scholarly journals Improving PSI Processing of Mining Induced Large Deformations with External Models

2020 ◽  
Vol 12 (19) ◽  
pp. 3145
Author(s):  
Sen Du ◽  
Jordi J. Mallorqui ◽  
Hongdong Fan ◽  
Meinan Zheng
Keyword(s):  
Ground Deformation ◽  
Ground Truth ◽  
Deformation Monitoring ◽  
Persistent Scatterer Interferometry ◽  
Mining Operations ◽  
Sar Images ◽  
Temporal Behaviour ◽  
Persistent Scatterer ◽  
Large Gradient ◽  
External Model

Ground subsidences, either caused by natural phenomena or human activities, can threaten the safety of nearby infrastructures and residents. Among the different causes, mining operations can trigger strong subsidence phenomena with a fast nonlinear temporal behaviour. Therefore, a reliable and precise deformation monitoring is of great significance for safe mining and protection of facilities located above or near the mined-out area. Persistent Scatterer Interferometry (PSI) is a technique that uses stacks Synthetic Aperture Radar (SAR) images to remotely monitor the ground deformation of large areas with a high degree of precision at a reasonable cost. Unfortunately, PSI presents limitations when monitoring large gradient deformations when there is phase ambiguity among adjacent Persistent Scatterer (PS) points. In this paper, an improvement of PSI processing, named as External Model-based Deformation Decomposition PSI (EMDD-PSI), is proposed to address this limitation by taking advantage of an external model. The proposed method first uses interferograms generated from SAR Single Look Complex (SLC) images to optimize the parameter adjustments of the external model. Then, the modelled spatial distribution of subsidence is utilized to reduce the fringes of the interferograms generated from the SAR images and to ease the PSI processing. Finally, the ground deformation is retrieved by jointly adding the external model and PSI results. In this paper, fourteen Radarsat-2 SAR images over Fengfeng mining area (China) are used to demonstrate the capabilities of the proposed method. The results are evaluated by comparing them with leveling data of the area covering the same temporal period. Results have shown that, after the optimization, the model is able to mimic the real deformation and the fringes of the interferograms can be effectively reduced. As a consequence, the large gradient deformation then can be better retrieved with the preservation of the nonlinear subsidence term. The ground truth shows that, comparing with the classical PSI and PSI with unadjusted parameters, the proposed scheme reduces the error by 35.2% and 20.4%, respectively.

scholarly journals DEFORMATION MONITORING USING SATELLITE RADAR INTERFEROMETRY

2020 ◽  
Vol IV-3/W2-2020 ◽  
pp. 1-6
Author(s):  
M. Crosetto ◽  
L. Solari
Keyword(s):  
Deformation Monitoring ◽  
Radar Interferometry ◽  
National Scale ◽  
Persistent Scatterer Interferometry ◽  
Sar Images ◽  
Persistent Scatterer ◽  
Main Factors ◽  
Satellite Radar ◽  
Processing Techniques ◽  
Monitoring Service

Abstract. The paper is focused on the Persistent Scatterer Interferometry (PSI) technique. First, it addresses the substantial evolution of PSI in the last twenty years. Three main factors are identified: the availability of SAR images, the development of advanced data processing techniques, and the increase of the computation capability. The paper then addresses the PSI deformation monitoring initiatives at regional and national scale. Finally, in the last section, it is described a pan European deformation monitoring service: the European Ground Motion Service (EGMS).

scholarly journals Using PS-InSAR with Sentinel-1 Images for Deformation Monitoring in Northeast Algeria

Geosciences ◽  
2019 ◽  
Vol 9 (7) ◽  
pp. 315
Author(s):  
Omar Beladam ◽  
Timo Balz ◽  
Bahaa Mohamadi ◽  
Mahdjoub Abdalhak
Keyword(s):  
Ground Deformation ◽  
Regional Scale ◽  
Deformation Monitoring ◽  
Slope Instability ◽  
Radar Interferometry ◽  
Persistent Scatterer Interferometry ◽  
Accurate Identification ◽  
The North ◽  
Persistent Scatterer ◽  
Ground Deformation Monitoring

Constantine city, Algeria, and its surroundings have always been affected by natural and human-induced slope instability and subsidence. Neogene clay-conglomeratic formations, which form the largest part of Constantine city, are extremely sensitive to the presence of water, which makes them susceptible to landslides. Fast and accurate identification and monitoring of the main areas facing existing or potential hazardous risks at a regional scale, as well as measuring the amount of displacement is essential for the conservation and sustainable development of Constantine. In the last three decades, the application of radar interferometry techniques for the measurement of millimeter-level terrain motions has become one of the most powerful tools for ground deformation monitoring due to its large coverage and low costs. Persistent scatterer interferometry (PS-InSAR) has a demonstrated potential for monitoring a range of hazard event scenarios and tracking their spatiotemporal evolution. We demonstrate the efficiency of Sentinel-1 data for deformation monitoring in Constantine located in the northeast of Algeria, and how an array of information such as geological maps and ground-measurements are integrated for deformation mapping. We conclude this article with a discussion of the potential of advanced differential radar interferometry approaches and their applicability for structural and ground deformation monitoring, including the advantages and challenges of these approaches in the north of Algeria.

