Estimation Method for Impact Location of Loose Parts Based on Hilbert Transform

2009 ◽  
Vol 45 (12) ◽  
pp. 232
Author(s):  
Jiangxin YANG
2006 ◽  
Vol 48 (4) ◽  
pp. 360-370 ◽  
Author(s):  
Gee Yong Park ◽  
Se Woo Cheon ◽  
Cheol Kwon Lee ◽  
Kee Choon Kwon

2015 ◽  
Vol 26 (9) ◽  
pp. 095003 ◽  
Author(s):  
Yan-lin Shen ◽  
Ya-qing Tu ◽  
Lin-jun Chen ◽  
Ting-ao Shen

2020 ◽  
Vol 2020 ◽  
pp. 1-13
Author(s):  
Jiangzehui Yan ◽  
Luping Xu ◽  
Chunhua Li ◽  
Weihao Tie ◽  
Xuerong Sun

The research interest of ultrawideband (UWB) discharge source location estimation has increased these years. In this paper, a direction of arrival (DOA) estimation method using multiple baseline wideband time-domain interferometry with Hilbert transform for UWB discharge source is proposed based on time-domain and frequency-domain characteristics of radiated RF electromagnetic pulses (EMPs) from discharge sources. Monte Carlo simulations are then carried out; the results indicate that, the proposed method provides a better performance in UWB discharge source DOA estimation than the traditional time-domain method, especially in low signal-to-noise ratio (SNR) conditions. Moreover, the influences of antenna array configurations and incident angles of radiated EMPs on the estimation precision are also studied. It has been shown that, the accuracy of both elevation angle and azimuth angle estimation improves with the increase of the antenna element number and baseline length. As for the influence of incident angles, the estimation accuracy of elevation angle enhances when real elevation angle increases, while that of azimuth angle tends to be opposite. Meanwhile, the real azimuth angle has little effect on the DOA estimation. Finally, an experimental setup for discharge source DOA estimation is introduced and the experiment results are illustrated.


2019 ◽  
Vol 18 (5-6) ◽  
pp. 1652-1668
Author(s):  
Jingru Zhou ◽  
V John Mathews ◽  
Daniel O Adams

In this article, an acoustic emission–based impact location estimation algorithm is presented for use with composite structures. The algorithm is formulated as a constrained optimization problem by utilizing sensor locations and times of arrival of impact signals at the sensors. The impact locations are estimated without any information about wave propagation velocity in the structure. A modification of the algorithm to overcome difficulties produced by waveform reflections enables accurate estimation of impact locations close to the structure’s boundaries. The capability of this algorithm to accurately estimate impact locations is demonstrated numerically and experimentally. Experiments performed at different temperatures showed that the algorithm is robust to temperature changes. An automatic time-of-arrival estimation method is also presented. The performance capabilities of the method and its computational simplicity make this approach an attractive alternative to other methods available in the literature for practical structural health monitoring applications.


1995 ◽  
Author(s):  
Nagykaldi Csaba ◽  
Manohar Singh Badhan
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document