scholarly journals Silica Nanoparticles and pH effect on Sand Production Mechanism due to Smart Water Softening

2020 ◽  
Vol 9 (3) ◽  
pp. 1294-1306
Keyword(s):  
Sio2 Nanoparticles ◽  
Soft Water ◽  
Rock Surface ◽  
Sand Production ◽  
Thin Sections ◽  
Low Salinity ◽  
Smart Water ◽  
Low Salinity Water ◽  
Salinity Water ◽  
Sandstone Reservoirs

Low salinity water is the most common method of increasing oil production, which has become very common in recent decades. Low-salinity water changes the electric charge of the rock surface in sandstone and carbonate reservoirs, causing the rock to become water wet. By a salt shock, smart water disturbs the static balance of sandstone reservoirs and increases sand production. Stabilizing nanoparticles in smart water can create a nano texture on the rock surface and change its wettability. On the other hand, by sitting on the rock surface in the sandstone reservoirs, they increase the strength of the rock and greatly reduce sand production. One way to improve the properties of low-salt water is to remove magnesium and calcium ions, which can be produced by using smart soft water, which has the ability to increase water viscosity, easier absorption of surfactants, and in any case, smart soft water has higher efficiency and more economical. The purpose of this study is to investigate sand production, with used SiO2 nanoparticles at different pH. By potential zeta test, 1000 ppm SiO2 concentration was selected for testing. The pH value of five containers containing smart soft water And five other containers containing Nanofluid was adjusted to 4.5, 5.5, 6.5, 7.5, and 8.5. In each of the ten containers, a thin section with a specific weight was immersed. After measuring the daily weight of the thin sections for five days, we concluded that the use of SiO2 nanoparticles, 80%, and a change of four pH units, 75%, would prevent sand production.

scholarly journals Sandstone Reservoir Wettability Alteration Due to Water Softening: Impact of Silica Nanoparticles on Sand Production Mechanism

2020 ◽  
Vol 10 (5) ◽  
pp. 6328-6342 ◽  
Keyword(s):  
Contact Angle ◽  
Silica Nanoparticles ◽  
Oil Recovery ◽  
Reservoir Rock ◽  
Wettability Alteration ◽  
Sand Production ◽  
Thin Sections ◽  
Low Salinity ◽  
Low Salinity Water ◽  
Salinity Water

Low salinity water in the oil reservoirs changes the wettability and increases the oil recovery factor. In sandstone reservoirs, the sand production occurs or intensifies with wettability alteration due to low salinity water injection. In any case, sand production should be stopped and there are many ways to prevent sand production. By modifying the composition of low salinity water, it can be adapted to be more compatible with the reservoir rock and formation water, which has the least formation damage. By eliminating magnesium and calcium ions, smart soft water (SSW) is created which is economically suitable for injection into the reservoirs. By stabilizing the nanoparticles in SSW, nanofluids can be prepared which with injection into the sandstones reservoir increase the oil recovery, change the wettability and increase the rock strength. In this present, SSW composition was determined by compatibility testing, and the SiO2 nanoparticle with 1000 ppm concentration was stabilized in SSW. Eight thin sections were oil wetted by using normal heptane solution and different molars of stearic acid and two thin sections were considered as base thin sections to compare the effect of wettability alteration on sand production. Thin sections were immersed in SSW and Nanofluid, the amount of contact angle and sand production were measured in both cases. The amount of sand produced and the contact angle in SSW was higher than the Nanofluid. The silica nanoparticles reduced the contact angle (more water wetting) and by sitting between the sand particles, more than 40%, it reduced sand production.

A Comparison of Different Nanoparticles' Effect on Fine Migration by Low Salinity Water Injection for Oil Recovery: Introducing an Optimum Condition

2021 ◽  
pp. 1-22 ◽  
Author(s):  
Ali Madadizadeh ◽  
Alireza Sadeghein ◽  
Siavash Riahi
Keyword(s):  
Porous Media ◽  
Zeta Potential ◽  
Oil Recovery ◽  
Fine Particles ◽  
Production Equipment ◽  
Water Flooding ◽  
Sand Production ◽  
Low Salinity ◽  
Low Salinity Water ◽  
Salinity Water

Abstract Today, enhance oil recovery (EOR) methods are attracting more attention to increase the petroleum production rate. Some EOR methods such as low salinity water flooding (LSW) can increase the amount of fine migration and sand production in sandstone reservoirs which causes a reduction in permeability and inflict damages on to the reservoir and the production equipment. One of the methods to control fine migration is using nanotechnology. Nanoparticles (NPs) can reduce fine migration by various mechanisms such as reducing the zeta potential of fine particles' surfaces. In this paper, three NPs including SiO2, MgO, and Al2O3 's effects on controlling fine migration and sand production were investigated in two scenarios of pre-flush and co-injection by using sandpack as a porous media sample. When NPs are injected into the porous media sample, the outflow turbidity and zeta potential of particles decreases. Experiments showed that SiO2 has the best effect on controlling fine migration in comparison with other NPs and it could reduce fine migration 69% in pre-flush and 75% in co-injection. Also, MgO and Al2O3 decreased fine migration 65% and 33% in the pre-flush scenario and 49%,13% in the co-injection scenario, respectively.

scholarly journals A mechanistic investigation of low salinity water flooding coupled with ion tuning for enhanced oil recovery

RSC Advances ◽  
2020 ◽  
Vol 10 (69) ◽  
pp. 42570-42583
Author(s):  
Rohit Kumar Saw ◽  
Ajay Mandal
Keyword(s):  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Water Flooding ◽  
Wettability Alteration ◽  
Rock Surface ◽  
Calcite Dissolution ◽  
Low Salinity ◽  
Low Salinity Water ◽  
Mechanistic Investigation ◽  
Salinity Water

The combined effects of dilution and ion tuning of seawater for enhanced oil recovery from carbonate reservoirs. Dominating mechanisms are calcite dissolution and the interplay of potential determining ions that lead to wettability alteration of rock surface.

Enhanced Oil Recovery using Smart Water Injection

2018 ◽  
Vol 24 (8) ◽  
pp. 40
Author(s):  
Hussain Ali Baker ◽  
Kareem A. Alwan ◽  
Saher Faris Fadhil
Keyword(s):  
Oil Recovery ◽  
Water Injection ◽  
Deionized Water ◽  
Water Flooding ◽  
Wettability Alteration ◽  
Formation Water ◽  
Low Salinity ◽  
Smart Water ◽  
Low Salinity Water ◽  
Salinity Water

Smart water flooding (low salinity water flooding) was mainly invested in a sandstone reservoir. The main reasons for using low salinity water flooding are; to improve oil recovery and to give a support for the reservoir pressure. In this study, two core plugs of sandstone were used with different permeability from south of Iraq to explain the effect of water injection with different ions concentration on the oil recovery. Water types that have been used are formation water, seawater, modified low salinity water, and deionized water. The effects of water salinity, the flow rate of water injected, and the permeability of core plugs have been studied in order to summarize the best conditions of low salinity water flooding. The result of this experimental work shows that the water without any free ions (deionized water) and modified low salinity water have improved better oil recovery than the formation water and seawater as a secondary oil process. The increase in oil recovery factor related to the wettability alteration during low salinity water flooding which causes a decrease in the interfacial tension between the crude oil in porous media and the surface of reservoir rocks. As well as the dissolution of minerals such as calcite Ca+2 was observed in this work, which causes an increase in the pH value. All these factors led to change the wettability of rock to be more water-wet, so the oil recovery can be increased.  

Sign in / Sign up

Export Citation Format

Share Document