A Comparison of Different Nanoparticles' Effect on Fine Migration by Low Salinity Water Injection for Oil Recovery: Introducing an Optimum Condition

2021 ◽  
pp. 1-22 ◽  
Author(s):  
Ali Madadizadeh ◽  
Alireza Sadeghein ◽  
Siavash Riahi
Keyword(s):  
Porous Media ◽  
Zeta Potential ◽  
Oil Recovery ◽  
Fine Particles ◽  
Production Equipment ◽  
Water Flooding ◽  
Sand Production ◽  
Low Salinity ◽  
Low Salinity Water ◽  
Salinity Water

Abstract Today, enhance oil recovery (EOR) methods are attracting more attention to increase the petroleum production rate. Some EOR methods such as low salinity water flooding (LSW) can increase the amount of fine migration and sand production in sandstone reservoirs which causes a reduction in permeability and inflict damages on to the reservoir and the production equipment. One of the methods to control fine migration is using nanotechnology. Nanoparticles (NPs) can reduce fine migration by various mechanisms such as reducing the zeta potential of fine particles' surfaces. In this paper, three NPs including SiO2, MgO, and Al2O3 's effects on controlling fine migration and sand production were investigated in two scenarios of pre-flush and co-injection by using sandpack as a porous media sample. When NPs are injected into the porous media sample, the outflow turbidity and zeta potential of particles decreases. Experiments showed that SiO2 has the best effect on controlling fine migration in comparison with other NPs and it could reduce fine migration 69% in pre-flush and 75% in co-injection. Also, MgO and Al2O3 decreased fine migration 65% and 33% in the pre-flush scenario and 49%,13% in the co-injection scenario, respectively.

scholarly journals Investigation of Clay Type on Low Salinity Water Flooding Using a Glass Micromodel

2020 ◽  
Vol 8 ◽  
Author(s):  
Xuemei Wei ◽  
Wenchao Jiang ◽  
Yanyu Zhang ◽  
Zhao Wang ◽  
Xiaojun Li ◽  
...  
Keyword(s):  
Zeta Potential ◽  
Clay Minerals ◽  
Oil Recovery ◽  
Wetting Angle ◽  
Water Flooding ◽  
Residual Oil ◽  
Low Salinity ◽  
Low Salinity Water ◽  
Displacement Experiments ◽  
Salinity Water

Clay minerals are usually regarded as an important factor affecting the results of low salinity water (LSW) flooding. However, experiments on clay minerals are mainly in qualitative stage, the mechanism of clay minerals has not been studied completely. In this paper, Zeta potential of four kinds of clay minerals (montmorillonite; chlorite; illite; kaolinite) in different brine was measured, microscopic models of these clay minerals were made to measured wetting angle in different brine, and montmorillonite and kaolinite were chosen to conduct microscopic displacement experiments through customized micro-glass etching models. From experiment results, the following conclusions can be get: 1). With the decrease of salinity of injected water, the negative zeta potential of clay minerals increases and the wetting angle decreases. 2). Clay minerals are more sensitive to monovalent Na+ than bivalent Ca2+. 3). The results of microscopic experiments show that LSW can effectively improve oil recovery, whether kaolinite or montmorillonite. The recovery of montmorillonite is better with a relatively high salinity of LSW and kaolinite is better with a relatively low salinity of LSW. The mechanism of LSW improves kaolinite recovery factor is the change of wettability while that of montmorillonite is the increase of water phase wettability. However, a lot of droplet-like residual oil cannot be displaced in the montmorillonite throat. In filed production, both kaolinite-rich and montmorillonite-rich reservoirs are suitable for LSW flooding to improve oil recovery. However, for kaolinite reservoirs, a lower salinity of injected water would produce a better result, while for montmorillonite reservoirs, residual oil droplets in the throat are noteworthy.

scholarly journals A mechanistic investigation of low salinity water flooding coupled with ion tuning for enhanced oil recovery

RSC Advances ◽  
2020 ◽  
Vol 10 (69) ◽  
pp. 42570-42583
Author(s):  
Rohit Kumar Saw ◽  
Ajay Mandal
Keyword(s):  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Water Flooding ◽  
Wettability Alteration ◽  
Rock Surface ◽  
Calcite Dissolution ◽  
Low Salinity ◽  
Low Salinity Water ◽  
Mechanistic Investigation ◽  
Salinity Water

The combined effects of dilution and ion tuning of seawater for enhanced oil recovery from carbonate reservoirs. Dominating mechanisms are calcite dissolution and the interplay of potential determining ions that lead to wettability alteration of rock surface.

