scholarly journals On the strain-rate sensitivity of columnar ice

1997 ◽  
Vol 43 (145) ◽  
pp. 408-410
Author(s):  
M. E. Manley ◽  
E. M. Schulson

AbstractA power law relation between stress and strain rate of the form was used to describe the response to strain rate of S1 ice loaded across the columns at –10° C. The rate exponent, n, decreased with increasing strain from about 4.6 at an observed peak on the load displacement curve to approximately 2.6 at a shortening of 2%. Analysis of these results and of the results of other authors on different forms of ice deformed at the same temperature suggests that the power law exponent, n is proportional to Fc/Fg The parameter Fc/Fg is the far-field basal dislocation climb force divided by the glide force.

1997 ◽  
Vol 43 (145) ◽  
pp. 408-410 ◽  
Author(s):  
M. E. Manley ◽  
E. M. Schulson

AbstractA power law relation between stress and strain rate of the formwas used to describe the response to strain rate of S1 ice loaded across the columns at –10° C. The rate exponent,n, decreased with increasing strain from about 4.6 at an observed peak on the load displacement curve to approximately 2.6 at a shortening of 2%. Analysis of these results and of the results of other authors on different forms of ice deformed at the same temperature suggests that the power law exponent,nis proportional toFc/FgThe parameterFc/Fgis the far-field basal dislocation climb force divided by the glide force.


2001 ◽  
Vol 2001 (0) ◽  
pp. 11-12
Author(s):  
Yasuhisa SATO ◽  
Takeshi SUZUKI ◽  
Wataru KIKUCHI ◽  
Masazumi KOMORI ◽  
Takuya ABE

1966 ◽  
Vol 33 (3) ◽  
pp. 505-513 ◽  
Author(s):  
T. C. E. Ting

Barenblatt and Ishlinskii [5] considered the impact of a viscoplastic rod on a rigid wall in which the relation between stress and strain rate is linear. In this paper, their analysis is generalized to a power-law relation between stress and strain rate so that their results may be reduced as a special case. Some strikingly different behaviors are observed between linear viscoplastic materials and nonlinear viscoplastic materials. Comparisons are also made between the viscoplastic solution obtained here with the rate-independent, rigid-plastic solution by Lee and Tapper [2]. It is shown that the curves which represent the residual strains versus the axial length along the rod are concave upward for all viscoplastic rods. For the rate-independent, rigid-plastic rods, on the other hand, they are concave downward.


Sign in / Sign up

Export Citation Format

Share Document