Evaluating the Multifunctional Performance of Structural Composites for Thermal Energy Storage

The simultaneous need for high specific mechanical properties and thermal energy storage (TES) function, present in several applications (e.g., electric vehicles), can be effectively addressed by multifunctional polymer-matrix composites containing a reinforcing agent and a phase change material (PCM). The PCMs generally decrease the mechanical properties of the host structural composites, but a multifunctional composite can still be beneficial in terms of mass saving, compared to two monofunctional units performing the structural and heat management functions individually. To quantify any possible advantages, this paper proposes an approach that determines the conditions for an effective mass saving at the system level and ranks the investigated structural TES composites with a parameter called multifunctional efficiency. It is found that the potential mass saving is higher when the volume fraction of the reinforcement is kept constant also when the PCM fraction increases or when the single phases (reinforcement, PCM) are themselves multifunctional.

Download Full-text

Phase-Transition Thermal Charging of a Channel-Shape Thermal Energy Storage Unit: Taguchi Optimization Approach and Copper Foam Inserts

Molecules ◽

10.3390/molecules26051235 ◽

2021 ◽

Vol 26 (5) ◽

pp. 1235

Author(s):

Mohammad Ghalambaz ◽

Seyed Abdollah Mansouri Mehryan ◽

Ahmad Hajjar ◽

Obai Younis ◽

Mikhail A. Sheremet ◽

...

Keyword(s):

Energy Storage ◽

Phase Change ◽

Thermal Energy ◽

Thermal Energy Storage ◽

Metal Foam ◽

Volume Fraction ◽

Foam Layer ◽

Storage Unit ◽

Energy Storage Unit ◽

Copper Foam

Thermal energy storage is a technique that has the potential to contribute to future energy grids to reduce fluctuations in supply from renewable energy sources. The principle of energy storage is to drive an endothermic phase change when excess energy is available and to allow the phase change to reverse and release heat when energy demand exceeds supply. Unwanted charge leakage and low heat transfer rates can limit the effectiveness of the units, but both of these problems can be mitigated by incorporating a metal foam into the design of the storage unit. This study demonstrates the benefits of adding copper foam into a thermal energy storage unit based on capric acid enhanced by copper nanoparticles. The volume fraction of nanoparticles and the location and porosity of the foam were optimized using the Taguchi approach to minimize the charge leakage expected from simulations. Placing the foam layer at the bottom of the unit with the maximum possible height and minimum porosity led to the lowest charge time. The optimum concentration of nanoparticles was found to be 4 vol.%, while the maximu possible concentration was 6 vol.%. The use of an optimized design of the enclosure and the optimum fraction of nanoparticles led to a predicted charging time for the unit that was approximately 58% shorter than that of the worst design. A sensitivity analysis shows that the height of the foam layer and its porosity are the dominant variables, and the location of the porous layer and volume fraction of nanoparticles are of secondary importance. Therefore, a well-designed location and size of a metal foam layer could be used to improve the charging speed of thermal energy storage units significantly. In such designs, the porosity and the placement-location of the foam should be considered more strongly than other factors.

Download Full-text