scholarly journals Simultaneous Allocation of Distributed Generators and Shunt Capacitors in a Distribution System

2019 ◽  
Vol 17 (1) ◽  
pp. 35-50
Author(s):  
Suresh Kumar Sudabattula ◽  
Kowsalya Muniswamy ◽  
Velamuri Suresh
Keyword(s):  
Case Studies ◽  
Distribution System ◽  
Distribution Systems ◽  
Optimal Allocation ◽  
Sensitivity Factor ◽  
Voltage Profile ◽  
Distributed Generators ◽  
Intelligent Technique ◽  
Power Load ◽  
Shunt Capacitors

Performance of a distribution system is negatively affected with the usage of non linear loads and rapid growth in electricity demand. It is possible to improve the voltage profile and reduce the power loss in a distribution system, by integrating distributed generators (DGs) and shunt capacitors (SCs). Identifying the optimal location and capacity of DGs and SCsare the crucial factors affecting the DS performance. This paper aims to reduce the power losses in the DS and facilitates an improvement in voltage profile with optimal allocation of DGs and SCs. First, the vulnerable nodes for placement of DGs and SCs are identified by loss sensitivity factor (LSF) technique. Next, the sizes of SCs and DGs at these corresponding locations are determined using a recently developed swarm intelligent technique dragonfly algorithm (DFA). Various constraints of the DS are included to estimate the objective function. To analyze the performance of the proposed method it is investigated on IEEE 69 bus radial distribution systems (RDS) considering constant power load at different load levels. Several case studies are conducted to analyze the performance of the DS. Three different load levels at different power factors are considered in the study. Initially few case studies are performed by considering single DG and single SC. Further the analyses are extended with multiple DGs and SCs. Finally, the proposed method is compared with other prominent methods accessible in the literature. It can be inferred from the analyses that simultaneous allocation of DGs and SCs in DS improves the overall performance of the system.

Optimal allocation of Multiple Distributed Generators and Shunt Capacitors in a Distribution System using Political Optimization Algorithm

2021 ◽  
pp. 1478-1488
Keyword(s):  
Optimization Algorithm ◽  
Distribution System ◽  
Power Loss ◽  
Optimal Allocation ◽  
Reactive Power ◽  
Sensitivity Factor ◽  
Combined Approach ◽  
Voltage Profile ◽  
Distributed Generators ◽  
Shunt Capacitors

To meet the increasing real & reactive power demand of a distribution system (DS), it is essential to allocate the Distributed Generators (DGs) and Shunt capacitors (SCs) optimally. In this article, multiple DGs and SCs are allocated simultaneously in the DS aiming minimal power loss (PL), improved voltage stability index (VSI) and voltage profile of the system. A combined approach considering loss sensitivity factor (LSF) and political optimization algorithm (POA) is proposed to solve the allocation and sizing of DGs and SCs. The analysis is performed on an IEEE 33 bus system considering 9 different scenarios and results are compared with other Meta heuristic techniques. The analysis is extended for a 24 hour case study to prove the efficacy of the proposed combined approach. From all the performed simulations it can be observed that the combined approach helps in minimizing power loss and improving voltage profile and VSI for dynamic load variations effectively.

scholarly journals Atom Search Optimization Algorithm for Allocating Distributed Generators in Radial Distribution Systems

2021 ◽  
Vol 264 ◽  
pp. 04084
Author(s):  
Ikrom Khonturaev ◽  
Mansur Khasanov ◽  
Muhiddin Anarbaev ◽  
Abror Kurbanov ◽  
Anvar Suyarov ◽  
...  
Keyword(s):  
Radial Distribution ◽  
Distribution System ◽  
Distribution Systems ◽  
Optimal Allocation ◽  
Renewable Energy Sources ◽  
Hybrid Approach ◽  
Voltage Profile ◽  
Fuel Prices ◽  
Distributed Generators ◽  
Search Optimization

In recent years the use of renewable energy sources (RES) by many power grid companies worldwide has increased significantly. The trend towards RES use is mainly due to environmental issues and rising fuel prices associated with conventional electricity generation. This paper introduces a hybrid approach to find the optimal location and size of distributed generations (DG) in the radial distribution system (RDS). The proposed approach is based on the atom search optimization (ASO) technique to calculate the optimal allocation of DGs and power loss sensitivity (PLS) index to obtain the best buses for DGs installation in RDS. The presented approach is applied to IEEE 33-bus RDS to increase voltage profile and minimize the power losses. The results obtained prove that the developed approach can be highly effective in integrating DG into RDS compared to many other methods in the literature.

