scholarly journals Optimal Relay Selection Scheme with Multiantenna Power Beacon for Wireless-Powered Cooperation Communication Networks

Sensors ◽  
2020 ◽  
Vol 21 (1) ◽  
pp. 147
Author(s):  
Oussama Messadi ◽  
Aduwati Sali ◽  
Vahid Khodamoradi ◽  
Asem A. Salah ◽  
Gaofeng Pan ◽  
...  

Unlike the fixed power grid cooperative networks, which are mainly based on the reception reliability parameter while choosing the best relay, the wireless-powered cooperative communication network (WPCCN) and in addition to the reception reliability the transmission requirement consideration is important for relay selection schemes. Hence, enabling efficient transmission techniques that address high attenuation of radio frequency (RF) signals according to the distance without increasing the total transmission power is an open issue worth studying. In this relation, a multiantennas power beacon (PB) that assists wireless-powered cooperative communication network (PB-WPCCN) is studied in this paper. The communication between source and destination is achieved with the aid of multiple relays, where both the source and the multiple relays need to harvest energy from the PB in the first place to enable their transmission functionalities. A novel relay selection scheme is proposed, named as two-round relay selection (2-RRS), where a group of relays that successfully decode the source information is selected in the first round selection. In the second round, the optimal relay is selected to forward the recorded information to the destination. The proposed 2-RRS scheme is compared with two existing relay selection schemes, i.e., partial relay selection (PRS) and opportunistic relay selection (ORS). The analytical closed-form expressions of outage probability and average system throughput are derived and validated by numerical simulation. The comparison results between different relay selection schemes show: (I) The superiority of the proposed 2-RRS scheme as it achieves around 17% better throughput compared to the conventional ORS scheme and 40% better than the PRS scheme, particularly when PB transmit power is 10 dB; (II) The proposed 2-RRS scheme guarantees the lowest outage probability, especially when the PB is equipped with multiantennas and performs beamforming technique; (III) The optimal localisation of the PB between the source and N relays depends on the adopted relay selection scheme; (IV) The exhaustive search of the maximum system throughput value shows that the proposed 2-RRS scheme required shorter energy harvesting time compared to other schemes. The increase in energy harvesting time and number of relays do not necessarily reflect positively on the system throughput performance; hence tradeoffs should be taken into consideration.

2013 ◽  
Vol 397-400 ◽  
pp. 1979-1983
Author(s):  
Dong Chen ◽  
Xiang Li ◽  
Li Ping Su ◽  
Jin Liang

This paper addresses the enhanced power allocation (PA) and relay selection scheme (RS) in two-way relaying cognitive radio networks consisting of multiple user-pairs and multiple relays. In order to reduce the computational complexity for practical scenario, we propose a branch and bound based (BnB-based) power allocation and relay selection scheme and a greedy power allocation and relay selection scheme to maximize the system throughput. Simulation results show that the proposed BnB-based PA and RS scheme can achieve better tradeoff of system throughput and complexity.


IEEE Access ◽  
2019 ◽  
Vol 7 ◽  
pp. 36246-36258 ◽  
Author(s):  
Ghulam Shabbir ◽  
Jamil Ahmad ◽  
Waseem Raza ◽  
Yasar Amin ◽  
Adeel Akram ◽  
...  

2018 ◽  
Vol 2018 ◽  
pp. 1-8
Author(s):  
Jie Li ◽  
Jianrong Bao ◽  
Shenji Luan ◽  
Bin Jiang ◽  
Chao Liu

To improve the reliability and efficiency in cooperative communications, a power optimized single relay selection scheme is proposed by increasing the diversity effort with an improved link-adaptive-regenerative (ILAR) protocol. The protocol determines the forwarding power of a relay node by comparing the signal-to-noise ratio (SNR) at both sides of the node; thus it improves the power efficiency. Moreover, it also proposes a single relay selection strategy to maximize the instantaneous SNR product, which ensures the approximate best channel link quality for good relay forwarding. And the system adjusts the forwarding power in real time and also selects the best relay node participated in the cooperative forwarding. In addition, the cooperation in the protocol is analyzed and the approximate expression of the bit-error-rate (BER) and the outage probability at high SNRs are also derived. Simulation results indicate that the BER and outage probability of the relay selection scheme by the ILAR protocol outperform other contrast schemes of current existing protocols. At BER of 10−2, the proposed scheme with ILAR protocol outperforms those of the decoded-and-forward (DF), the selected DF (SDF), and the amplify-and-forward (AF) protocols by 3.5, 3.5 and 7 dB, respectively. Moreover, the outage probability of the relay system decreases with the growth of the relay number. Therefore, the proposed relay selection scheme with ILAR strategies can be properly used in cooperative communications for good reliability and high power efficiency.


Energies ◽  
2019 ◽  
Vol 12 (13) ◽  
pp. 2579 ◽  
Author(s):  
Van-Duc Phan ◽  
Tan N. Nguyen ◽  
Minh Tran ◽  
Tran Thanh Trang ◽  
Miroslav Voznak ◽  
...  

In this time, energy efficiency (EE), measured in bits per Watt, has been considered as an important emerging metric in energy-constrained wireless communication networks because of their energy shortage. In this paper, we investigate power beacon assisted (PB) energy harvesting (EH) in half-duplex (HD) communication network under co-channel Interferer over Rayleigh fading environment. In this work, we investigate the model system with the time switching (TS) protocol. Firstly, the exact and asymptotic form expressions of the outage probability (OP) are analyzed and derived. Then the system EE is investigated and the influence of the primary system parameters on the system performance. Finally, we verify the correctness of the analytical expressions using Monte Carlo simulation. Finally, we can state that the simulation and analytical results are the same.


Sign in / Sign up

Export Citation Format

Share Document