as a combination of different hearing sensations. The present work is understood as an essential step towards low-annoyance aircraft design.


1988 ◽  
Vol 102 ◽  
pp. 357-360
Author(s):  
J.C. Gauthier ◽  
J.P. Geindre ◽  
P. Monier ◽  
C. Chenais-Popovics ◽  
N. Tragin ◽  
...  

AbstractIn order to achieve a nickel-like X ray laser scheme we need a tool to determine the parameters which characterise the high-Z plasma. The aim of this work is to study gold laser plasmas and to compare experimental results to a collisional-radiative model which describes nickel-like ions. The electronic temperature and density are measured by the emission of an aluminium tracer. They are compared to the predictions of the nickel-like model for pure gold. The results show that the density and temperature can be estimated in a pure gold plasma.


Sign in / Sign up

Export Citation Format

Share Document