scholarly journals A New Hybrid Technique for Minimizing Power Losses in a Distribution System by Optimal Sizing and Siting of Distributed Generators with Network Reconfiguration

Energies ◽  
2018 ◽  
Vol 11 (12) ◽  
pp. 3351 ◽  
Author(s):  
Mirna Abd El-salam ◽  
Eman Beshr ◽  
Magdy Eteiba
Keyword(s):  
Case Studies ◽  
Distribution System ◽  
Distribution Systems ◽  
Grey Wolf Optimizer ◽  
Hybrid Technique ◽  
Network Reconfiguration ◽  
Voltage Profile ◽  
Power Losses ◽  
Particle Swarm Optimizer ◽  
Distributed Generators

Transformations are taking place within the distribution systems to cope with the congestions and reliability concerns. This paper presents a new technique to efficiently minimize power losses within the distribution system by optimally sizing and placing distributed generators (DGs) while considering network reconfiguration. The proposed technique is a hybridization of two metaheuristic-based algorithms: Grey Wolf Optimizer (GWO) and Particle Swarm Optimizer (PSO), which solve the network reconfiguration problem by optimally installing different DG types (conventional and renewable-based). Case studies carried out showed the proposed hybrid technique outperformed each algorithm operating individually regarding both voltage profile and reduction in system losses. Case studies are carried to measure and compare the performance of the proposed technique on three different works: IEEE 33-bus, IEEE 69-bus radial distribution system, and an actual 78-bus distribution system located at Cairo, Egypt. The integration of renewable energy with the distribution network, such as photovoltaic (PV) arrays, is recommended since Cairo enjoys an excellent actual record of irradiance according to the PV map of Egypt.

scholarly journals A new meta-heuristic pathfinder algorithm for solving optimal allocation of solar photovoltaic system in multi-lateral distribution system for improving resilience

2021 ◽  
Vol 3 (1) ◽  
Author(s):  
Varaprasad Janamala
Keyword(s):  
Distribution System ◽  
Distribution Systems ◽  
Voltage Stability ◽  
Optimal Allocation ◽  
Photovoltaic System ◽  
Solar Photovoltaic ◽  
Voltage Profile ◽  
Pv System ◽  
Solar Photovoltaic System ◽  
The Impact

AbstractA new meta-heuristic Pathfinder Algorithm (PFA) is adopted in this paper for optimal allocation and simultaneous integration of a solar photovoltaic system among multi-laterals, called interline-photovoltaic (I-PV) system. At first, the performance of PFA is evaluated by solving the optimal allocation of distribution generation problem in IEEE 33- and 69-bus systems for loss minimization. The obtained results show that the performance of proposed PFA is superior to PSO, TLBO, CSA, and GOA and other approaches cited in literature. The comparison of different performance measures of 50 independent trail runs predominantly shows the effectiveness of PFA and its efficiency for global optima. Subsequently, PFA is implemented for determining the optimal I-PV configuration considering the resilience without compromising the various operational and radiality constraints. Different case studies are simulated and the impact of the I-PV system is analyzed in terms of voltage profile and voltage stability. The proposed optimal I-PV configuration resulted in loss reduction of 77.87% and 98.33% in IEEE 33- and 69-bus systems, respectively. Further, the reduced average voltage deviation index and increased voltage stability index result in an improved voltage profile and enhanced voltage stability margin in radial distribution systems and its suitability for practical applications.

scholarly journals Optimal Allocation of Capacitor Bank for Loss Minimization and Voltage Improvement Using Analytical Method

SCITECH Nepal ◽  
2019 ◽  
Vol 14 (1) ◽  
pp. 1-7
Author(s):  
Avinash Khatri KC ◽  
Tika Ram Regmi
Keyword(s):  
Distribution System ◽  
Distribution Systems ◽  
Optimal Allocation ◽  
Reactive Power ◽  
Capacitor Bank ◽  
Minimum Cost ◽  
Distribution Networks ◽  
Standard Test ◽  
Load Flow ◽  
Voltage Profile

