scholarly journals MILLIMETER-WAVE TIGHTLY-COUPLED PHASED ARRAY WITH INTEGRATED MEMS PHASE SHIFTERS

2021 ◽  
Vol 110 ◽  
pp. 135-150
Author(s):  
Anas J. Abumunshar ◽  
Kubilay Sertel ◽  
Niru K. Nahar
Author(s):  
Divya Singh ◽  
Aasheesh Shukla

Background : Millimeter wave technology is the emerging technology in wireless communication due to increased demand for data traffic and its numerous advantages however it suffers from severe attenuation. To mitigate this attenuation, phased antenna arrays are used for unidirectional power distribution. An initial access is needed to make a connection between the base station and users in millimeter wave system. The high complexity and cost can be mitigated by the use of hybrid precoding schemes. Hybrid precoding techniques are developed to reduce the complexity, power consumption and cost by using phase shifters in place of converters. The use of phase shifters also increases the spectral efficiency. Objective: Analysis of Optimum Precoding schemes in Millimeter Wave System. Method: In this paper, the suitability of existing hybrid precoding solutions are explored on the basis of the different algorithms and the architecture to increase the average achievable rate. Previous work done in hybrid precoding is also compared on the basis of the resolution of the phase shifter and digital to analog converter. Results: A comparison of the previous work is done on the basis of different parameters like the resolution of phase shifters, digital to analog converter, amount of power consumption and spectral efficiency. Table 2 shows the average achievable rate of different algorithms at SNR= 0 dB and 5 dB. Table 3 also compares the performance achieved by the hybrid precoder in the fully connected structure with two existing approaches, dynamic subarray structure with and without switch and sub connected or partially connected structure. Table 4 gives the comparative analysis of hybrid precoding with the different resolutions of the phase shifter and DAC. Conclusion: In this paper, some available literature is reviewed and summarized about hybrid precoding in millimeter wave communication. Current solutions of hybrid precoding are also reviewed and compared in terms of their efficiency, power consumption, and effectiveness. The limitations of the existing hybrid precoding algorithms are the selection of group and resolution of phase shifters. The mm wave massive MIMO is only feasible due to hybrid precoding.


Author(s):  
Victoria A. Carey ◽  
Matthew R. Konkol ◽  
Shouyuan Shi ◽  
Andrew J. Mercante ◽  
Kevin Shreve ◽  
...  

Author(s):  
Xiaoxiong Gu ◽  
Duixian Liu ◽  
Yuta Hasegawa ◽  
Koichiro Masuko ◽  
Christian Baks ◽  
...  

Author(s):  
Aparna B. Barbadekar ◽  
Pradeep M. Patil

Abstract The paper proposes a system consisting of novel programmable system on chip (PSoC)-controlled phase shifters which in turn guides the beam of an antenna array attached to it. Four antennae forming an array receive individual inputs from the programmable phase shifters (IC 2484). The input to the PSoC-based phase shifter is provided from an optimized 1:4 Wilkinson power divider. The antenna consists of an inverted L-shaped dipole on the front and two mirrored inverted L-shaped dipoles mounted on a rectangular conductive structure on the back which resonates in the ISM/Wi-Fi band (2.40–2.48 GHz). The power divider is designed to provide the feed to the phase shifter using a beamforming network while ensuring good isolation among the ports. The power divider has measured S11, S21, S31, S41, and S51 to be −14, −6.25, −6.31, −6.28, and −6.31 dB, respectively at a frequency of 2.45 GHz. The ingenious controller is designed in-house using a PSoC microcontroller to regulate the control voltage of individual phase shifter IC and generate progressive phase shifts. To validate the calibration of the in-house designed control circuit, the phased array is simulated using $s_p^2$ touchstone file of IC 2484. This designed control circuit exhibits low insertion loss close to −8.5 dB, voltage standing wave ratio of 1.58:1, and reflection coefficient (S11) is −14.36 dB at 2.45 GHz. Low insertion loss variations confirm that the phased-array antenna gives equal amplitude and phase. The beamforming radiation patterns for different scan angles (30, 60, and 90°) for experimental and simulated phased-array antenna are matched accurately showing the accuracy of the control circuit designed. The average experimental and simulated gain is 13.03 and 13.48 dBi respectively. The in-house designed controller overcomes the primary limitations associated with the present electromechanical phased array such as cost weight, size, power consumption, and complexity in design which limits the use of a phased array to military applications only. The current study with novel design and enhanced performance makes the system worthy of the practical use of phased-array antennas for common society at large.


2015 ◽  
Vol 2015 ◽  
pp. 1-22 ◽  
Author(s):  
Ivan Aldaya ◽  
Gabriel Campuzano ◽  
Gerardo Castañón ◽  
Alejandro Aragón-Zavala

Given the interference avoidance capacity, high gain, and dynamical reconfigurability, phased array antennas (PAAs) have emerged as a key enabling technology for future broadband mobile applications. This is especially important at millimeter-wave (mm-wave) frequencies, where the high power consumption and significant path loss impose serious range constraints. However, at mm-wave frequencies the phase and amplitude control of the feeding currents of the PAA elements is not a trivial issue because electrical beamforming requires bulky devices and exhibits relatively narrow bandwidth. In order to overcome these limitations, different optical beamforming architectures have been presented. In this paper we review the basic principles of phased arrays and identify the main challenges, that is, integration of high-speed photodetectors with antenna elements and the efficient optical control of both amplitude and phase of the feeding current. After presenting the most important solutions found in the literature, we analyze the impact of the different noise sources on the PAA performance, giving some guidelines for the design of optically fed PAAs.


2000 ◽  
Vol 15 (7) ◽  
pp. 25-31 ◽  
Author(s):  
A.A. Tolkachev ◽  
B.A. Levitan ◽  
G.K. Solovjev ◽  
V.V. Veytsel ◽  
V.E. Farber

Sign in / Sign up

Export Citation Format

Share Document