scholarly journals Convection Heat Transfer Coefficients in Thermoacoustic Heat Exchangers: An Experimental Investigation

Energies ◽  
2019 ◽  
Vol 12 (23) ◽  
pp. 4525 ◽  
Author(s):  
Piccolo ◽  
Sapienza ◽  
Guglielmino
Keyword(s):  
Heat Transfer ◽  
Experimental Data ◽  
Boundary Layer ◽  
Heat Exchanger ◽  
Heat Exchangers ◽  
Convection Heat Transfer ◽  
Convection Heat ◽  
Transfer Coefficients ◽  
Oscillating Flows ◽  
Heat Transfer Coefficients

This paper investigates the thermal performance of thermoacoustic heat exchangers subjected to acoustically oscillating flows. The analysis is carried out by experimental measurements of the heat fluxes sustained by the ambient heat exchanger of a prime mover of the standing wave type. A home-made parallel-plate heat exchanger is considered for the study. The gas-side convection heat transfer coefficients expressed as Nusselt numbers are determined over a wide range of velocity amplitudes of the oscillating flow. The experimental results are then compared to the predictions of a number of theoretical models currently applied in thermoacoustics such as the time-average steady-flow equivalent (TASFE) model, the root mean square Reynolds number (RMS-Re) model, and the boundary layer conduction model. The comparison suggests that the boundary layer model performs better than the rms-Re and TASFE models in predicting the heat transfer coefficients in oscillating flows. The relative difference between the model predictions and the experimental data amounts to 19%. A new correlation law, based on regression of the experimental data, is also proposed.

The Correlation of Heat Transfer Coefficients for the Laminar Natural Convection in a Circular Finned-Tube Heat Exchanger

2017 ◽  
Vol 140 (3) ◽  
Author(s):  
Hie Chan Kang ◽  
Se-Myong Chang
Keyword(s):  
Heat Transfer ◽  
Experimental Data ◽  
Nusselt Number ◽  
Natural Convection ◽  
Heat Exchanger ◽  
Heat Exchangers ◽  
Finned Tube ◽  
Transfer Coefficients ◽  
Heat Transfer Coefficients ◽  
Laminar Natural Convection

This study proposes an empirical correlation for laminar natural convection applicable to external circular finned-tube heat exchangers with wide range of configuration parameters. The transient temperature response of the heat exchangers was used to obtain the heat transfer coefficient, and the experimental data with their characteristic lengths are discussed. The data lie in the range from 1 to 1000 for Rayleigh numbers based on the fin spacing: the ratio of fin height to tube diameter ranges from 0.1 to 0.9, and the ratio of fin pitch to height ranges from 0.13 to 2.6. Sixteen sets of finned-tube electroplated with nickel–chrome were tested. The convective heat transfer coefficients on the heat exchangers were measured by elimination of the thermal radiation effect from the heat exchanger surfaces. The Nusselt number was correlated with a newly suggested composite curve formula, which converges to the quarter power of the Rayleigh number for a single cylinder case. The proposed characteristic length for the Rayleigh number is the fin pitch while that for the Nusselt number is mean flow length, defined as half the perimeter of the mean radial position inside the flow region bounded by the tube surface and two adjacent fins. The flow is regarded as laminar, which covers heat exchangers from a single horizontal cylinder to infinite parallel disks. Consequently, the result of curve fitting for the experimental data shows the reasonable physical interpretation as well as the good quantitative agreement with the correction factors.

Study on Forced Convective Heat Transfer of FC-72 in Vertical Small Tubes

2020 ◽  
Vol 12 (6) ◽  
Author(s):  
Yantao Li ◽  
Yulong Ji ◽  
Katsuya Fukuda ◽  
Qiusheng Liu
Keyword(s):  
Heat Transfer ◽  
Experimental Data ◽  
Convective Heat Transfer ◽  
Convective Heat ◽  
Convection Heat Transfer ◽  
Bulk Liquid ◽  
Transfer Coefficients ◽  
Forced Convective Heat Transfer ◽  
Heat Transfer Coefficients ◽  
Convective Heat Transfer Coefficients

Abstract This paper presents an experimental investigation of the forced convective heat transfer of FC-72 in vertical tubes at various velocities, inlet temperatures, and tube sizes. Exponentially escalating heat inputs were supplied to the small tubes with inner diameters of 1, 1.8, and 2.8 mm and effective heated lengths between 30.1 and 50.2 mm. The exponential periods of heat input range from 6.4 to 15.5 s. The experimental data suggest that the convective heat transfer coefficients increase with an increase in flow velocity and µ/µw (refers to the viscosity evaluated at the bulk liquid temperature over the liquid viscosity estimated at the tube inner surface temperature). When tube diameter and the ratio of effective heated length to inner diameter decrease, the convective heat transfer coefficients increase as well. The experimental data were nondimensionalized to explore the effect of Reynolds number (Re) on forced convection heat transfer coefficient. It was found that the Nusselt numbers (Nu) are influenced by the Re for d = 2.8 mm in the same pattern as the conventional correlations. However, the dependences of Nu on Re for d = 1 and 1.8 mm show different trends. It means that the conventional heat transfer correlations are inadequate to predict the forced convective heat transfer in minichannels. The experimental data for tubes with diameters of 1, 1.8, and 2.8 mm were well correlated separately. And, the data agree with the proposed correlations within ±15%.

