scholarly journals NMR inversion echo analog in cobalt and lithium ferrite under the combined action of radiofrequency and magnetic pulses

2021 ◽  
Vol 23 (1) ◽  
Author(s):  
G. Mamniashvili ◽  
◽  
T. Gegechkori ◽  
T. Gavasheli ◽  
◽  
...  
Keyword(s):  
Lithium Ferrite ◽  
Combined Action

The Effect of Stress and Warfarin on the Adrenal Gland in Relation to Spontaneous Hemorrhage, as Judged by Measurement of Adrenal Ascorbic Acid and Serum Corticosterone

1971 ◽  
Vol 26 (02) ◽  
pp. 275-288 ◽  
Author(s):  
S Chattopadhyay ◽  
D. D Johnson ◽  
G. J Millar ◽  
L. B Jaques
Keyword(s):  
Ascorbic Acid ◽  
Acid Concentration ◽  
Ascorbic Acid Concentration ◽  
Corticosterone Concentration ◽  
Serum Corticosterone ◽  
Spontaneous Hemorrhage ◽  
Combined Action ◽  
Series Of Experiments ◽  
Pituitary Adrenal Axis

SummaryRats were subjected to the following procedures: No treatment, Stressor (10% NaCl i.p.), Warfarin for 7 days, Stressor followed by Warfarin; and groups were sacrificed at intervals for assessment of spontaneous hemorrhage and of adrenal ascorbic acid concentration. There was no hemorrhage in the no treatment and stressor groups; some hemorrhage in the warfarin group; profound hemorrhage with Warfarin + Stressor. The adrenal ascorbic acid concentration was found to be lower, 8 h and again 5 days after stress, and remained lower in the warfarin + stress animals. Warfarin had no effect on adrenal ascorbic acid level.In another series of experiments in which the stress consisted of an electric current to the cage floor for 6 sec over 15 min, rats were sacrificed daily for determination of serum corticosterone concentration and occurrence of spontaneous hemorrhage. There was a statistically significant increase of serum corticosterone concentration with stress, warfarin and combined warfarin and stress treatments (P< 0.001 for all three variables). There was a significant correlation (r = 0.96 and 0.89, P< 0.01) for serum corticosterone concentration with hemorrhage score and incidence of hemorrhage in stressed rats receiving warfarin, but not in those receiving only warfarin. The results indicate an activation, rather than an exhaustion, of the pituitary-adrenal axis during the combined action of anticoagulant and stress, which results in the development of spontaneous hemorrhage.

The effect of Tin additionon on Structural and magnetic properties of the stannoferrite Li0.5+0.5XFe2.5-1.5XSnXO4

2016 ◽  
Vol 12 (3) ◽  
pp. 4307-4321 ◽  
Author(s):  
Ahmed Hassan Ibrahim ◽  
Yehia Abbas
Keyword(s):  
Particle Size ◽  
Fine Particles ◽  
Magnetic Moments ◽  
Lithium Ferrite ◽  
Tem Analysis ◽  
Weiss Temperature ◽  
X Ray ◽  
Two Phases ◽  
Nanocrystalline Ferrite ◽  
20 Nm

The physical properties of ferrites are verysensitive to microstructure, which in turn critically dependson the manufacturing process.Nanocrystalline Lithium Stannoferrite system Li0.5+0.5XFe2.5-1.5XSnXO4,X= (0, 0.2, 0.4, 0.6, 0.8 and 1.0) fine particles were successfully prepared by double sintering ceramic technique at pre-sintering temperature of 500oC for 3 h andthepre-sintered material was crushed and sintered finally in air at 1000oC.The structural and microstructural evolutions of the nanophase have been studied using X-ray powder diffraction (XRD) and the Rietveld method.The refinement results showed that the nanocrystalline ferrite has a two phases of ordered and disordered phases for polymorphous lithium Stannoferrite.The particle size of as obtained samples were found to be ~20 nm through TEM that increases up to ~ 85 nmand isdependent on the annealing temperature. TEM micrograph reveals that the grains of sample are spherical in shape. (TEM) analysis confirmed the X-ray results.The particle size of stannic substituted lithium ferrite fine particle obtained from the XRD using Scherrer equation.Magneticmeasurements obtained from lake shore’s vibrating sample magnetometer (VSM), saturation magnetization ofordered LiFe5O8 was found to be (57.829 emu/g) which was lower than disordered LiFe5O8(62.848 emu/g).Theinterplay between superexchange interactions of Fe3+ ions at A and B sublattices gives rise to ferrimagnetic ordering of magnetic moments,with a high Curie-Weiss temperature (TCW ~ 900 K).

