Dynamic properties of the isolators used in the Green Museum Library (Taiwan)

2021 ◽  
Author(s):  
Ivan Marenda ◽  
Agostino Marioni ◽  
Roberto Dalpedri ◽  
Marco Banfi
Keyword(s):  
Scale Effect ◽  
Seismic Isolation ◽  
Production Control ◽  
Dynamic Properties ◽  
Friction Material ◽  
Curved Surface ◽  
Natural Period ◽  
Response Data ◽  
Factory Production ◽  
Friction Pendulum

<p>Over the last decades seismic isolation technology has got a foothold in the structural protection increasing both the damping and the natural period of the superstructure. The curved surface sliding isolator is one of the most common devices used to aim at this goal. It features a special friction material (HIM) able to dissipate a very large amount of energy while, the recentring capacity is given by the pendulum effect. This kind of isolator has been used in the Green Museum Palace (Taiwan). The constancy of its behaviour has been investigated in ShakeLab (Italy), testing 100% of the Friction Pendulum devices in factory production control. In this paper, response data from FPC tests on seven types of Friction Pendulum devices are illustrated. These data show the constancy of the performance of the isolators subjected to design conditions. Furthermore, scale effect in dynamic properties has been studied because of different size isolators have been taken into account.</p>

Isolation Performance of Intelligent Seismic Isolation System Using Air Bearing

2009 ◽  
Author(s):  
Satoshi Fujita ◽  
Keisuke Minagawa ◽  
Mitsuru Miyazaki ◽  
Go Tanaka ◽  
Toshio Omi ◽  
...  
Keyword(s):  
Seismic Isolation ◽  
Seismic Waves ◽  
Three Dimensional ◽  
Vertical Motion ◽  
Air Bearings ◽  
Natural Period ◽  
Isolation System ◽  
Vertical Excitation ◽  
Long Period ◽  
Isolation Performance

This paper describes three-dimensional isolation performance of seismic isolation system using air bearings. Long period seismic waves having predominant period of from a few seconds to a few ten seconds have recently been observed in various earthquakes. Also resonances of high-rise buildings and sloshing of petroleum tanks in consequence of long period seismic waves have been reported. Therefore the isolation systems having very long natural period or no natural period are required. In a previous paper [1], we proposed an isolation system having no natural period by using air bearings. Additionally we have already reported an introduction of the system, and have investigated horizontal motion during earthquake in the previous paper. It was confirmed by horizontal vibration experiment and simulation in the previous paper that the proposed system had good performance of isolation. However vertical motion should be investigated, because vertical motion varies horizontal frictional force. Therefore this paper describes investigation regarding vertical motion of the proposed system by experiment. At first, a vertical excitation test of the system is carried out so as to investigate vertical dynamic property. Then a three-dimensional vibration test using seismic waves is carried out so as to investigate performance of isolation against three-dimensional seismic waves.

scholarly journals A comparative study of base isolation devices in light rail transit structure featured with lead rubber bearing and friction pendulum system

2018 ◽  
Vol 195 ◽  
pp. 02013
Author(s):  
Santi Nuraini ◽  
Asdam Tambusay ◽  
Priyo Suprobo
Keyword(s):  
Seismic Isolation ◽  
Time History ◽  
Light Rail ◽  
Rail Transit ◽  
Light Rail Transit ◽  
Pendulum System ◽  
Rubber Bearing ◽  
Lead Rubber Bearing ◽  
Friction Pendulum ◽  
Friction Pendulum System

Advanced nonlinear analysis in light rail transit (LRT) structures has been undertaken to examine the influence of seismic isolation devices for reducing seismic demand. The study employed the use of two types of commercially available bearings, namely lead rubber bearing (LRB) and friction pendulum system (FPS). Six LRT structures, designed to be built in Surabaya, were modelled using computer-aided software SAP2000, where each of the three structures consisted of three types of LRB and FPS placed onto the pier cap to support the horizontal upper-structural member. Nonlinear static pushover and dynamic time history analysis with seven improved ground motion data was performed to gain improved insights on the behavioural response of LRT structures, allowing one to fully understand the supremacy of seismic isolations for protecting the structure against seismic actions. It is shown that both devices manage to isolate seismic forces, resulting in alleviation of excessive base shear occurring at the column. In addition, it is noticeable that the overall responses of LRB and FPS shows marginal discrepancies, suggesting both devices are interchangeable to be used for LRT-like structures.

Shaking Table Test Study on Mid-Story Isolation Structures

2012 ◽  
Vol 446-449 ◽  
pp. 378-381
Author(s):  
Jian Min Jin ◽  
Ping Tan ◽  
Fu Lin Zhou ◽  
Yu Hong Ma ◽  
Chao Yong Shen
Keyword(s):  
Seismic Response ◽  
Seismic Isolation ◽  
Shaking Table Test ◽  
Base Isolation ◽  
Shaking Table ◽  
Natural Period ◽  
Isolation System ◽  
Isolation Layer ◽  
Lead Rubber Bearing ◽  
Complex Structural

Mid-story isolation structure is developing from base isolation structures. As a complex structural system, the work mechanism of base isolation structure is not entirely appropriate for mid-story isolation structure, and the prolonging of structural natural period may not be able to decrease the seismic response of substructure and superstructure simultaneously. In this paper, for a four-story steel frame model, whose prototype first natural period is about 1s without seismic isolation design, the seismic responses and isolation effectiveness of mid-story isolation system with lead rubber bearing are studied experimentally by changing the location of isolation layer. Respectively, the locations of isolation layer are set at bottom of the first story, top of the first story, top of the second story and top of the third story. The results show that mid-story isolation can reduce seismic response in general, and substructure acceleration may be amplified.

Seismic Mitigation Assessment of Building Using Multiple Direction Optimized-Friction Pendulum System

2008 ◽  
Author(s):  
C. S. Tsai ◽  
Wen-Shin Chen ◽  
Yung-Chang Lin ◽  
Chi-Lu Lin
Keyword(s):  
Finite Element ◽  
Shaking Table Test ◽  
Shaking Table ◽  
Finite Element Formulation ◽  
Element Formulation ◽  
Natural Period ◽  
Pendulum System ◽  
Friction Pendulum ◽  
Seismic Mitigation ◽  
Friction Pendulum System

In order to prevent a building near a fault from earthquake damage, in this study an advanced base isolation system called the multiple direction optimized-friction pendulum system (Multiple DO-FPS or MDO-FPS) is proposed and examined to address its mechanical behavior through the finite element formulation and evaluate its efficiency in seismic mitigation through a series of shaking table tests. On the basis of the finite element formulation, it is revealed that the natural period, the capacity of the bearing displacement and damping effect for the Multiple Direction Optimized-Friction Pendulum System (Multiple DO-FPS) change continually during earthquakes. Therefore, the MDO-FPS isolator can avoid possibility of resonance of enriched frequencies from ground motions and provide an efficient capacity of the bearing displacement and damping during the earthquakes. Simultaneously, the shaking table test results also illustrate that the Multiple DO-FPS isolator possesses an outstanding seismic mitigation capabilities.

Sign in / Sign up

Export Citation Format

Share Document