scholarly journals Modelling Low-Salinity Water Flooding as a Tertiary Oil Recovery Technique

2020 ◽  
Vol 2020 ◽  
pp. 1-9
Author(s):  
Oluwasanmi Olabode ◽  
David Alaigba ◽  
Daniel Oramabo ◽  
Oreofeoluwa Bamigboye
Keyword(s):  
Oil Recovery ◽  
Water Flooding ◽  
High Salinity Water ◽  
Low Salinity ◽  
Low Salinity Water ◽  
First Case ◽  
Short Period ◽  
Tertiary Oil Recovery ◽  
Salinity Water ◽  
Field Production

In this project, low-salinity water flooding has been modeled on ECLIPSE black oil simulator in three cases for a total field production life of twenty-five years. In the first case, low-salinity water flooding starts fifteen years after secondary water flooding. For the second case, low-salinity water flooding starts five years after secondary water flooding and runs till the end of the field production life. For the third case, low-salinity water flooding starts five years after secondary water flooding, but low-salinity water flooding is injected in measured pore volumes for a short period of time; then, high-salinity water flooding was resumed till the end of the field production life. This was done to measure the effect of low-salinity water flooding as slug injection. From the three cases presented, oil recovery efficiency, field oil production rate, and field water cut were observed. Increased percentages of 22.66%, 35.12%, and 26.77% were observed in the three cases, respectively.

scholarly journals A Core Flood and Microfluidics Investigation of Nanocellulose as a Chemical Additive to Water Flooding for EOR

Nanomaterials ◽  
2020 ◽  
Vol 10 (7) ◽  
pp. 1296 ◽  
Author(s):  
Reidun C. Aadland ◽  
Salem Akarri ◽  
Ellinor B. Heggset ◽  
Kristin Syverud ◽  
Ole Torsæter
Keyword(s):  
Contact Angle ◽  
Interfacial Tension ◽  
Oil Recovery ◽  
Cellulose Nanofibrils ◽  
Water Flooding ◽  
Low Salinity ◽  
The Core ◽  
Low Salinity Water ◽  
Salinity Water ◽  
Core Flood

Cellulose nanocrystals (CNCs) and 2,2,6,6-tetramethylpiperidine-1-oxyl (TEMPO)-oxidized cellulose nanofibrils (T-CNFs) were tested as enhanced oil recovery (EOR) agents through core floods and microfluidic experiments. Both particles were mixed with low salinity water (LSW). The core floods were grouped into three parts based on the research objectives. In Part 1, secondary core flood using CNCs was compared to regular water flooding at fixed conditions, by reusing the same core plug to maintain the same pore structure. CNCs produced 5.8% of original oil in place (OOIP) more oil than LSW. For Part 2, the effect of injection scheme, temperature, and rock wettability was investigated using CNCs. The same trend was observed for the secondary floods, with CNCs performing better than their parallel experiment using LSW. Furthermore, the particles seemed to perform better under mixed-wet conditions. Additional oil (2.9–15.7% of OOIP) was produced when CNCs were injected as a tertiary EOR agent, with more incremental oil produced at high temperature. In the final part, the effect of particle type was studied. T-CNFs produced significantly more oil compared to CNCs. However, the injection of T-CNF particles resulted in a steep increase in pressure, which never stabilized. Furthermore, a filter cake was observed at the core face after the experiment was completed. Microfluidic experiments showed that both T-CNF and CNC nanofluids led to a better sweep efficiency compared to low salinity water flooding. T-CNF particles showed the ability to enhance the oil recovery by breaking up events and reducing the trapping efficiency of the porous medium. A higher flow rate resulted in lower oil recovery factors and higher remaining oil connectivity. Contact angle and interfacial tension measurements were conducted to understand the oil recovery mechanisms. CNCs altered the interfacial tension the most, while T-CNFs had the largest effect on the contact angle. However, the changes were not significant enough for them to be considered primary EOR mechanisms.

scholarly journals Development of a Microfluidic Method to Study Enhanced Oil Recovery by Low Salinity Water Flooding

ACS Omega ◽  
2020 ◽  
Vol 5 (28) ◽  
pp. 17521-17530 ◽  
Author(s):  
Marzieh Saadat ◽  
Peichun A. Tsai ◽  
Tsai-Hsing Ho ◽  
Gisle Øye ◽  
Marcin Dudek
Keyword(s):  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Water Flooding ◽  
Low Salinity ◽  
Low Salinity Water ◽  
Salinity Water
Sign in / Sign up

Export Citation Format

Share Document