scholarly journals Reparation of voltage disturbance using PR controller-based DVR in Modern power systems

2021 ◽  
Vol 27 (1) ◽  
pp. 16-29
Author(s):  
D. Danalakshmi ◽  
S. Prathiba ◽  
M. Ettappan ◽  
D. Mohan Krishna

Abstract The Smart Grid environment gives more benefits for the consumers, whereas the power quality is one of the challenging factors in the smart grid environment. To protect the system equipment and increase the reliability, different filter technologies are used. Even though, consumers’ expectations towards the power quality are not fulfilled. To overcome these drawbacks and enhance the system reliability, a new Custom Power Devices (CPD) are introduced in the system. Among different CPDs, the Dynamic Voltage Restorer (DVR) is one of the voltage compensating devices that is used to improve the power quality during distortions. When the distortions such as voltage swell and sag occur in the distribution system, the control strategy in the DVR plays a significant role. In this article, the DVR performance using Proportional Integral (PI), Proportional Resonant (PR) controllers are analyzed. A robust optimization algorithm called Self Balanced Differential Evolution (SBDE) is used to find the optimal gain values of the controllers in order to reach the target of global minimum error and obtain fast response. Then, a comparative analysis is performed between different controllers and verified that the performance of PR controller is superior than the other controllers. It has been found that the proposed PR controller strategy reduces the Total Harmonic Distortion (THD) values for all types of faults. The proposed SBDE optimized DVR with PR controller reduces the THD value less than 4% under voltage distoration condition. The DVR topology is validated in MATLAB/SIMULINK in order to detect the disturbance and inject the voltage to compensate the load voltage.

2014 ◽  
Vol 2014 ◽  
pp. 1-7 ◽  
Author(s):  
Aida Fazliana Abdul Kadir ◽  
Tamer Khatib ◽  
Wilfried Elmenreich

This paper is an overview of some of the main issues in photovoltaic based distributed generation (PVDG). A discussion of the harmonic distortion produced by PVDG units is presented. The maximum permissible penetration level of PVDG in distribution system is also considered. The general procedures of optimal planning for PVDG placement and sizing are also explained in this paper. The result of this review shows that there are different challenges for integrating PVDG in the power systems. One of these challenges is integrated system reliability whereas the amount of power produced by renewable energy source is consistent. Thus, the high penetration of PVDG into grid can decrease the reliability of the power system network. On the other hand, power quality is considered one of the challenges of PVDG whereas the high penetration of PVDGs can lead to more harmonic propagation into the power system network. In addition to that, voltage fluctuation of the integrated PVDG and reverse power flow are two important challenges to this technology. Finally, protection of power system with integrated PVDG is one of the most critical challenges to this technology as the current protection schemes are designed for unidirectional not bidirectional power flow pattern.


2019 ◽  
Vol 8 (3) ◽  
pp. 7366-7369

Power quality has been an issue in electrical power systems. Disturbances occur in power quality which effects machines, some electric devices and severe cause will get very serious damages. For normal and efficient operation it’s necessary to compensate and acknowledge every type of the disturbances at earlier time of the power system. Many sorts of Custom Power Devices (CPD’s) are used to resolve these issues .Here at present, one in every of those devices, Dynamic Voltage restorer (DVR) is conferred. In power distribution systems this is often best and effective device employed. During this project new structure and control methodology of multifunctional DVRs for voltage quality correction are mentioned. Proportional Integral Controller and Fuzzy Logic Controller are used for the PQ improvement. The performance of the device and Total Harmonic Distortion is compared with each other. The performance of the device like voltage swell, sag is projected.


Author(s):  
Ali Basim Mohammed ◽  
Mohd Aifaa Mohd Ariff

This paper represents a new configuration of the dynamic voltage restorer consists of approximate classical sliding mode differentiator (ACSMD) with the terminal sliding mode controller (TSMC) as the nonlinear sliding variable. In this study, the proposed structure of the DVR is utilized to maintain the magnitude of the load voltage at a constant value, maintain the system total harmonic distortion (THD), boost the robustness property and minimize the steady-state error. The power quality has received more interest due to the implementation of various industrial devices and critical loads at the distribution side. Nowadays, the main challenges in power quality in the system are voltage sags/swells, harmonics and voltage imbalance. Various devices are utilized to address these challenges. The dynamic voltage restorer is one of these devices. It is connected in series with the distribution system and injects a proper voltage magnitude to maintain the voltage load at the constant value. In this paper, the DVR model with the ASMF and TSMC is implemented in using MATLAB/Simulink. The proposed controller is evaluated using the standard voltage sag indices.


2021 ◽  
Vol 11 (2) ◽  
pp. 774 ◽  
Author(s):  
Ahmed S. Abbas ◽  
Ragab A. El-Sehiemy ◽  
Adel Abou El-Ela ◽  
Eman Salah Ali ◽  
Karar Mahmoud ◽  
...  

