Traditional methods of calculation of beam constructions of floors and coverings of industrial buildings assume their consideration when calculating separately from the frame structures, in particular, reinforced concrete slabs, without taking into account their joint work, which leads to a significant margin of safety. Today in Ukraine there is a significant number of industrial buildings and structures that need strengthening and reconstruction.
In this regard, of particular importance are studies of the actual load-bearing capacity of the frames of single-storey and multi-storey industrial buildings, and both in the reconstruction and in new construction, the results of which will significantly reduce costs and more rationally design structures.
At the same time, one of the most relevant areas is the study of the joint work of metal load-bearing structures with prefabricated reinforced concrete structures of rigid disks of coatings and floors in their calculation.
Moreover, in the national building codes, as well as in the educational and methodological literature, the calculation methods of taking into account the joint work of such constructions are not fully covered.
The purpose of this work is to estimate the reduction of mass of the metal beam structure in its calculation in bending, taking into account the joint work with the rigid disk of the floor consist of precast concrete.
As part of the study, the calculation of the floor beam according to the traditional calculation scheme - without taking into account the joint work with the floor slab, the calculation of its cross-section taking into account the joint work with floor slabs and experimental numerical study of the floor by the finite element method. Modeling of the floor fragment was performed in the software packages "SCAD Office" and "LIRA CAD 2019".
Numerical research is aimed at verifying the feasibility of using the calculation methodology of DBN B.2.6-98-2009 to determine the effective width of the shelf when calculating the T-sections for prefabricated reinforced concrete slabs, which are included in the joint work with the floor beams.
A comparative analysis of the obtained cross-section of the beam with the beam which was previously calculated by the traditional method of calculation in stresses in the most dangerous cross section and the total mass of the beams.
According to the results of the analysis, the correctness of the application of the above normative method for determining the effective width of the shelf of T-bending reinforced concrete elements was confirmed.
Ensuring Operational Reliability of Overpass on "Almaty-Kapshagai" Highway Section in Kazakhstan