scholarly journals Measuring Urban Subsidence in the Rome Metropolitan Area (Italy) with Sentinel-1 SNAP-StaMPS Persistent Scatterer Interferometry

2019 ◽  
Vol 11 (2) ◽  
pp. 129 ◽  
Author(s):  
José Delgado Blasco ◽  
Michael Foumelis ◽  
Chris Stewart ◽  
Andrew Hooper
Keyword(s):  
Ground Deformation ◽  
European Space Agency ◽  
Vertical Motion ◽  
Automatic Processing ◽  
Deformation Monitoring ◽  
Geographical Information ◽  
Persistent Scatterer Interferometry ◽  
Persistent Scatterers ◽  
Processing Chain ◽  
Persistent Scatterer

Land subsidence in urban environments is an increasingly prominent aspect in the monitoring and maintenance of urban infrastructures. In this study we update the subsidence information over Rome and its surroundings (already the subject of past research with other sensors) for the first time using Copernicus Sentinel-1 data and open source tools. With this aim, we have developed a fully automatic processing chain for land deformation monitoring using the European Space Agency (ESA) SentiNel Application Platform (SNAP) and Stanford Method for Persistent Scatterers (StaMPS). We have applied this automatic processing chain to more than 160 Sentinel-1A images over ascending and descending orbits to depict primarily the Line-Of-Sight ground deformation rates. Results of both geometries were then combined to compute the actual vertical motion component, which resulted in more than 2 million point targets, over their common area. Deformation measurements are in agreement with past studies over the city of Rome, identifying main subsidence areas in: (i) Fiumicino; (ii) along the Tiber River; (iii) Ostia and coastal area; (iv) Ostiense quarter; and (v) Tivoli area. Finally, post-processing of Persistent Scatterer Inteferometry (PSI) results, in a Geographical Information System (GIS) environment, for the extraction of ground displacements on urban infrastructures (including road networks, buildings and bridges) is considered.

scholarly journals Deformation Monitoring Using Sentinel-1 SAR Data

Proceedings ◽  
2018 ◽  
Vol 2 (7) ◽  
pp. 344 ◽  
Author(s):  
Núria Devanthéry ◽  
Michele Crosetto ◽  
Oriol Monserrat ◽  
María Cuevas-González ◽  
Bruno Crippa
Keyword(s):  
Earth Observation ◽  
Deformation Monitoring ◽  
Synthetic Aperture ◽  
Persistent Scatterer Interferometry ◽  
Sar Images ◽  
Persistent Scatterer ◽  
Deformation Velocity ◽  
Different Types ◽  
Processing Steps ◽  
Deformation Measurements

Satellite earth observation enables the monitoring of different types of natural hazards, contributing to the mitigation of their fatal consequences. In this paper, satellite Synthetic Aperture Radar (SAR) images are used to derive terrain deformation measurements. The images acquired with the ESA satellites Sentinel-1 are used. In order to fully exploit these images, two different approaches to Persistent Scatterer Interferometry (PSI) are used, depending on the characteristics of the study area and the available images. The main processing steps of the two methods, i.e.; the simplified and the full PSI approach, are described and applied over an area of 7500 km2 located in Catalonia (Spain). The deformation velocity map and deformation time series are analysed in the last section of the paper.

scholarly journals A Review of Ten-Year Advances of Multi-Baseline SAR Interferometry Using TerraSAR-X Data

2018 ◽  
Vol 10 (9) ◽  
pp. 1374 ◽  
Author(s):  
Xiao Zhu ◽  
Yuanyuan Wang ◽  
Sina Montazeri ◽  
Nan Ge
Keyword(s):  
Spatial Resolution ◽  
Deformation Monitoring ◽  
Sar Interferometry ◽  
Synthetic Aperture ◽  
Geometric Accuracy ◽  
Persistent Scatterer Interferometry ◽  
Sar Images ◽  
Orbit Control ◽  
Absolute Positioning ◽  
Persistent Scatterer