THE ENERGY EFFICIENCY TECHNIQUE OF THERMAL PROCESSING OF GRAIN

2019 ◽  
pp. 176-182
Author(s):  
А. Zykov ◽  
S. Orlova ◽  
L. Ovsiannykova
Keyword(s):  
Energy Efficiency ◽  
Thermal Processing ◽  
Microwave Field ◽  
Low Frequency ◽  
Heat Pipes ◽  
Biologically Active ◽  
Microwave Drying ◽  
Post Harvest ◽  
Combined Action ◽  
Frequency Radiation

The methods of energy efficiency increasing of pre- and post-harvest thermal processing of grain are considered. The effective ways to deliver energy to the grain using heat pipes and microwave field are given. The effect of combined action of microwave and low-frequency radiation on the grain germination is shown. Currently, the intensification of technological processes under the influence of microwave radiation is used in many industrial processes. Microwave equipment is becoming a necessary technological component of large profitable industries. The process of drying is no exception. In recent years, new versions of dryers have been proposed that use combined methods of energy supply, including microwave energy. Microwave dryers for foodstuffs, grains and oilseeds, including those for seed stock, have been created and are beginning to be used, along with drying and disinfection, disinfection of drying products from harmful bacteria, fungi, and mildew. For the implementation of microwave drying of particular importance is the choice of regime parameters of drying, given the fact that the grain is a biologically active object. Microwave drying allows you to provide a powerful flow of energy to the object of drying and to obtain a significant intensification of moisture evaporation. But at the same time there is also an intense heating of the product, which can degrade its quality. The possibility of supplying energy throughout the cross section of the product allows for the evaporation of moisture from the inner layers of the product, which is especially important at the end of drying, when the zone of evaporation of moisture is significantly deeper. Therefore, the highest drying efficiency can be obtained in combined processes that take advantage of various drying methods, such as convective, as well as the use of microwave and low-frequency magnetic fields. The paper presents effective ways to supply energy to the grain using heat pipes and a microwave field. The effect of the combined action of microwave and low-frequency radiation on grain similarity is shown. Ways to improve the energy efficiency of the processes of preseeding and post-harvest heat treatment of grain are considered.

Synthesis, Structure and Dielectric Properties of Magnesium-substituted Lithium Ferrite

2016 ◽  
Vol 8 (4(2)) ◽  
pp. 04066-1-04066-6
Author(s):  
L. S. Kaykan ◽  
◽  
J. S. Kaykan ◽  
I. P. Yaremiy ◽  
O. M. Ugorchuk ◽  
...  
Keyword(s):  
Dielectric Properties ◽  
Lithium Ferrite

scholarly journals Investigation of Corrosion Rate and Rust Expansion Form of Segment Reinforcement for Shield Tunnel by Combined Action of Soil Loading, Chloride Ion and Stray Current

2021 ◽  
Vol 13 (6) ◽  
pp. 3444
Author(s):  
Zheng Li ◽  
Hao Jin ◽  
Shuo Yu
Keyword(s):  
Corrosion Rate ◽  
Steel Corrosion ◽  
Chloride Ion ◽  
Shield Tunnel ◽  
Uniform Corrosion ◽  
Stray Current ◽  
Soil Loading ◽  
Capacity Degradation ◽  
Expansion Form ◽  
Combined Action

Segment reinforcement corrosion can cause bearing-capacity degradation of shield tunnel, which is unsafe for the metro operation. Therefore, a three-dimensional computational model was proposed in this paper to study the corrosion rate and rust expansion form of segment reinforcement by the combined action of soil loading, chloride ion and stray current. The results show that the arch waist segment steel corrosion rate in the middle is larger than the ends. The rust expansion form of segment reinforcement appears be an eccentric circle. The radius size and circular center are related to the non-uniform corrosion coefficient and the maximum corrosion current density.

Sign in / Sign up

Export Citation Format

Share Document