An electric distribution system plays an important role in achieving satisfactory power supply. The quality of power is measured by voltage stability and profile of voltage. The voltage profile is affected by the losses in distribution system. As the load is mostly inductive on the distribution system and requires large reactive power, most of the power quality problems can be resolved with requisite control of reactive power. Capacitors are often installed in distribution system for reactive power compensation. This paper presents two stage procedures to identify the location and size of capacitor bank. In the first stage, the load flow is carried out to find the losses of the system using sweep algorithm. In the next stage, different size of capacitors are initialized and placed in each possible candidate bus and again load flow for the system is carried out. The objective function of the cost incorporating capacitor cost and loss cost is formulated constrained with voltage limits. The capacitor with the minimum cost is selected as the optimized solution. The proposed procedure is applied to different standard test systems as 12-bus radial distribution systems. In addition, the proposed procedure is applied on a real distribution system, a section of Sallaghari Feeder of Thimi substation. The voltage drops and power loss before and after installing the capacitor were compared for the system under test in this work. The result showed better voltage profiles and power losses of the distribution system can be improved by using the proposed method and it can be a benefit to the distribution networks.

scholarly journals A Review of Cuckoo Search Algorithm Based Optimal Siting and Sizing of Shunt Capacitors in Radial Distribution Systems

2019 ◽  
Vol 1 (2) ◽  
Author(s):  
O.E. Olabode
Keyword(s):  
Radial Distribution ◽  
Distribution Systems ◽  
Reactive Power ◽  
Heuristic Algorithms ◽  
Search Algorithm ◽  
Cuckoo Search ◽  
Cuckoo Search Algorithm ◽  
Sensitivity Factor ◽  
Voltage Profile ◽  
Shunt Capacitors

Compensating reactive power deficiency on power grids is a central concern in the distribution of energy management systems. Several approaches have been adopted over time to minimize the total real power loss and enhancing bus voltage profile. Shunt capacitor has been used from time immemorial for addressing issue of reactive power compensation at the distribution end of power systems, and the extent of benefits derivable from its usage depend solely on correct siting and sizing. To this effect, meta-heuristic algorithms are promising optimization tools for achieving these objectives. This paper, therefore, presents a comprehensive review of cuckoo search algorithm based on optimal siting and sizing of shunt capacitors in radial distribution systems. The suitability, in addition to strengths and weakness of each approaches reported in the reviewed articles have been painstakingly x-rayed. Based on the review, it was observed that a two-stage approach is always adopted in the compensation process: the pre-selection of potential or sensitive nodes and the optimal sizing of shunt capacitors needed for the compensation. For the pre-location, Voltage Stability Index and Loss Sensitivity Factor were found to be comparatively less complex and highly suitable techniques. Another cogent discovery from this review is that less attention has been drawn to the use of cuckoo search algorithm by Nigerian researchers. Therefore, regarding Nigerian electric grid system, the use of cuckoo search algorithm in reactive power support presents a research gap for further investigations.

scholarly journals Multi-Objective Optimal Placement of Distributed Generators by Modified BAT Algorithm

2020 ◽  
Vol 9 (7) ◽  
pp. 86-91
Keyword(s):  
Distribution System ◽  
Distribution Systems ◽  
Electrical Power ◽  
Optimal Placement ◽  
Voltage Profile ◽  
Electrical Power System ◽  
Continuous Growth ◽  
Distributed Generators ◽  
Load Demand ◽  
Modified Bat Algorithm

Day by day the need for electrical power is increasing due to the continuous growth and development in the social and economical status of the society. By and large in conventional electrical power system network, power flows from generating stations through transmission and distribution system to the end user. The demand for electrical power at the distribution systems is also increasing continuously. In order to meet the increase in the demand for the electrical power, it is required to increase the existing capacities of the generation and transmission & distribution system that involves lot of money and is a time consuming process. The best solution for this problem of increase in load demand is perfectly met with electric power generating units of smaller capacity which are going to be installed locally in the distribution system and are termed as “Distributed Generators (DGs)”. DGs not only supplies electrical power that meets the increase in load demand but also reduces the losses, improves the voltage profile and reliability of the system. To get maximum of these benefits, DGs are to be installed at its best optimal locations and are to be operated at its optimal generating capacities. In this work an algorithm based on MBAT is proposed to find the optimal locations and sizes of the DG units by considering the minimization of multiple objective functions like minimization of real power loss, cost function and total voltage deviation. The proposed algorithm is tested on IEEE-33 radial distribution systems and results are presented.

Sign in / Sign up

Export Citation Format

Share Document