Since its launch in 2007, TerraSAR-X has continuously provided spaceborne synthetic aperture radar (SAR) images of our planet with unprecedented spatial resolution, geodetic, and geometric accuracy. This has brought life to the once inscrutable SAR images, which deterred many researchers. Thanks to merits like higher spatial resolution and more precise orbit control, we are now able to indicate individual buildings, even individual floors, to pinpoint targets within centimeter accuracy. As a result, multi-baseline SAR interferometric (InSAR) techniques are flourishing, from point target-based algorithms, to coherent stacking techniques, to absolute positioning of the former techniques. This article reviews the recent advances of multi-baseline InSAR techniques using TerraSAR-X images. Particular focus was put on our own development of persistent scatterer interferometry, SAR tomography, robust estimation in distributed scatterer interferometry and absolute positioning using geodetic InSAR. Furthermore, by introducing the applications associated with these techniques, such as 3D reconstruction and deformation monitoring, this article is also intended to give guidance to wider audiences who would like to resort to SAR data and related techniques for their applications.

scholarly journals Polarimetric Persistent Scatterer Interferometry for Ground Deformation Monitoring with VV-VH Sentinel-1 Data

2022 ◽  
Vol 14 (2) ◽  
pp. 309
Author(s):  
Feng Zhao ◽  
Teng Wang ◽  
Leixin Zhang ◽  
Han Feng ◽  
Shiyong Yan ◽  
...  
Keyword(s):  
Urban Areas ◽  
Ground Deformation ◽  
Deformation Monitoring ◽  
Adaptive Optimization ◽  
Persistent Scatterer Interferometry ◽  
Quality Metric ◽  
Persistent Scatterer ◽  
First Choice ◽  
Ground Deformation Monitoring ◽  
Different Characteristics

With the launch of the Sentinel-1 satellites, it becomes easy to obtain long time-series dual-pol (i.e., VV and VH channels) SAR images over most areas of the world. By combining the information from both VV and VH channels, the polarimetric persistent scatterer interferometry (PolPSI) techniques is supposed to achieve better ground deformation monitoring results than conventional PSI techniques (using only VV channel) with Sentinel-1 data. According to the quality metric used for polarimetric optimizations, the most commonly used PolPSI techniques can be categorized into three main categories. They are PolPSI-ADI (amplitude dispersion index as the phase quality metric), PolPSI-COH (coherence as the phase quality metric), and PolPSI-AOS (taking adaptive optimization strategies). Different categories of PolPSI techniques are suitable for different study areas and with different performances. However, the study that simultaneously applies all the three types of PolPSI techniques on Sentinel-1 PolSAR images is rare. Moreover, there has been little discussion about different characteristics of the three types of PolPSI techniques and how to use them with Sentinel-1 data. To this end, in this study, three data sets in China have been used to evaluate the three types of PolPSI techniques’ performances. Based on results obtained, the different characteristics of PolPSI techniques have been discussed. The results show that all three PolPSI techniques can improve the phase quality of interferograms. Thus, more qualified pixels can be used for ground deformation estimation by PolPSI methods with respect to the PSI technique. Specifically, this pixel density improvement is 50%, 12%, and 348% for the PolPSI-ADI, PolPSI-COH, and POlPSI-AOS, respectively. PolPSI-ADI is the most efficient method, and it is the first choice for the area with abundant deterministic scatterers (e.g., urban areas). Benefitting from its adaptive optimization strategy, PolPSI-AOS has the best performances at the price of highest computation cost, which is suitable for rural area applications. On the other hand, limited by the medium resolution of Sentinel-1 PolSAR images, PolPSI-COH’s improvement with respect to conventional PSI is relatively insignificant.

scholarly journals GROUND DEFORMATION MONITORING AT CONTINENTAL SCALE: THE EUROPEAN GROUND MOTION SERVICE

2020 ◽  
Vol XLIII-B3-2020 ◽  
pp. 293-298
Author(s):  
M. Crosetto ◽  
L. Solari ◽  
J. Balasis-Levinsen ◽  
N. Casagli ◽  
M. Frei ◽  
...  
Keyword(s):  
Ground Motion ◽  
Ground Deformation ◽  
Rapid Evolution ◽  
Deformation Monitoring ◽  
Persistent Scatterer Interferometry ◽  
Wide Area Monitoring ◽  
Continental Scale ◽  
Regional Deformation ◽  
Ground Deformation Monitoring ◽  
Monitoring Service

Abstract. The Persistent Scatterer Interferometry is a powerful technique for ground motion detection and monitoring over wide areas. In the recent years, PSI has undergone a rapid evolution, largely thanks to the launch of the Copernicus Sentinel-1 constellation, the refinement of algorithms, and the increased computational capabilities. These factors allow for using Sentinel-1 interferometric data to develop ground deformation services for wide-area monitoring. Firstly, we review examples of services for national or regional deformation monitoring. The paper then describes the European Ground Motion Service (EGMS), part of the Copernicus Land Monitoring Service. The EGMS represents a unique initiative for performing ground deformation monitoring on a European scale.

Sign in / Sign up

Export Citation Format

Share Document