Experimental Investigation of Natural Convection Heat Transfer in Volumetrically Heated Spherical Segments

1996 ◽  
Vol 118 (1) ◽  
pp. 31-37 ◽  
Author(s):  
F. J. Asfia ◽  
B. Frantz ◽  
V. K. Dhir
Keyword(s):  
Heat Transfer ◽  
Natural Convection ◽  
Convection Heat Transfer ◽  
Reactor Vessel ◽  
Core Material ◽  
Natural Convection Heat Transfer ◽  
Convection Heat ◽  
Transfer Coefficients ◽  
Heat Transfer Coefficients ◽  
External Cooling

External cooling of a light water reactor vessel by flooding of the concrete cavity with subcooled water is one of several management strategies currently being considered for accidents in which significant relocation of core material is predicted to occur. At present, uncertainty exists with respect to natural convection heat transfer coefficients between the pool of molten core material and the reactor vessel wall. In the present work, experiments were conducted to examine natural convection heat transfer in internally heated partially filled spherical pools with external cooling. In the experiments, Freon-113 was contained in a Pyrex bell jar, which was cooled externally with subcooled water. The pool was heated using a 750 W magnetron taken from a conventional microwave. The pool had a nearly adiabatic free surface. The vessel wall temperature was not uniform and varied from the stagnation point to the free surface. A series of chromel–alumel thermocouples was used to measure temperatures in both steady-state and transient conditions. Each thermocouple was placed in a specific vertical and radial location in order to determine the temperature distribution throughout the pool and along the inner and outer walls of the vessel. In the experiments, pool depth and radius were varied parametrically. Both local and averages heat transfer coefficients based on pool maximum temperature were obtained. Rayleigh numbers based on pool height were varied from 2 × 1010 to 1.1 × 1014. Correlations for the local heat transfer coefficient dependence on pool angle and for the dependence of average Nusselt number on Rayleigh number and pool depth have been developed.

Experimental and Numerical Investigation of Convection Heat Transfer of CO2 at Supercritical Pressures in a Vertical Mini Tube

2004 ◽  
Author(s):  
Pei-Xue Jiang ◽  
Yi-Jun Xu ◽  
Run-Fu Shi ◽  
S. He
Keyword(s):  
Heat Transfer ◽  
Wall Thickness ◽  
Fluid Pressure ◽  
Convection Heat Transfer ◽  
Local Heat Transfer ◽  
Fluid Temperature ◽  
Convection Heat ◽  
Transfer Coefficients ◽  
Bulk Fluid ◽  
Heat Transfer Coefficients

Convection heat transfer of CO2 at supercritical pressures in a vertical mini tube with a diameter of 0.948 mm was investigated experimentally and numerically. The local heat transfer coefficients, bulk fluid temperatures and wall temperatures were measured and presented. The effects of inlet fluid temperature, fluid pressure, mass flow rate, heat flux and wall thickness on the convection heat transfer in the mini tube were investigated. The experimental results were compared with calculated results using well-known correlations and numerical simulations. The results showed that the variable thermophysical properties of supercritical CO2 significantly influenced the convection heat transfer in the vertical mini tube and that for the studied conditions the influence of the wall thickness on the convection heat transfer in the mini tube was not great. For bulk fluid temperatures higher than the pseudo-critical temperature, the simulation results and the correlation results for the convection heat transfer coefficients in the mini tube corresponded well to the experimentally measured results.

Finite Element Predictions of Free Convection Heat Transfer Coefficients of Simulated Electronic Circuit Boards

1989 ◽  
Vol 111 (2) ◽  
pp. 129-134 ◽  
Author(s):  
C. Rajakumar ◽  
D. Johnson
Keyword(s):  
Heat Transfer ◽  
Finite Element ◽  
Convection Heat Transfer ◽  
Circuit Board ◽  
Convection Heat ◽  
Transfer Coefficients ◽  
Heat Transfer Coefficients ◽  
Heating Surfaces ◽  
Free Convection Heat ◽  
Microelectronic Components

A numerical simulation of the buoyancy-induced flow around microelectronic components mounted on a circuit board has been performed using the finite element method. The circuit board is modeled by a vertical plate on which rectangular strip heating surfaces are mounted. Computations have been performed in two-dimensional plane applying a simplifying assumption that the circuit board and the strip heating surfaces are infinitely long. The Navier-Stokes, the flow continuity and the energy equations for laminar flow have been considered in the finite element discretizations. Results of the computations are presented in the form of temperature contour plots and velocity vector plots in the flow field. The convection heat transfer coefficients at the surface of the microelectronic components are presented as a function of their height. The convection coefficients computed have been compared with experimental correlations of free convection heat transfer found in the literature.

Sign in / Sign up

Export Citation Format

Share Document