On temperature dependence of the parameters of corona discharge current–voltage characteristics

2016 ◽  
Vol 52 (1) ◽  
pp. 85-91 ◽  
Author(s):  
F. P. Grosu ◽  
An. M. Bologa ◽  
M. K. Bologa ◽  
O. V. Motorin
Author(s):  
Haifeng Chen ◽  
Penghao Su ◽  
Shu Yang ◽  
Yimin Zhu

AbstractThis paper systematically studied the current-voltage characteristics and the spectrum characteristics of bipolar corona discharge in multi-needle electrode configuration, and determined the optimized space between electrodes. The experimental results show that the discharge current I decreases with an increase in the needle radius a or the space between electrodes d, and increases with an increase in the space between needles s. Due to the symmetry of the discharge electrode configuration, the polarity of the HV electrode has no obvious influence on the discharge. Using the method of OES for measuring N


1979 ◽  
Vol 35 (5) ◽  
pp. 416-418 ◽  
Author(s):  
J. Shewchun ◽  
R. Singh ◽  
D. Burk ◽  
F. Scholz

2012 ◽  
Vol 1426 ◽  
pp. 365-370
Author(s):  
Francisco Temoltzi Avila ◽  
Andrey Kosarev ◽  
Ismael Cosme ◽  
Mario Moreno ◽  
P. Roca y Cabarrocas

ABSTRACTThe dark current-voltage characteristics of PIN structures are studied and analyzed for PV samples as for integral device without taking account the performance of the different elements typically used in equivalent circuit model such as diode n-factor, shunt and series resistances. The contribution of all these elements is very important in the development of devices because they determine the performance characteristics. In this work we have studied and compared the temperature dependence of current-voltage characteristics in μc-Si:H and pm-Si:H p-i-n structures having approximately the same efficiencies with emphasis on their different electronic characteristics such as shunt (Rsh) and series (Rs) resistance, ideality factor (n), and the saturation current (Is), which give us some ideas on role of these elements. In the pm-Si:H cell it was observed that the Rs increases with the increase of the temperature in contrast to the μc-Si:H structures, where the series resistance reduces with temperature change from T = 300 up to 480K. In both the pm-Si:H and μc-Si:H samples Rshreduces with temperature change from 300 up to 480 K. The ideality factor in the pm-Si:H structure shows an increase, and in μc-Si:H a reduction, when temperature increases. Saturation current in both cases increases with temperature as it was expected. From the saturation current it was obtained the build-in potential. Analysis behavior of both saturation current and n-factor with temperature shows that build-in potential increases with temperature in the pm-Si:H, but reduces in μc-Si:H structure.


Author(s):  
Galina A. Sokolina ◽  
Igor I. Arkhipov ◽  
Nikolay Yu. Svechnikov ◽  
Sergey A. Grashin

Amorphous hydrocarbon films on silicon substrates obtained in the chamber of tokamak T-10 with space-bounded deuterium plasma by carbon diaphragms were studied. Using the methods of spectrophotometry, ellipsometry, X-ray photoemission spectroscopy and X-ray excited Auger electron spectroscopy, it was established that the refraction and absorption coefficients of films, as well as the parameters of the electronic structure such as the magnitude of the band gap, the fraction of sp2-hybridized carbon and the chemical composition of impurities depend on the characteristics of the discharge in the tokamak. It is shown that the deposited films refer to high-resistance dielectrics, and they can be classified by optical properties as hard or soft amorphous hydrocarbon films, depending on the type of the plasma discharge (pulse working discharge or long-term low-energy cleaning discharge). Wherein, the conductivity of hard films is less than that of soft films, which corresponds to a smaller fraction of sp2-states of carbon in these films and to a higher value of the band gap. The current-voltage characteristics and the temperature dependence of the direct current conductivity of hard and soft films were measured. It was shown that in the temperature range of 293–550 K, the conductivity is determined by the hopping conductivity mechanism over localized states near the Fermi level and the boundaries of the allowed bands. The hopping conductivity mechanism is also indicated by the power law obtained at room temperature at alternating current with a value of a power exponent close to 0.8. The measurement of the current-voltage characteristics and the temperature dependence of the conductivity of hard and soft films showed a significant difference in the activation energy of conductivity and the conductivity at an elevated temperature. The established dependences of the direct current conductivity and the activation energy value of the films on the discharge parameters can be used as diagnostic benchmarks of different types of plasma discharges in a tokamak. Data on the electrical conductivity of the films are analyzed within the framework of the concept of the electronic structure of amorphous non-crystalline materials.  


2001 ◽  
Vol 674 ◽  
Author(s):  
Robert Gunnarsson ◽  
Anatoli Kadigrobov ◽  
Zdravko Ivanov

ABSTRACTWe have been able to deduce a temperature dependence of the built-in potential in La2/3Sr1/3MnO3 grain boundary junctions. This has been performed by trimming a single grain boundary down to 1μm width with a focused ion-beam. We can thereby see the impact of single domain walls on the magnetoresistance and the current-voltage characteristics. We have also demonstrated the effect of averaging as we increased the number of junctions.


Sign in / Sign up

Export Citation Format

Share Document