In recent years, with the widespread use of non-linear loads power electronic devices associated with the penetration of various renewable energy sources, the distribution system is highly affected by harmonic distortion caused by these sources. Moreover, the inverter-based distributed generation units (DGs) (e.g., photovoltaic (PV) and wind turbine) that are integrated into the distribution systems, are considered as significant harmonic sources of severe harmful effects on the system power quality. To solve these issues, this paper proposes a harmonic mitigation method for improving the power quality problems in distribution systems. Specifically, the proposed optimal planning of the single tuned harmonic filters (STFs) in the presence of inverter-based DGs is developed by the recent Water Cycle Algorithm (WCA). The objectives of this planning problem aim to minimize the total harmonic distortion (THD), power loss, filter investment cost, and improvement of voltage profile considering different constraints to meet the IEEE 519 standard. Further, the impact of the inverter-based DGs on the system harmonics is studied. Two cases are considered to find the effect of the DGs harmonic spectrum on the system distortion and filter planning. The proposed method is tested on the IEEE 69-bus distribution system. The effectiveness of the proposed planning model is demonstrated where significant reductions in the harmonic distortion are accomplished.


2019 ◽  
Vol 8 (2S11) ◽  
pp. 3283-3289

The DC smart-grid-system (DCSGS) becomes more and more popular and it is seen as an alternative to the AC. In DCSGS, voltage quality and harmonic distortion issues affects the performance of integrated renewable power sources. To improve the voltage quality, SEPIC converter is used to step up the output of PV cell. In DCSGS, output of PV is stepped-up using SEPIC. The output of wind generator is also rectified and stepped-up using SEPIC. This effort covenants with modeling&-simulation of CL(closed-loop)-DC-SGS (smart grid system) with PR controller and FLC in DCSGS. The performance of DCSGS with PR and FLC are compared and their results are presented. The results indicate that FLC controlled close-loop DCSGS gives superior response


Author(s):  
A. Sathik Basha ◽  
M. Ramasamy

Increased utilization of nonlinear loads in the power distribution system with profound integration of renewable energy requires improved power quality control. This paper proposes a Reformed Second Order Generalized Integrated (R-SOGI) control scheme for enhancing the output of the Dynamic Voltage Restorer (DVR) for the objective of achieving the desired sinusoidal voltage wave shape at the common point of services and harmonic reduction. The DVR incorporates a Solar Photovoltaic (SPV) system using the Z-source Inverter (ZSI), providing the necessary active power to mitigate the voltage sag/swell and power demand. ZSI offers step-down as well as step-up abilities, it makes the converters to operate in the conditions of shoot-through. Therefore, the application of ZSI-based DVR topology seems very promising. The compensating reference voltage is generated by the R-SOGI algorithm, which offers superior output under conditions for grid voltage irregularities, including voltage sag/swell and unbalanced and distorted utility grid voltages. In comparison to DVR based on the VSI voltage inverter (VSI), the response from ZSI-DVR to a reduction of voltage distortions and harmonics is investigated. An experimental SPV ZSI-DVR prototype is developed in the laboratory to check the effectiveness of the controller and is tested under balanced and unbalanced supply and dynamic load conditions.


Author(s):  
Akash K. Pati ◽  
Arunjyoti Priyadarshini ◽  
Atma P. Sethy ◽  
Prativa Muduli ◽  
Prateek Kr. Sahoo ◽  
...  

Author(s):  
Reza Tajik

Nowadays, the utilization of renewable energy resources in distribution systems (DSs) has been rapidly increased. Since distribution generation (DG) use renewable resources (i.e., biomass, wind and solar) are emerging as proper solutions for electricity generation. Regarding the tremendous deployment of DG, common distribution networks are undergoing a transition to DSs, and the common planning methods have become traditional in the high penetration level. Indeed, in conformity with the voltage violation challenge of these resources, this problem must be dealt with too. So, due to the high penetration of DG resources and nonlinear nature of most industrial loads, the planning of DG installation has become an important issue in power systems. The goal of this paper is to determine the planning of DG in distribution systems through smart grid to minimize losses and control grid factors. In this regard, the present work intending to propose a suitable method for the planning of DSs, the key properties of DS planning problem are evaluated from the various aspects, such as the allocation of DGs, and planning, and high-level uncertainties. Also depending on these analyses, this universal literature review addressed the updated study associated with DS planning. In this work, an operational design has been prepared for a higher performance of the power distribution system in the presence of DG. Artificial neural network (ANN) has been used as a method for voltage monitoring and generation output optimization. The findings of the study show that the proposed method can be utilized as a technique to improve the process of the distribution system under various penetration levels and in the presence of DG. Also, the findings revealed that the optimal use of ANN method leads to more controllable and apparent DS.


2016 ◽  
Vol 2016 ◽  
pp. 1-17 ◽  
Author(s):  
A. Elsherif ◽  
T. Fetouh ◽  
H. Shaaban

In recent years a multitude of events have created a new environment for the electric power infrastructure. The presence of small-scale generation near load spots is becoming common especially with the advent of renewable energy sources such as wind power energy. This type of generation is known as distributed generation (DG). The expansion of the distributed generators- (DGs-) based wind energy raises constraints on the distribution networks operation and power quality issues: voltage sag, voltage swell, voltage interruption, harmonic contents, flickering, frequency deviation, unbalance, and so forth. Consequently, the public distribution network conception and connection studies evolve in order to keep the distribution system operating in optimal conditions. In this paper, a comprehensive power quality investigation of a distribution system with embedded wind turbines has been carried out. This investigation is carried out in a comparison aspect between the conventional synchronous generators, as DGs are widely in use at present, and the different wind turbines technologies, which represent the foresightedness of the DGs. The obtained results are discussed with the IEC 61400-21 standard for testing and assessing power quality characteristics of grid-connected wind energy and the IEEE 1547-2003 standard for interconnecting distributed resources with electric power systems.


Sign in / Sign up

Export Citation Format

Share Document